A58 电离辐射计量 标准查询与下载

KS A 4401-2005 放射线探测用采样金属板

이 규격은 방사성 동위 원소가 방출하는 b 선 및 g 선을 방사선 측정기로 측정하기 위한

Planchets used in radiation measurement instruments

KS A 4315-2005 手脚污染监测器

이 규격은 a 선 또는 b 선을 검출함으로써 손발의 어느 쪽 또는 손발 표면상의 방사성 물

Hand and/or foot contamination monitors

KS A 4606-2005 工业用X线装置辐射测试

이 규격은 X선 투과 시험에 사용하는 산업용 X선 장치(이하 X선 장치라 한다.)에 대하여

Industrial X-ray apparatus for radiographic testing

KS A 4921-2005 γ射线工业辐射测试设备

이 규격은 g 선 투과 시험에 사용하는 산업용 g 선 장치(이하 g 선 장치라 한다.)에

Industrial γ -ray apparatus for radiography

KS A 4922-2005 X射线及γ射线个人剂量计校正幻象

이 규격은 1 cm 선량 당량, 3 mm 선량 당량 및 70 mm 선량 당량을 측정 평가하

Calibration phantom for X- and γ -ray personal dosimeters

NF M60-200-5:2005 电离辐射测量探测限和判断阈的确定.第5部分:基本原则及对放射材料累积过程中过滤器计数测量的应用

Determination of the detection limit and decision threshold for ionizing radiation measurements - Part 5 : fundamentals and applications to counting measurements on filters during accumulation of radioactive materiel.

NF M60-200-6:2005 电离辐射测量的探测极限和判断阈值的测定.第6部分:基本原则和对瞬态测量方法的应用

Determination of the detection limit and decision threshold for ionizing radiation measurements - Part 6 : fundamentals and applications to measurements by use of transient mode.

NF M60-512-4:2005 校准剂量仪和剂量率仪及确定其光子能量响应的Χ和γ参考辐射.第4部分:低能X参考辐射场中场所剂量计和个人剂量计的校准

X and gamma reference radiation for calibrating dosemeters and doserate meters and for determining their response as a function of photon energy - Part 4 : calibration of area and personal dosimeters in low energy X reference radiation fields.

BS EN 14255-1:2005 对处于断续光辐射中的人体测量和评定.工作场所中人工源放射的紫外线辐射

This document specifies procedures for the measurement and assessment of personal exposures to ultraviolet (UV) radiation emitted by artificial sources, where adverse effects can not readily be excluded. NOTE 1 Adverse effects will usually not occur in exposures caused by commonly used artificial lighting. However, exposures to very strong light sources or light sources with extended spectra may cause a health risk nevertheless. This document applies to UV-exposures in indoor and outdoor workplaces. It does not apply to UV-exposures in leisure time. This document does not apply to UV-exposure caused by the sun. NOTE 2 Part 3 of this standard will deal with UV-exposure caused by the sun. This document does not specify UV-exposure limit values. It supports the application of limit values set by national regulations or international recommendations. This document applies to UV-exposures by artificial incoherent sources, which emit spectral lines as well as continuous spectra. This document does not apply to coherent radiation sources. NOTE 3 Coherent optical radiation sources are covered by standards for lasers, like EN 60825-1 etc.. This document applies to UV-exposures in the wavelength band 180 nm to 400 nm. This document does not apply to radiation exposures which concern the retina. NOTE 4 Part 2 of this standard will address these effects. This document does not apply to radiation emissions of products. NOTE 5 For radiation emissions of products other standards apply, such as: EN 60335-2-27 (IEC 60335-2-27) for sunbeds, EN 60335-2-59 (IEC 60335-2-59) for insect killers and EN 12198 for radiation emissions of machinery.

Measurement and assessment of personal exposures to incoherent optical radiation - Ultraviolet radiation emitted by artifical sources in the workplace

ISO 11929-8:2005 电离辐射测量探测限和判断阈的确定.第8部分:基本原则及对不受样品处理影响的光谱测量法演变的应用

This part of ISO 11929 specifies a method for determination of suitable statistical values which allow an assessment of the detection capabilities in spectrometric nuclear radiation measurements, and of the physical effect quantified by a measurand (for example, a net area of a spectrometric line in an alpha- or gamma-spectrum) which is determined by evaluation of a multi-channel spectrum by unfolding methods, without the influence of sample treatment. For this purpose, Bayesian statistical methods are used to specify characteristic limits.

Determination of the detection limit and decision threshold for ionizing radiation measurements - Part 8: Fundamentals and application to unfolding of spectrometric measurements without the influence of sample treatment

ISO 11929-7:2005 电离辐射测量探测限和判断阀的确定.第7部分:基本原则和一般应用

This part of ISO 11929 specifies suitable statistical values which allow an assessment of the detection capabilities in ionizing radiation measurements and of the physical effect quantified by the measurand. For this purpose, Bayesian statistical methods are used to specify characteristic limits. This part of ISO 11929 deals with fundamentals and general applications.

