M74 广播、电视发送与接收设备 标准查询与下载

DLA SMD-5962-95689 REV G-2007 抗辐射四重微分线路接收器硅单片电路线型微电路

The General Services Administration has authorized the use of this Commercial Item Description

MICROCIRCUIT, LINEAR, RADIATION HARDNED, LINE RECEIVER, QUAD DIFFERENTIAL MONOLITHIC SILICON

DLA SMD-5962-88751 REV C-2007 硅单片三倍RS-232驱动器/接收器线性微电路

This drawing describes device requirements for MIL-STD-883 compliant, non-JAN class level B microcircuits in accordance with MIL-PRF-38535, appendix A.

MICROCIRCUIT, LINEAR, TRIPLE RS-232 DRIVER/RECEIVER, MONOLITHIC SILICON

IEC 62273-1:2007 无线电发射机测量方法.第1部分:地面数字电视发射机的工作特性

This part of IEC 62273 gives the conditions for measuring the performance parameters of terrestrial digital transmitters and for facilitating the comparison of measurements which are carried out by different personnel. It contains details of specially selected methods for determining the most important performance parameters of digital transmitters. The measurement methods described apply to a limited number of performance parameters, i.e. those which can give rise to ambiguous interpretation due to the use of different methods and conditions. They are neither restrictive nor mandatory: measurements can be chosen for each particular case. If necessary, additional tests can be carried out but they shall comply with those standards which have been established by other study groups, subcommittees of the IEC or other international or suitably accredited organizations. No limits have been assigned to quantify acceptable ranges of performance parameters. These are judged to be properly included in the technical specifications for individual transmitters; however, the terms and the manner used to quantify them should ideally be those described in a future IEC publication. The measurement methods described in this standard are intended for type approval tests. However they can equally well apply to acceptance tests measurements and quality control tests either in factories or on site. Test signals are used to measure performance parameters for both digital and analogue terrestrial transmitters. Their electronic characteristics and their associated performance parameters are widely understood. The test signals are measured after they have gone through the transmitter equipment to determine if their degradation is within the required quality criteria. This standard does not go into any detail regarding MPEG 2 signals or DVB processes nor does it deal with digital signal processing.

Methods of measurement for radio transmitters - Part 1: Performance characteristics of terrestrial digital television transmitters

DLA MIL-DTL-5815 G-2007 超高频带飞机用天线的一般规范

This specification covers the general requirements for ultra high frequency (UHF) band airborne antenna.

ANTENNA, AIRBORNE, UHF - BAND, GENERAL SPECIFICATION FOR

DLA MIL-DTL-25895 A-2007 AT-505/AP型天线

This specification establishes the requirements for Antenna AT-505/AP which is a pressure-sealed single-slot flush-mounted broadband airborne antenna.

ANTENNA AT-505/AP

ITU-R REPORT BS.2104-2007 调频(FM)调制器干扰广播业务

The increasing proliferation of short-range FM modulators for consumer use with automobile and personal audio devices has led to the studies described in this report. Four Appendices are provided that address the concerns for interference.

FM modulator interference to broadcast services

ANSI/CEA 2020-2007 其它垂直消隐信息(VBI)波形

Specifies four Vertical Blanking Interval (VBI) waveforms in commercial use. The electrical properties of the waveforms are covered, but the meaning of the payload data is not. The waveforms apply to 525-line, interlaced (i.e. 480i) analog television signals. The waveforms may be present on analog inputs and analog outputs, but no conformance requirements about the actual presence of the waveforms are defined in this standard.

Other VBI Waveforms

ITU-R SM.1840-2007 测量使用模拟调制信号无线电监测接收机灵敏度的测试程序

This Recommendation belongs to a set of Recommendations describing the test methods to determine technical parameters of radio monitoring receivers that are important for the users of these receivers. When the described methods are followed by manufacturers, comparing different receivers is made easier. This Recommendation provides the definition of a sensitivity test procedure for receivers. This test procedure definition is recommended to all the manufacturers, with the advantage for the users of such receivers, that an easier and more objective assessment of product quality is possible.

Test procedure for measuring the sensitivity of radio monitoring receivers using analogue-modulated signals

ANSI/CEA 2022-2007 数字视频转换器(STB)有效功率消耗测量

CEA-2022 defines a method for measuring power consumption of a digital set top box (STB) whose primary function is video reception and delivery when operating in an active (ON) state.

Digital STB Active Power Consumption Measurement

ANSI/CEA 2013-A-2007 数字视频转换器(STB)背景功率消耗

This standard defines maximum background mode (SLEEP state) energy consumption of basic digital set top boxes (STBs), whose primary function is video reception and delivery. Digital STBs spend large amounts of time in SLEEP state when consumers are not watching television. Annex A provides a detailed SLEEP state power measurement specification & procedure. Annex A can be used as the test method for specifying SLEEP state power of any STB, including types with advanced features.

