G52 涂料辅助材料 标准查询与下载

NF T31-111:1991 稀释剂.用于涂料工业的经过热处理的硅土.规范和试验方法

EXTENDERS. THERMALY TREATED SILICA FOR PAINT INDUSTRY. SPECIFICATIONS AND TEST METHODS.

CGSB 1.5-M91-CAN/CGSB-1991 低闪点矿物油稀释剂 代替 1-GP-5M

La présente norme s’applique au diluant, essence minérale ou white spirit, produit de distillation du pétrole, convenant à une utilisation générale dans la dilution des peintures et des vernis. Ce produit ne doit pas être employé dans des applicati

Diluant, Essence Minerale A Faible Point D'Eclair

DIN 55933:1990 油漆和清漆的粘合剂.精炼亚麻油.要求和试验方法

The standard lays down requirements for refined linseed oil as binder for paints and varnishes as well as the according tests.

Binders for paints and varnishes; refined linseed oil; requirements and test methods

DIN 55954:1990 油漆和清漆的粘合剂.树脂的融合性（混合性）试验方法

Binders for paints and varnishes; compatibility (miscibility behaviour) test for resins

ASTM D2349-90(2009) 溶剂可还原的涂料中溶剂组份特性的定性测定标准试验方法

This test method provides a procedure for determining qualitatively the composition of solvent in paints containing only hydrocarbon solvents.1.1 This test method covers the determination of the nature of solvent in solvent-reducible house paints containing only hydrocarbon solvents. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Qualitative Determination of Nature of Solvent Composition in Solvent-Reducible Paints

ASTM D600-90(2001) 液体涂料催干剂

1.1 This specification covers liquids for use in paints, varnishes, enamels, and similar organic coatings and are solutions of metallic salts of:1.1.1 Class A8212;2-Ethyl hexanoic acids in petroleum spirits.1.1.2 Class B8212;Naphthenic acids in petroleum spirits.1.1.3 Class C8212;Neodecanoic acids in petroleum spirits.1.1.4 Class D8212;Tall oil fatty acids in petroleum spirits.1.1.5 Class E8212;Any of the above acids or acid blends, but containing additives that make the liquid drier water dispersible. Some other driers may also contain complexing agents.1.1.6 Class F8212;Other acids and acid blends unidentified by their producers.1.2 For specific hazard information and guidance, see the supplier's Material Safety Data Sheets for materials listed in this specification.

Standard Specification for Liquid Paint Driers

ASTM D600-90(1997) 液体涂料催干剂

1.1 This specification covers liquids for use in paints, varnishes, enamels, and similar organic coatings and are solutions of metallic salts of:1.1.1 Class A8212;2-Ethyl hexanoic acids in petroleum spirits.1.1.2 Class B8212;Naphthenic acids in petroleum spirits.1.1.3 Class C8212;Neodecanoic acids in petroleum spirits.1.1.4 Class D8212;Tall oil fatty acids in petroleum spirits.1.1.5 Class E8212;Any of the above acids or acid blends, but containing additives that make the liquid drier water dispersible. Some other driers may also contain complexing agents.1.1.6 Class F8212;Other acids and acid blends unidentified by their producers.1.2 For specific hazard information and guidance, see the supplier's Material Safety Data Sheets for materials listed in this specification.

Standard Specification for Liquid Paint Driers

DIN 53770-8:1989 颜料和填充剂的检验.盐酸可溶物质的测定.第8部分:铬含量(Ⅵ)

The standard describes two methods a diphenylcarbazide method and a chromate method, for the determination of the chromium content in pigments, soluble in hydrochloric acid, c (HCl)= 0,07 mol/l.

Testing of pigments and extenders; determination of matter soluble in hydrochloric acid; chromium(VI) content

BS 6900:1987 油漆和清漆用生亚麻油、精制亚麻油和熟亚麻油规范

Requirements and test methods for raw, alkali-refined, acid-refined and boiled linseed oils.

Specification for raw, refined and boiled linseed oils for paints and varnishes

BS 6782-6:1987 涂料用粘合剂.第6部分:软化点的测定方法

This International Standard specifies a method for the deter-mination of the softening point of resins (including rosin) and similar materials by means of the ring-and-ball apparatus.

Binders for paints - Method for determination of softening point (ring and ball method)

BS 6782-1:1987 涂料用粘合剂.第1部分:挥发成分含量与不挥发成分含量的测定方法

This International Standard specifies a procedure for determining the content of both "volatile matter" and "non-volatile matter" in paint media. NOTE - The volatile matter content of a product (and consequently the non-volatile matter content also) is not an absolute quantity, but depends upon the temperature and period of heating used for the test (see annex). This method is not applicable to certain reactive resins like isocyanate resins and unsaturated polyester resins.

