E31 燃料油 标准查询与下载

NB/T 10895-2021 燃料乙醇工业用木薯干

本文件规定了燃料乙醇工业用木薯干的要求、试验方法、检验规则及运输和储存等要求。 本文件适用于以木薯为原料加工而成，作为工业生产原料的干木薯块、片等形态木薯的品质分类等级。

Dried cassava for fuel ethanol industry

NB/T 10897-2021 烃基生物柴油

本文件规定了烃基生物柴油的质量技术要求和试验方法，检验规则，标志、包装、运输和贮存，以及安全的要求。 本文件适用于以动植物油脂、废弃动植物油脂或其衍生物为原料通过加氢工艺生产的烃基生物柴油。

hydrocarbon-based biodiesel

NB/T 10896-2021 燃料乙醇工业用秸秆

本文件规定了燃料乙醇工业用秸秆的外观与质量要求、检测方法，以及储存和运输要求。 本文件适用于燃料乙醇工业用秸秆的收购、储存、运输和使用。

Straw for fuel ethanol industry

HG/T 5990-2021 燃料乙醇单位产品能源消耗限额

Energy consumption limit per unit product of fuel ethanol

NF M40-002:2021 气体燃料 商用丙烷 要求和测试方法

Combustibles gazeux - Propane commercial - Exigences et méthodes d'essai

BS EN ISO 22854:2021 液体石油产品 测定车用汽油和乙醇(E85)汽车燃料中的碳氢化合物类型和含氧化合物 多维气相色谱法

Liquid petroleum products. Determination of hydrocarbon types and oxygenates in automotive-motor gasoline and in ethanol (E85) automotive fuel. Multidimensional gas chromatography method

DB11/ 239-2021 车用柴油环保技术要求

Technical Requirements for Environmental Protection of Vehicle Diesel

DB11/ 238-2021 车用汽油环保技术要求

Technical Requirements for Environmental Protection of Motor Gasoline

ISO 22854:2021 液化石油产品. 汽车发动机汽油和乙醇(E85)汽车燃料中烃类和氧化物的测定. 多维气相色谱法

This document specifies the gas chromatographic (GC) method for the determination of saturated, olefinic and aromatic hydrocarbons in automotive motor gasoline and ethanol (E85) automotive fuel. Additionally, the benzene and toluene content, oxygenated compounds and the total oxygen content can be determined. NOTE 1 For the purposes of this document, the terms % (m/m) and % (V/V) are used to represent respectively the mass fraction, w, and the volume fraction, φ. This document defines two procedures, A and B. Procedure A is applicable to automotive motor gasoline with total aromatics of 19,32 % (V/V) up to 46,29 % (V/V); total olefins from 0,40 % (V/V) up to 26,85 % (V/V); oxygenates from 0,61 % (V/V) up to 9,85 % (V/V); oxygen content from 1,50 % (m/m) to 12,32 % (m/m); benzene content from 0,38 % (V/V) up to 1,98 % (V/V) and toluene content from 5,85 % (V/V) up to 31,65 % (V/V). The method has also been tested for individual oxygenates. A precision has been determined for a total volume of methanol from 1,05 % (V/V) up to 16,96 % (V/V); a total volume of ethanol from 0,50 % (V/V) up to 17,86 % (V/V); a total volume of MTBE from 0,99 % (V/V) up to 15,70 % (V/V), a total volume of ETBE from 0,99 % (V/V) up to 15,49 % (V/V), a total volume of TAME from 0,99 % (V/V) up to 5,92 % (V/V), and a total volume of TAEE from 0,98 % (V/V) up to 15,59 % (V/V). Although this test method can be used to determine higher-olefin contents of up to 50 % (V/V), the precision for olefins was tested only in the range from 0,40 % (V/V) to 26,85 % (V/V). Although specifically developed for the analysis of automotive motor gasoline that contains oxygenates, this test method can also be applied to other hydrocarbon streams having similar boiling ranges, such as naphthas and reformates. NOTE 2 For Procedure A, applicability of this document has also been verified for the determination of n-propanol, acetone, and di-isopropyl ether (DIPE). However, no precision data have been determined for these compounds. Procedure B describes the analysis of oxygenated groups (ethanol, methanol, ethers, C3 – C5 alcohols) in ethanol (E85) automotive fuel containing ethanol between 50 % (V/V) and 85 % (V/V). The gasoline is diluted with an oxygenate-free component to lower the ethanol content to a value below 20 % (V/V) before the analysis by GC. The sample can be fully analysed including hydrocarbons. Precision data for the diluted sample are only available for the oxygenated groups. NOTE 3 For Procedure B, the precision can be used for an ethanol fraction from about 50 % up to 85 % (V/V). For the ether fraction, the precision as specified in Table 6 can be used for samples containing at least 11 % (V/V) of ethers. For the higher alcohol fraction, too few data were obtained to derive a full precision statement and the data presented in Table 6 are therefore only indicative. NOTE 4 An overlap between C9 and C10 aromatics can occur. However, the total is accurate. Isopropyl benzene is resolved from the C8 aromatics and is included with the other C9 aromatics.  1 

