共找到 1828 条与 合成橡胶基础标准与通用方法 相关的标准,共 122 页
Rubber, vulcanized or thermoplastic - Determination of tear strength - Part 1: Trouser, angle and crescent test pieces (ISO 34-1:2015)
Rubber, raw - Determination of block polystyrene content - Ozonolysis method
Rubber, vulcanized or thermoplastic -- Determination of the effect of liquids
Rubber compounding ingredients -- Organic chemicals -- Part 4: Abbreviated terms
Rubber, vulcanized or thermoplastic -- Determination of stress-strain properties
Rubber and rubber products. Determination of the composition of vulcanizates and uncured compounds by thermogravimetry. Butadiene, ethylene-propylene copolymer and terpolymer, isobutene-isoprene, isoprene and styrene-butadiene rubbers
Rubber. Determination of residual unsaturation of hydrogenated nitrile butadiene rubber (HNBR) by infrared spectroscopy
Rubber, vulcanized or thermoplastic. Determination of adhesion to a rigid substrate. 90
Rubber - Determination of residual unsaturation of hydrogenated nitrile butadiene rubber (HNBR) by infrared spectroscopy
Rubber, vulcanized or thermoplastic - Determination of adhesion to a rigid substrate - 90 degree peel method
Rubber, unvulcanized - Determinations using a shearing-disc viscometer - Part 2 : determination of pre-vulcanization characteristics
Rubber, vulcanized or thermoplastic - Determination of permeability to gases - Part 1: Differential-pressure methods
Rubber, unvulcanized. Determinations using a shearing-disc viscometer. Determination of pre-vulcanization characteristics
This International Standard specifies a method for the determination of the resistance of rubber to abrasion using a driven, vertical abrasive disc. The loss in mass on abrasion is determined through the slip caused by setting different slip angles and rotational speeds between a wheel-shaped rubber test piece and an abrasive disc which are rotating in planes at right angles to each other and pressed against each other with a specified load. The test result can be reported as the loss in mass per unit running distance and/or as an abrasion resistance index compared to a reference compound. This International Standard is applicable to comparative testing, quality control, specification compliance testing, referee testing and research and development work. As the test device described is capable of setting each abrasion parameter, such as slip angle, rotational speed of the abrasive disc and load, independently, the method is suitable for carrying out a wide range of abrasion tests for various rubber products, especially tyres.
Rubber, vulcanized or thermoplastic - Determination of resistance to abrasion using a driven, vertical abrasive disc
Rubber. Guide to the use of curemeters
This part of ISO 289 specifies a method for determining the pre-vulcanization characteristics of compounded rubber. The pre-vulcanization characteristics determined by this method provide a means of estimating how long compounded rubber can be maintained at high temperatures and remain processable.
Rubber, unvulcanized - Determinations using a shearing-disc viscometer - Part 2: Determination of pre-vulcanization characteristics
This International Standard specifies procedures for the calibration and verification of durometers of types A, D, AO and AM (see ISO 7619-1), IRHD pocket meters (see ISO 7619-2), IRHD dead-load instruments (see ISO 48) and dead-load instruments using the very low rubber hardness scale (see ISO 27588).
Rubber - Calibration and verification of hardness testers
Rubber, vulcanized or thermoplastic. Resistance to weathering
Rubber compounding ingredients. Sulfenamide accelerators. Test methods
Rubber compounding ingredients - Sulfenamide accelerators - Test methods
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号