共找到 431 条与 合成橡胶 相关的标准,共 29 页
この規格は,加硫ゴム及び熱可塑性ゴム(製品も含む。)の自由振動方法及ぴ強制振動方法による動的性質の求め方の一般指針について規定する。ただし,反発弾性及び繰り返しによる疲労試験については適用しない。
Rubber, vulcanized or thermoplastic -- Determination of dynamic properties -- General guidance
この規格は,加硫ゴム及び熱可塑性ゴムの硬さを求めるための試験方法について規定する。
Rubber, vulcanized or thermoplastic -- Determination of hardness
この規格は,ゴムの物理航験方法にかかわる試験片の,保管。状態調節及び試験条件(温度,湿度,時間)並びに識別方法,作製方法及び寸法測定方法について規定する。特定の試験又は試料に対する特別な試験条件,特定の環境条件を追尾・再現(シミュレート)する条件及び製品全体を試験するための特別な要求条件は含まない。
Rubber -- General procedures for preparing and conditioning test pieces for physical test methods
이 규격은 냉각 환풍기(팬), 얼터네이터, 물 펌프, 컴프레서 및 파워스테어링용 펌프 등의
Engine accessory drive V-belts
이 규격은 고무 공업에서 사용하는 주된 용어에 대하여 규정한다.
Glossary of rubber terms
이 규격은 모든 종류의 가죽에 적용할 수 있는 휘발성 물질의 측정 방법을 규정한다.이
Leather-Chemical tests-Determination of volatile matter
이 규격은 고무 제품용 접착제의 물리 시험 방법에 대하여 규정한다.
Testing methods of rubber cement
이 규격은 가황 고무의 저온 압축에 의한 영구 줄음을 측정하는 방법에 대하여 규정한다.
Testing method for low-temperature compression set of vulcanized elastomers
이 규격은 가황 고무(에보나이트 및 기포성 고무는 제외한다.)의 물리 시험 방법에 대하여
Physical test methods for vulcanized rubber
이 규격은 아교 및 젤라틴에 대하여 규정한다. 사진, 의약 및 식품용 젤라틴에 대하여는 이
Animal glues and gelatins
Rubber compounding ingredients - Titanium oxyde.
This International Standard specifies the methods to be used for the evaluation of sulfenamide accelerators. The analytical methods are applicable for most commercial sulfenamide accelerators: - Sulfenamides of primary amines (type l) - Sulfenamides of unhindered secondary amines (type ll) - Sulfenamides of hindered secondary amines (type lll)
Rubber compounding ingredients - Sulfenamide accelerators - Test methods (ISO 11235:1999) English version of DIN ISO 11235:2006-07
Styrene-butadiene rubber (SBR). Determination of the microstructure of solution-polymerized SBR
3.1 These tests are intended mainly for referee purpose but may be used for quality control of rubber production. They may also be used in research and development work and for comparison of different samples in a standard formula. 3.2 These tests may be used to obtain values for quality control acceptance of rubber. 1.1 These test methods cover the standard materials, test formula, mixing procedures, and test methods for the evaluation of halogenated isobutene-isoprene rubbers (BIIR and CIIR). 1.2 Both mill and miniature internal mixer procedures are given. 1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Test Methods for Rubber&x2014;Evaluation of BIIR and CIIR (Halogenated Isobutene&x2014;Isoprene Rubber)
이 규격은 자전거용 고무 튜브의 공기 밸브에 사용되는 밸브 고무(이하 밸브 고무라 한다.)
Valve rubber for bicycle
이 규격은 고무용 산화마그네슘(이하 산화마그네슘이라 한다.)에 대하여 규정한다.
Magnesium oxide for rubber
이 규격은 의류에 사용되는 연질 우레탄 폼(이하 폼이라 한다.)에 대하여 규정한다. 여
Flexible urethane foam for garments
이 규격은 자전거 림에 끼우는 솔리드 타이어(이하 타이어라 한다.)에 대하여 규정한다.
Solid tires for bicycles
이 규격은 어린이 탈것에 사용되는 솔리드 타이어(이하 통고무 타이어라 한다.)에 대하여 규
Solid tires for children vehicle
이 규격은 전기용을 제외한 에보나이트 막대ㆍ관 및 판(이하 에보나이트라 한다.)에 대하여
Ebonite rods, pipes and plates
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号