Liquid petroleum products - Determination of hydrocarbon types and oxygenates in automotive-motor gasoline and in ethanol (E85) automotive fuel - Multidimensional gas chromatography method

ISO 9038:2021 液体持续可燃性的测定

This document specifies a procedure, at temperatures up to 100 °C, to determine whether a liquid product, that would be classified as “flammable” by virtue of its flash point, sustains combustion at the temperature(s) specified e.g. in regulations. NOTE Many national and international regulations classify liquids as presenting a flammable hazard based on their flash point, as determined by a recognized method. Some of these regulations allow a derogation if the substance cannot “sustain combustion” at some specified temperature(s). The procedure is applicable to paints (including water-borne paints), varnishes, paint binders, solvents, petroleum or related products and adhesives, that have a flash point. It is not applicable to painted surfaces in respect of assessing their potential fire hazards. This test method is applicable, in addition to test methods for flash point, for assessing the fire hazard of a product.

Determination of sustained combustibility of liquids

ISO 21644:2021 固体回收燃料. 生物量含量测定的方法

This document specifies three methods for the determination of the biomass content in solid recovered fuels: the 14C content method, the selective dissolution and the manual sorting methods.

Solid recovered fuels - Methods for the determination of biomass content

ASTM D396-21 燃料油标准规范

1.1?This specification (see Note 1) covers grades of fuel oil intended for use in various types of fuel-oil-burning equipment under various climatic and operating conditions. These grades are described as follows: 1.1.1?Grades No. 1 S5000, No. 1 S500, No. 1 S15, No. 2 S5000, No

Standard Specification for Fuel Oils

ASTM D7960-21 含非烃组分的无铅航空汽油试验燃料标准规范

1.1?This specification covers formulating specifications for purchases of a UL102 unleaded aviation gasoline test fuel under contract and is intended solely for use by purchasing agencies for testing purposes. 1.2?This specification defines a specific type of aviation gasoline

Standard Specification for Unleaded Aviation Gasoline Test Fuel Containing Non-hydrocarbon Components

BS PD CEN/TR 15367-1:2020 石油产品. 良好家务管理指南. 第1部分: 机动车用柴油燃料

Petroleum products. Guidelines for good housekeeping. Automotive diesel fuels

DB64/T 1762-2020 煤基柴油组分油芳烃含量的测定 全二维气相色谱法

Determination of Aromatics Content in Coal-based Diesel Component Oil by Comprehensive Two-Dimensional Gas Chromatography

DB64/T 1760-2020 中间馏分烃类组成的分离与测定 全二维气相色谱法

Separation and Determination of Hydrocarbon Composition in Middle Distillates by Comprehensive Two-Dimensional Gas Chromatography

DB64/T 1761-2020 车用汽油和煤基汽油组分油中12种添加剂的测定 全二维气相色谱法

Determination of 12 Additives in Motor Gasoline and Coal-based Gasoline Component Oil by Comprehensive Two-Dimensional Gas Chromatography

DIN EN 16603-50-11:2020 空间工程. SpaceFibre. 超高速串行链路; 英文版 EN 16603-50-11-2020

The scope of the SpaceFibre standard is the detailed specification a very high-speed serial link protocol stack reaching from link level Quality layer down to the Physical layer. The higher layers like packet, network and higher level protocols are the same as for SpaceWire and s

Space engineering - SpaceFibre - Very high-speed serial link; English version EN 16603-50-11:2020

DIN CEN/TR 15367-1:2020 石油产品. 良好内务管理指南. 第1部分: 汽车柴油; 德文版本CEN/TR 15367-1-2020

This document provides general guidance on diesel fuel housekeeping. It does not pre-empt national or local regulations but addresses the issues of contamination by water, sediment, inorganic contaminants, or microbial growth that may occur in the supply chain during manufacture,

Petroleum products - Guidelines for good housekeeping - Part 1: Automotive diesel fuels; German version CEN/TR 15367-1:2020

DIN EN ISO 5165:2020 石油产品. 柴油燃料点火质量的测定. 十六烷发动机试验法(ISO 5165-2020); 德文版本EN ISO 5165-2020

This document establishes the rating of diesel fuel oil in terms of an arbitrary scale of cetane numbers (CNs) using a standard single cylinder, four-stroke cycle, variable compression ratio, indirect injected diesel engine. The CN provides a measure of the ignition characteristi

Petroleum products - Determination of the ignition quality of diesel fuels - Cetane engine method (ISO 5165:2020); German version EN ISO 5165:2020