P46 供热、采暖工程 标准查询与下载

JG/T 3047-1998 采暖散热器.灰铸铁柱翼型散热器

本标准规定了灰铸铁柱翼型散热器的型式、尺寸与性能参数、技术要求、试验方法、检验规则、标志、包装、运输、贮存。 本标准适用于工业、民用建筑中以热水、蒸汽为热媒的灰铸铁柱翼型散热器。 热媒为热水时，温度低于130℃，灰铸铁材质不低于HT100，工作压力为0.5MPa;温度低于150℃，材质不低于HT150，工作压力为0.8 MPa。热媒为蒸汽时，工作压力为0.2MPa。

Heating radiator.Cast iron column-wing-type radiator

JG/T 3012.2-1998 采暖散热器.钢制翅片管对流散热器

本标准规定了钢制翅片管对流散热器的型式、尺寸与性能参数、技术要求、试验方法、检测规则、标志、包装、运输和贮存等。 本标准适用于工业、民用建筑中以热水和蒸汽为热媒的对流器。对流器的工作压力:热水热媒为1.0 MPa；蒸汽热媒为0.3MPa。

Heating radiator.Steel finned-tube convector

DIN 18160-5:1998 烟囱.第5部分:烟囱清扫工作用工具.要求、计划与制造

Chimneys - Part 5: Appliances for chimney-sweep work; requirements, planning and constructions

BS EN 1264-3:1998 地板加热设施.系统和部件.尺寸测量

This standard is applicable to hot water floor heating systems as defined in EN 1264-1. Physiological limitations are taken into account when specifying the floor surface temperature. The design is based on performance characteristic curves and limit curves calculated in accordance with EN 1264-2.

Floor heating - Systems and components - Dimensioning

BS EN 1264-1:1998 地板加热设施.系统和组件.定义和符号

This European Standard is applicable to hot water floor heating systems in residential, office and other buildings, the use of which corresponds to or is similar to that of residential buildings. This European Standard is not applicable to floor heating systems in wood flooring. It also applies as appropriate to the use of other heating media instead of water. The important definitions and symbols for hot water heating systems are specified in this standard.

Floor heating - Systems and components - Definitions and symbols

BS EN 1264-2:1998 地板加热设施.系统和组件.热输出量的测定

This European Standard is applicable to hot water floor heating systems as defined in EN 1264-1. The determination of thermal performance of hot water floor heating systems and their conformity to this standard is carried out by calculation in accordance with design documents and model: in the case of special constructions and if necessary, the determination of thermal performance by calculation is combined with measurement techniques. This European Standard specifies procedures and conditions to enable the heat flow density of hot water floor heating systems to be determined relative to the heating medium differential temperature for standard systems. For special systems the additional influencing factors are experimentally determined and introduced in the calculation. This should enable a uniform assessment and calculation of floor heating systems. The nominal heat flow density, the associated nominal heating medium differential temperature and the field of characteristic curves for the relationship between heat flow density and the determining variables are given as the result.

Floor heating - Systems and components - Determination of the thermal output

BOCA IOTFDC-1998 CHAPTER 33-1998 热水器

To serve governmental units, code administration personnel, and related building industry professionals by providing authoritative technical, educational and informational services relating to all specialty mas of code administration and enforcement.

Water Heaters

ARI 940-1998 干燥除湿混合物

This standard is intended for the guidance of the industry, including manufacturers, engineers, installers, contractors and users.

Desiccant Dehumidification Components

BOCA IOTFDC-1998 CHAPTER 14-1998 供热和制冷设备

The format and provisions of The BOCA National Propero Maintenance Code are designed to provide units of government with an effective regulatory means of providing minimum health and safety requirements for existing buildings and structures.

Heating and Cooling Equipment

BOCA IOTFDC-1998 CHAPTER 23-1998 锅炉/热水器

This table, a nomogram, determines the distribution pipe or manifold length, hole or distribution pipe spacing, number of boles, dis?ibution discharge rate and hole diameter of pressure distribution systems by the placement of a straightedge between two

Boilers/Water Heaters

CJJ/T 78-1997 供热工程制图标准

Standard for drawing of heat-supply engineering

JIS A 4009:1997 空气管道组件

この規格は空気調和及び換気設備(排煙設備用を含む。)に用いるダクトの構成部材(以下,ダクトという。)について規定する。

Components of air duct

AS/NZS 4445.1:1997 太阳能加热.家用水加热系统.第1部分:使用室内试验方法的性能评估规程

This Standard provides an indoor test method for rating solar domestic water heating for thermal performance under benchmark conditions. This Standard is identical with and reproduced from ISO 9459.1:1993.

Solar heating - Domestic water heating systems - Performance rating procedure using indoor test methods

BOCA IPC-1997 CHAPTER 5-1997 热水器

The provisions requiring that the excavation left when an unfit structure has been removed be filled in is an obvious, but often neglected means of protecting the public health and safety.

Water Heaters

SY/T 0306-1996 滩海石油工程热工采暖技术规范

本规范适用于滩海石油工程平台与人工岛上热工、采暖的设计和施工。

Technical specification for heating engineering and heating of petroleum engineering in beach-shallow sea

DB65/ 018-1996 搪瓷烧成窑炉节能监测规范

Specifications for Energy Saving Monitoring of Enamel Firing Kilns

CJ/T 3053-1995 隔绝式气体加压膨胀装置

Isolative gas-pressurized expansion device

BS EN 835:1995 测定房间暖气片消耗的热成本分配器.以蒸发原理为基础的不带电源器具

Specifies minimum requirements for construction, installation and evaluation of the displayed readings. Also specifies test procedures.

Heat cost allocators for the determination of the consumption of room heating radiators - Appliances without an electrical energy supply, based on the evaporation principle

JIS A 4303:1994 排烟设备的检验标准

この規格は，建築物に設置した排煙設備の性能について検査するための検交項目，検査器具，検査方法及び判定基準について規定する。

Inspection standard of smoke exhaust equipment

CECS 60-1994 半即热式水加热器热水供应设计规程

本规程适用于以半即热式水加热器制备热水的生活或生产用热水供应工程设计。

SPECIFICATION FOR DESIGN OF HOTWATER SUPPLY WITH SEMI-INSTANTANEOUS WATER HEATER