G40 橡胶制品综合 标准查询与下载

GB/T 1693-1981 硫化橡胶工频介电常数和介质损耗角正切值的测定方法

本标准适用于将试样置于频率为50Hz的交变电场下，测定其介质损耗角正切值和电容，并通过电容计算出介电常数。

Vulcanized rubber--Determination of dielectric constant and dielectric loss angular tangent value

GB/T 29610-2013(英文版) 橡胶制品《多溴联苯和多溴联苯醚的测定》色谱质谱法

Rubber products—Determination of polybrominated biphenyls and polybrominated diphenyl ethers—Gas chromatography and mass spectrometry

GB/T 31357-2014(英文版) 混炼胶通用技术条件

Compounded rubber—General technical specification

DB3401/T 311-2023 城市道路地下管线综合设计及检查井设置技术规范

Comprehensive design of urban road underground pipelines and technical specifications for the installation of inspection wells

DB37/T 5121-2022 室外塑胶跑道质量控制技术规程

本规程适用于山东省新建、扩建和改建的教学、竞赛和健身用室外塑胶跑道的设计、选材、施工、验收和管理维护，其他的塑胶跑道根据材料类型和施工工艺参照本规程执行。

Technical specification for quality control of outdoor plastic track

T/SHPTA 021-2021 柔性抗撕裂橡皮线缆料

本文件给出了电线电缆用橡皮线缆料的分类和命名、外观和颜色、要求、试验方法、检验规则和包装、标志、运输、贮存

Flexible and tear resistant rubber materials for wires & cables

ISO 19242:2021 橡胶. 采用离子色谱法测定总硫含量

This document specifies a method for the determination of the total sulfur content of raw rubber and unvulcanized or vulcanized rubber compounds by ion chromatography following the preparation of a sample solution using either a tubular furnace combustion or an oxygen combustion flask method. The tubular furnace combustion method is applicable for rubbers with sulfur content less than 0,1 % as it is possible that the oxygen combustion flask method will not give sufficiently accurate results. The oxygen combustion flask method is not applicable to rubbers containing a metal salt that forms an insoluble metal sulfate, such as barium sulfate (CAS 7727-43-7).

Rubber - Determination of total sulfur content by ion chromatography

NF T47-203-2*NF EN ISO 10619-2:2021 橡胶、塑料软管和管材. 曲挠性和刚性的测量. 第2部分: 低于环境温度的弯曲试验

Rubber and plastics hoses and tubing - Measurement of flexibility and stiffness - Part 2 : bending tests at sub-ambient temperatures

ISO/TS 16095:2021 主要来源于包含天然橡胶产品的再生橡胶. 评估程序

Reclaimed rubber derived from products containing mainly natural rubber - Evaluation procedure

ISO/TS 16096:2021 再生丁基(IIR)橡胶. 评估程序

Reclaimed isobutene-isoprene (IIR) rubber - Evaluation procedure

SN/T 5299-2021 进口复合橡胶检验规程

Inspection Regulations for Imported Composite Rubber

SN/T 5318-2021 轮胎中多环芳烃的测定 核磁共振法

Determination of polycyclic aromatic hydrocarbons in tires by NMR method

HG/T 20721-2021 浓盐水蒸发塘设计规范

Design specifications for concentrated brine evaporation ponds

ISO 1432:2021 硫化或热塑性橡胶. 低温硬化测定(Gehman试验)

This document specifies a static procedure, known as the Gehman test, for determining the relative stiffness characteristics of vulcanized or thermoplastic rubbers over a temperature range from room temperature to approximately −120 °C.

Rubber, vulcanized or thermoplastic - Determination of low-temperature stiffening (Gehman test)

ISO 6914:2021 硫化橡胶或热塑性橡胶. 老化性能的测定 (拉伸应力松弛试验)

This document describes three methods for the measurement of the change of stress in a test piece at a given elongation for the purpose of determining the ageing characteristics of a rubber. — Method A is intended for measurement under continuous strain conditions. — Method B is the preferred method for measurement under intermittent strain conditions. — Method C is an alternative to method B for measurement under intermittent strain conditions in which the test piece is removed from the ageing environment for measurement of the stress at standard laboratory temperature. Measurements at a single elevated ageing temperature can be used for quality control purposes as a measure of heat-ageing resistance. Measurements at a number of temperatures can be used for research and development purposes to estimate long-term ageing characteristics in accordance with the procedures described in ISO 11346. Tests under continuous and intermittent strain conditions measure the results of different processes, and hence do not give the same results. The results of the intermittent methods B and C also cannot be expected to be the same as they use different test conditions.

Rubber, vulcanized or thermoplastic - Determination of ageing characteristics by measurement of stress relaxation in tension

ASTM D1418-21a 橡胶和橡胶胶乳命名的标准实施规程

1.1?This practice covers a system of general classification for the basic rubbers both in dry and latex forms determined from the chemical composition of the polymer chain. 1.2?The purpose of this practice is to provide a standardization of terms for use in industry, commerce,

Standard Practice for Rubber and Rubber Latices-Nomenclature

JIS K 6297:2020 未硫化橡胶. 用无转子密封流变仪测定粘度和应力松弛

Rubber, unvulcanized -- Determination of viscosity and stress relaxation using a rotorless sealed rheometer

NB/T 10370-2019 煤矿抽放瓦斯用焊接不锈钢管吸能检验规范

Specifications for energy absorption inspection of welded stainless steel pipes used for gas drainage in coal mines

SN/T 5271-2019 橡胶和橡胶制品 氟橡胶 热重分析法测定硫化和未硫化胶的成分

Rubber and rubber products fluorine rubber thermogravimetric analysis method to determine the composition of vulcanized and unvulcanized rubber

SN/T 5269-2019 氯丁橡胶复合橡胶 生橡胶含量的测定 热重分析法

Determination of Raw Rubber Content of Neoprene Composite Rubber by Thermogravimetric Analysis