Binders for paints - Method for determination of volatile and non-volatile content

ASTM D564-87(1996) 液体涂料催干剂的试验方法

1.1 These test methods cover the test procedures to be applied to liquid paint driers used in paints and related coatings. Typical paint driers, listed in Specification D600, are carboxylates of lead, cobalt, manganese, zinc, iron, calcium, and zirconium. 1.2This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Methods for Liquid Paint Driers

ASTM D564-87(2002) 液体涂料催干剂的试验方法

Driers accelerate the drying of oil, paint, printing ink, and varnish. These test methods are applicable to liquid driers manufactured for use in paints and related coatings. The tests for metallic content using ethylenediaminetetraacetic acid dihydrate (EDTA) are intended for concentrated solutions of single metals; two or more metals may cause interference.1.1 These test methods cover the test procedures to be applied to liquid paint driers used in paints and related coatings. Typical paint driers, listed in Specification D600, are carboxylates of lead, cobalt, manganese, zinc, iron, calcium, and zirconium. 1.2This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Methods for Liquid Paint Driers

ASTM D564-87(2008) 液体涂料催干剂的标准试验方法

Driers accelerate the drying of oil, paint, printing ink, and varnish. These test methods are applicable to liquid driers manufactured for use in paints and related coatings. The tests for metallic content using ethylenediaminetetraacetic acid dihydrate (EDTA) are intended for concentrated solutions of single metals; two or more metals may cause interference.1.1 These test methods cover the test procedures to be applied to liquid paint driers used in paints and related coatings. Typical paint driers, listed in Specification D 600, are carboxylates of lead, cobalt, manganese, zinc, iron, calcium, and zirconium. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Methods for Liquid Paint Driers

ASTM D1310-86(1997)e1 用泰格开口杯装置测定液体闪点和燃点的测试方法

1.1 This test method covers the determination by Tag Open-Cup Apparatus of the flash point and fire point of liquids having flash points between 0 and 325176;F (-18 and 165176;C) and fire points up to 325176;F.1.2 This test method, when applied to paints and resin solutions that tend to skin over or that are very viscous, gives less reproducible results than when applied to solvents. Note 18212;In order to conserve time and sample, the fire point of a material may be determined by the Tag Open-Cup Method by continuing the heating of the specimen to its fire point. Fire points may also be determined by Test Method D 92, which should be used for fire points beyond the scope of this test method.1.3 This standard should be used to measure and describe the properties of materials, products, or assemblies in response to heat and flame under controlled laboratory conditions and should not be used to describe or appraise the fire hazard or fire risk of materials, products, or assemblies under actual fire conditions. However, results of this test may be used as elements of a fire risk assessment which takes into account all of the factors pertinent to an assessment of the fire hazard of a particular end use.1.4 This standard does not purport to address the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Flash Point and Fire Point of Liquids by Tag Open-Cup Apparatus

ASTM D4451-85(1996) 低温灰化法测定涂料中颜料含量的标准试验方法

1.1 This test method covers the pigment content of paints and several traffic marking materials (thermoplastic and preformed tape) by low-temperature furnace ashing. Some organic pigments may be lost by this method and some water or moisture contained in pigments will be lost.1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Pigment Content of Paints by Low-Temperature Ashing

ASTM D4450-85(2002) 羟基亚磷酸锌颜料的分析试验方法

This test method may be used to confirm the stated zinc oxide and phosphorous acid content of zinc hydroxy phosphite pigment.1.1 This test method is intended for the determination of zinc oxide and phosphorous acid content of the pigment commercially known as zinc hydroxy phosphite. The zinc content is determined by ethylenediaminetetraacetate (EDTA) titration and calculated as zinc oxide (ZnO), while the phosphorus content is determined colorimetrically and calculated as phosphorous acid (H3PO3).1.2 The analytical procedures appear in the following order:SectionsZinc oxide6 through 8Phosphorous acid9 through 14This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Analysis of Zinc Hydroxy Phosphite Pigment

ASTM D4450-85(2007) 羟基亚磷酸锌颜料的分析试验方法

1.1 This test method is intended for the determination of zinc oxide and phosphorous acid content of the pigment commercially known as zinc hydroxy phosphite. The zinc content is determined by ethylenediaminetetraacetate (EDTA) titration and calculated as zinc oxide (ZnO), while the phosphorus content is determined colorimetrically and calculated as phosphorous acid (H3PO3).1.2 The analytical procedures appear in the following order:1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Analysis of Zinc Hydroxy Phosphite Pigment

ISO 277:1983 涂料和清漆用生桐油.规范和试验方法

Raw tung oils for paints and varnishes; Specifications and methods of test

JIS K 5421:1983 熟炼油及熟亚麻仁油

Boiled oil and boiled linseed oil