Determination of the detection limit and decision threshold for ionizing radiation measurements - Part 7: Fundamentals and general applications

ISO 11929-5:2005 电离辐射测量探测限和判断阈的确定.第5部分:基本原则及对放射材料累积过程中过滤器计数测量的应用

This part of ISO 11929 specifies suitable statistical values which allow an assessment of the detection capabilities in ionizing radiation measurements and of the physical effect quantified by the measurand. For this purpose, Bayesian statistical methods are used to specify characteristic limits. This part of ISO 11929 deals with fundamentals and applications to counting measurements on filters during accumulation of radioactive material.

Determination of the detection limit and decision threshold for ionizing radiation measurements - Part 5: Fundamentals and applications to counting measurements on filters during accumulation of radioactive material

ISO 11929-6:2005 电离辐射测量探测限和判断阈的确定.第6部分:基本原则及对瞬态测量方法的应用

This part of ISO 11929 specifies suitable statistical values which allow an assessment of the detection capabilities in ionizing radiation measurements by use of a transient mode. For this purpose, statistical methods are used to specify two statistical values characterizing given probabilities of error. This part of ISO 11929 deals with fundamentals and applications to measurements by use of transient mode.

Determination of the detection limit and decision threshold for ionizing radiation measurements - Part 6: Fundamentals and applications to measurements by use of transient mode

ASTM E170-05 与辐射测量和剂量测定相关的标准术语

Standard Terminology Relating to Radiation Measurements and Dosimetry

ISO 4037-4:2004 校准剂量仪和剂量率仪及确定其光子能量响应的Χ和γ参考辐射.第4部分:低能X参考辐射场中场所剂量计和个人剂量计的校准

This part of ISO 4037 gives guidelines on additional aspects of the characterization of low energy photon radiations. This part of ISO 4037 also describes procedures for calibration and determination of the response of area and personal dose(rate)meters as a function of photon energy and angle of incidence. This part of ISO 4037 concentrates on the accurate determination of conversion coefficients from air kerma to Hp(10) and H(10) for the spectra of low energy photon radiations. As an alternative to the use of conversion coefficients, the direct calibration in terms of these quantities by means of appropriate reference instruments is described.

X and gamma reference radiation for calibrating dosemeters and doserate meters and for determining their response as a function of photon energy - Part 4: Calibration of area and personal dosemeters in low energy X reference radiation fields

ISO 6980-2:2004 核能.参考β粒子辐射.第2部分:辐射场的基本数量特性的相关校正基础

This part of ISO 6980 specifies methods for the measurement of the directional absorbed-dose rate in a tissue-equivalent slab phantom in the ISO 6980 reference beta-particle radiation fields. The energy range of the beta-particle-emitting isotopes covered by these reference radiations is 0,066 to 3,54 MeV (maximum energy). Radiation energies outside this range are beyond the scope of this standard. While measurements in a reference geometry (depth of 0,07 mm at perpendicular incidence in a tissue-equivalent slab phantom) with a reference class extrapolation chamber are dealt with in detail, the use of other measurement systems and measurements in other geometries are also described, although in less detail. The ambient dose equivalent, H(10) as used for area monitoring of strongly penetrating radiation, is not an appropriate quantity for any beta radiation, even for that penetrating a 10 mm thick layer of ICRU tissue (i.e. Emax > 2 MeV). If adequate protection is provided at 0,07 mm, only rarely will one be concerned with other depths, for example 3 mm. This document is geared towards organizations wishing to establish reference-class dosimetry capabilities for beta particles, and serves as a guide to the performance of dosimetry with the reference class extrapolation chamber for beta-particle dosimetry in other fields. Guidance is also provided on the statement of measurement uncertainties.

Nuclear energy - Reference beta-particle radiation - Part 2: Calibration fundamentals related to basic quantities characterizing the radiation field

JJG 744-2004 医用诊断X射线辐射源

Medical Diagnostic X-ray Radiation Source

JJF 1120-2004 热电离同位素质谱计校准规范

Calibration Specification for Thermal Ionization Isotope Mass Spectrometers

ANSI/ASTM E2381:2004 流化床和液体流的辐射处理中剂量测定指南

This guide describes several dosimetry systems and methods suitable for the documentation of the irradiation of product transported as fluid or in a fluidized bed. The sources of penetrating ionizing radiation included in this guide are electron beams, x-rays (bremsstrahlung) and gamma rays. Absorbed doses from 10 to 100, 000 gray are considered, including applications such as disinfestation, disinfection, bioburden reduction, sterilization, crosslinking and graft modification of products, particularly powders and aggregates. This guide does not purport to address the safety concerns, if any, associated with the use of fluidized beds and streams incorporating sources of ionizing radiation. It is the responsibility of the user of this guide to establish appropriate safety and health practices and to determine compliance with regulatory limitations prior to use.

Guide for Dosimetry in Radiation Processing of Fluidized Beds and Fluid Streams

ASTM D3648-04(2011) 测量放射性的标准操作规程

This practice was developed for the purpose of summarizing the various generic radiometric techniques, equipment, and practices that are used for the measurement of radioactivity. GENERAL INFORMATION Top 1.1 These practices cover a review of the accepted counting practices currently used in radiochemical analyses..

Standard Practices for the Measurement of Radioactivity