Digital STB Background Power Consumption

ITU-R SM.1840 SPANISH-2007 用于使用模拟调制信号的无线电监测接收机灵敏度测量的测试程序

This Recommendation belongs to a set of Recommendations describing the test methods to determine technical parameters of radio monitoring receivers that are important for the users of these receivers. When the described methods are followed by manufacturers, comparing different receivers is made easier. This Recommendation provides the definition of a sensitivity test procedure for receivers. This test procedure definition is recommended to all the manufacturers, with the advantage for the users of such receivers, that an easier and more objective assessment of product quality is possible.

Test procedure for measuring the sensitivity of radio monitoring receivers using analogue-modulated signals

ITU-R SM.1840 FRENCH-2007 用于使用模拟调制信号的无线电监测接收机灵敏度测量的测试程序

This Recommendation belongs to a set of Recommendations describing the test methods to determine technical parameters of radio monitoring receivers that are important for the users of these receivers. When the described methods are followed by manufacturers, comparing different receivers is made easier. This Recommendation provides the definition of a sensitivity test procedure for receivers. This test procedure definition is recommended to all the manufacturers, with the advantage for the users of such receivers, that an easier and more objective assessment of product quality is possible.

Test procedure for measuring the sensitivity of radio monitoring receivers using analogue-modulated signals

DLA QPL-28837-12-2006 无线电频率混频器模块一般规格

This list has been prepared for use by or for the Government in the acquisition of products covered by Specification MIL-DTL-28837 Listing of a product is not intended to and does not connote endorsement of the product by the Department of Defense.

MIXER STAGES, RADIO FREQUENCY, GENERAL SPECIFICATION FOR

JB/T 10613-2006 数字式电动机综合保护装置通用技术条件

本标准规定了380V～10kV电压等级的数字式电动机综合保护装置的分类、技术要求、试验方法、检验规则、包装、运输、贮存、标志、标签、使用说明书、供货的成套性及质量保证等。 本标准适用于380V～10kV电压等级的电动机的数字式综合保护装置，作为高度民主产品设计、制造、试验和使用的依据。

General technical specifications for integrated protection unit of digital electromotors.

DLA DSCC-DWG-04026 REV A-2006 DBA焊料口袋系列JAMNUT展开(螺纹贮器,插座接触)无线电频率,同心双心同轴连接器

This revision described below has been authorized for the document listed.

CONNECTOR, CONCENTRIC TWINAXIAL, RADIO FREQUENCY, (THREADED RECEPTACLE, SOCKET CONTACT) JAMNUT MOUNTED, SOLDER POCKET, SERIES DBA

DLA MIL-DTL-17 H SUPP 1-2006 易曲半硬式无线电频率电缆的一般规范

The activities listed above were interested in this document as of the date of this document.Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at http://assist.daps.dla.mil.

CABLES, RADIO FREQUENCY, FLEXIBLE AND SEMIRIGID, GENERAL SPECIFICATION FOR

NF Z82-018-2:2006 电磁兼容性和射频频谱管理(ERM).调频声音播放发射设备.第2部分:根据R&TTE指令中3.2条款统一的EN(V1.2.1)

Electromagnetic compatibility and Radio spectrum Matters (ERM) - Transmitting equipment for the Frequency Modulated (FM) sound broadcasting service - Part 2 : harmonized EN under article 3.2 of the R&TTE Directive (V1.2.1).

NF Z82-018-1:2006 电磁兼容性和射频频谱管理(ERM).调频声音播放发射设备.第1部分:技术特性和试验方法(V1.2.1)

Electromagnetic compatibility and Radio spectrum Matters (ERM) - Transmitting equipment for the Frequency Modulated (FM) sound broadcasting service - Part 1 : technical characteristics and test methods (V1.2.1).

BS EN 50401:2006+A1:2011 验证投入使用的具有基本限值或参数范围的无线通讯网络用固定无线电广播设备(110MHz～40GHz)合格性的产品标准(基本限值和参考范围与公众暴露于无线电频率电磁场相关)

Product standard to demonstrate the compliance of fixed equipment for radio transmission (110 MHz - 40 GHz) intended for use in wireless telecommunication networks with the basic restrictions or the reference levels related to general public exposure to r

BS EN 50420:2006 人体暴露于独立广播发射机(30MHz～40GHz)电磁场的评估用基本标准

This standard applies to a broadcast transmitter operating in the frequency range 30 MHz to 40 GHz when put on the market. The objective of the standard is to specify, for such equipment operating in typical conditions, the method for assessment of compliance distances according to the basic restrictions (directly or indirectly via compliance with reference levels) related to human exposure to radio frequency electromagnetic fields.

Basic standard for the evaluation of human exposure to electromagnetic fields from a stand alone broadcast transmitter (30 MHz - 40 GHz)