共找到 259 条与 控制电器 相关的标准,共 18 页
Automatic electrical controls for household and similar use; part 1: general requirements (IEC 730-1:1986/AMD 2:1991, modified)
Adds definition 2.1.5 (smooth direct current), amends subclause 3.8, adds a note to 4.2.2, replaces 4.2.10.2 and 4.2.10.3, replaces the last paragraph of 5.14 and adds a new paragraph, replaces "Under consideration" in 7.13 by text, amends 8.3.6.1, 8.3.6
General requirements for residual current operated protective devices; amendment 2
Automatic electrical controls for household and similar use; part 2: particular requirements for electrical controls for electrical household appliances
The Canadian Standards Association, which operates under the name CSA International (CSA), under whose auspices this National Standard has been produced, was chartered in 1 91 9 and accredited by the Standards Council of Canada to the National Standa
Ouvre-Portes Et Dispositifs De Commande De Barrieres, De Rideaux Et De Volets Fiche No 1
Electromechanical contactors for household and similar purposes
Supplements or modifies the corresponding clauses in IEC 730-1, so as to convert that publication into the IEC standard: Safety requirements for automatic electrical pressure sensing controls including mechanical requirements.
Automatic electrical controls for household and similar use; part 2: particular requirements for automatic electrical pressure sensing controls including mechanical requirements
Automatic electrical controls for household and similar use; part 2: particular requirements for electrical controls for electrical household appliances (IEC 730-2-1:1989, modified)
Automatic electrical controls for household and similar use; part 1: general requirements; amendment 1
Automatic electrical controls for household and similar use; part 1: general requirements; amendment 11
Electromagnetic interference filter
Characteristics and requirements for a general purpose electrical connector with earth contact for use with single solenoid operators for control valves and intended for use in conditions where they are protected from physical damage. Includes a national appendix making recommendations for safe wiring configurations for certain types of valve used in hydraulic systems.
Specification for three-pin plug connectors for electrically controlled fluid power equipment
Low-voltage controlgear; part 2: semiconductor contactors (solid state contactors)
Canadian Standards Association (CSA) standards are developed through a consensus standards development process approved by the Standards Council of Canada. This process brings together volunteers representing varied viewpoints and interests to achieve co
Electromagnetic Interference (EMI) Filters Fourth Edition; Includes General Instruction No 1 - 3
Low-voltage controlgear. Part 3 : Additional requirements for contactors subject to certification
The primary function of residual current devices is to give protection against "indirect contact", but with devices of adequate sensitivity (that is units having operating residual currents not exceeding 30 mA) there is the additional benefit that, shoul
General requirements for residual current operated protective devices
Low-voltage controlgear. Part 2 : Semiconductor contactors (solid state contactors)
This specification is approved for use by US Army Armament Research and Development Command, Department of the Army, and is avaiLable for use by all Departments and Agencies of the Department of Defense.
COUPLING HALF, QUICK DISCONNECT
Starter for d.c.-motors and a.c.-slip-ring induction motors
Starter for d.c.-motors and a.c.-slip-ring induction motors
AC contactors. Reliability requirement and test method
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号