共找到 363 条与 电力试验技术 相关的标准,共 25 页
DL/T 502的本部分规定了锅炉用水和冷却水中用电极法测定氯离子的方法。 本部分适用于锅炉用水和冷却水氯离子含量5mg/L~1000mg/L水样的测定。
Analytical methods of steam and water in power plants Part 4: Determination of chloride (Electrode method)
DL/T 502的本部分规定了锅炉用水和冷却水中全硅的测定方法。 本部分中硅含量在1mg/L~5mg/L的测定方法适用于原水、澄清水和炉水中全硅的测定;含硅量小于100μg/L的测定方法适用于除盐水、给水、凝结水、蒸汽中全硅的测定。对含硅量在0.1mg/L~1.0mg/L的水样,可用改变取样量的方法进行测定。
Analytical methods of steam and water in power plants Part 3: Determination of total silicon (Spectrometric method by conversion with hydrofluoric acid)
DL/T 502的本部分规定了锅炉用水和冷却水分析时采集水汽样品的方法。 本部分适用于锅炉用水和冷却水分析用水汽样品的采集。
Analytical methods of steam and water in power plants Part 2: Sampling method for steam and water
DL/T 502的本部分规定了火力发电厂水质分析中应遵守的原则和规定。 本部分适用于火力发电厂水质分析。
Analytical methods of steam and water in power plants.Part 1: General rule
本标准规定了火电厂用2.25Cr-1Mo钢球化的评级方法和评级标准。 本标准适用于以2.25Cr-1Mo钢制造的金属壁温小于570℃的过热蒸汽管道、联箱、导汽管等高温部件在高温条件下长期使用后的球化等级评定。同类材料制作的金属壁温在580℃以下的受热面管的球化等级评定可参照执行。
The gradational standard of spheroidizition for 2.25Cr-1Mo steel used in power plant
本标准规定了使用光谱分析方法对电力设备金属构件(含焊接接头、焊接材料)进行合金成分检验的基本要求和主要操作方法。 本标准适用于电力设备制造、安装、检修时各类金属构件(含焊接接头、焊接材料)合金成分复验及甄别的光谱分析工作,也适用于相关行业对金属材料合金成分的复验及甄别。
Spectral analysis guideline of metal for electrical power equipment
本标准规定了火力发电厂微量溶解氧仪采用标准气体标定的方法。 本标准适用于火力发电厂在线式和便携式微量溶解氧仪的标定。
Calibration for low-level dissolved oxygen meter.standard gases calibration
DL/T 502的本部分规定了锅炉用水和冷却水中钙离子的测定方法。 本部分适用于锅炉用水和冷却水中钙离子的测定。
Analytical methods of steam and water in power plants Part 32: Determination of calcium (Volumetric method)
DL/T 502的本部分规定了生水、循环冷却水及经过石灰处理后的清水安定性的测定方法。 本部分适用于生水、循环冷却水及经过石灰处理后的清水安定性的测定。
Analytical methods of steam and water in power plants Part 31: Determination of stability index
DL/T 502的本部分规定了锅炉用水和冷却水中硝酸盐的测定方法。 本部分适用于锅炉用水和冷却水硝酸盐含量为0.1mg/L~10.0mg/L水样的测定。
Analytical methods of steam and water in power plants Part 30: Determination of nitrates (Spectrometric method using salicylic acid)
DL/T 502的本部分规定了在连续流动状态下,水样通过氢型阳离子交换柱,电导率测定的方法。 本部分适用于锅炉凝结水、给水、蒸汽和炉水氢电导率小于1μS/cm水样的测定。
Analytical methods of steam and water in power plants Part 29: Determination of cation conductivity
本标准规定了试验室冷却塔淋水填料的热力性能及阻力性能、除水器的阻力性能及飘水率、喷溅装置的水力学性能试验方法。 本标准适用于湿式逆流式冷却塔、湿式横流式冷却塔中使用的淋水填料、除水器、喷溅装置。
Test methods for determining the performance of cooling tower of transfer packing, drift eliminator and sprayer
本标准规定了燃煤电厂烟气排放连续监测系统的订货技术条件。 本标准适用于燃煤电厂固定式烟气排放连续监测系统。
Order specifications for continuous emissions monitoring systems of flue gas emitted from coal-fired power plants
本标准规定了六氟化硫气体湿度测定方法(重量法)。 本标准适用于电气设备用六氟化硫气体湿度的测定,可作为六氟化硫气体湿度测量的仲裁方法。
Determination of moisture content in sulphur hexafluoride by weight method
本标准规定了烟气湿法脱硫用石灰石粉反应速率的测定方法。 本标准适用于烟气湿法脱硫用石灰石粉反应速率的测定。
Measurement of dissolution rate of limestone powder used in wet flue gas desulfurization
本标准规定了微机氧弹热量计使用性能的检验方法。 本标准适用于微机氧弹热量计产品检验机构、使用单位对燃煤质量检验专用的微机氧弹热量计(包括恒温式、绝热式)的使用性能的检验,同时可为微机氧弹热量计生产单位提供参考。
The rule for the of PC bomb calorimeter performance
本标准规定了六氟化硫气体中可水解氟化物含量的比色测定方法和电极测定方法。 本标准适用于电气设备用六氟化硫气体中可水解氟化物含量的测定。
Determination of hydrolysable fluoride content in sulphur hexafluoride
本标准规定了六氟化硫气体毒性的生物试验方法。 本标准适用于电气设备用六氟化硫气体的毒性生物试验。
Biotoxication tests by sulphur hexafluoride
本标准规定了六氟化硫气体中空气、四氟化碳的气相色谱测定法。 本标准适用于电气设备用六氟化硫气体中空气(N、O)、四氟化碳含量的测定。
Determination of air and carbon tetrafluoride content in sulphur hexafluoride by gas chromatography method
本标准规定了六氟化硫气体中矿物油(不含合成润滑油)含量的红外光谱分析测定法。 本标准适用于电气设备用六氟化硫气体中矿物油(不含合成润滑油)含量的测定。
Determination of mineral oil content in sulphur hexafluoride by infrared spectrum method
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号