V39 燃油系统及其附件 标准查询与下载

BS 2C 13:1988 飞机重力灌注燃油口及相关供燃油嘴的尺寸规范(米制系列)

Aims to minimise the dangerous possibility of refuelling gasoline powered aircraft with turbine fuel.

Specification for sizes of aircraft gravity filling orifices and associated replenishment nozzles (metric series)

HB 6151-1988 飞机液压系统非隔离式油箱通用技术条件

本标准规定了飞机用非隔离式液压油箱通用技术条件。非隔离式液压油箱是指油箱内气体直接与油液接触的油箱。 　　本标准适用于按ＨＢ ５９４９－８６《飞机Ⅰ、Ⅱ型液压系统设计、安装要求》设计的非隔离式液压油箱。本标准为ＨＢ６１１５－８６《飞机液压系统附件通用技术条件》的具体实施，当本标准的要求超出ＨＢ６１１５－８６的范围时，按本标准的要求执行。专用的非隔离式液压油箱其技术要求超出本标准规定时，可在本标准的原则指导下制订专用技术条件。

General specifications for non-isolated fuel tanks of aircraft hydraulic systems

NAVY MIL-STD-1362 A-1987 海军动力锅蒸汽纯度测量程序

This standard covers the procedure for the determination of steam purity in Naval propulsion boilers.

PROCEDURES FOR STEAM PURITY MEASUREMENT NAVAL PROPULSION BOILERS

NAVY MIL-P-18526 A (1)-1987 海军舷侧用主锅炉燃料服务的主要港口用容积式泵

This amendment forms a part of MIL-P-l8526A(SH), dated 31 May 1978, and is approved for use by the Naval Sea Systems Command, Department of the Navy and is available for use by all Departments and Agencies of the Department of Defense.

PUMPS, POSITIVE DISPLACEMENT, MAIN/PORT USE, MAIN BOILER FUEL SERVICE, NAVAL SHIPBOARD USE

NAVY MIL-STD-1322-74-1987 MK 71型目标探测装置,用于国内和海外输送的集装物资,置于图号为 5479491的集装箱内

POSITION STRAPPING, ITEM 5. UNDER PALLET DECK AND AROUND THE UNIT LOAD. TENSION AND DOUBLE NOTCH SEAL. ITEM 8.

UNIT LOAD FOR DOMESTIC AND OVERSEAS SHIPMENT TARGET DETECTING DEVICE MK 71 IN CONTAINER DWG. 5479491

HB 6130-1987 飞机压力加油接嘴外形尺寸标准

Dimensions standard for aircraft pressure refueling nozzle

HB 6122-1987 飞机压力加油接嘴通用技术条件

本技术条件适用于锁紧式压力加油接嘴。当飞机在地面时，这种接嘴与飞机压力加油接头刚性连接，利用地面压力加油系统对飞机进行加油或抽油。

General technical specifications for aircraft pressure refueling nozzles

HB 6117-1987 航空燃气涡轮发动机气态污染物的连续取样及测量程序规范

本规范规定了对航空燃气涡轮发动机中气态污染物的连续取样和分析以及对一氧化碳（CO）、二氧化碳（CO2）、一氧化氮（NO）、二氧化氮（NO2）及总碳氢化合物（HC）的测试设备及试验程序。 　　本规范不适用于飞行试验和发动机开加力的情况

Specification for continuous sampling and measurement procedures for gaseous pollutants in aviation gas turbine engines

HB 6116-1987 航空燃气涡轮发动机排气冒烟测量规范

本规范规定了航空燃气涡轮发动机的排气冒烟测量程序和装置。 　　本规范不适用于航空燃气涡轮发动机飞行试验情况和发动机开加力的情况，但可用于航空燃气涡轮发动机烧烧室出口排气冒烟的测量。

Specifications for measurement of exhaust smoke from aviation gas turbine engines

ARMY MIL-H-48085 A VALID NOTICE 1-1987 4.2英寸弹药的推进剂夹持器

This notice should be filed in front of MIL-F-l2774D(AR), dated 22 May 1975

HOLDER, PROPELLANT FOR 4.2 INCH AMMUNITION

NAVY MIL-F-17280 D-1987 航海扫雷无磁性固定装置

This specification covers miscellaneous nonmagnetic fittings used in minesweeping.

FITTINGS, MARINE MINESWEEPING, NONMAGNETIC

AIR FORCE MIL-P-87896 (1)-1987 三氟化氮推进剂

This amendment forms a part of Military Specification MIL-P-87896, dated 4 October 1982, and is approved for use by-all Departments and Agencies of the Department of Defense

PROPELLANT, NITROGEN TRIFLUORIDE

HB 6100-1986 航空燃油过滤器通用技术条件

本标准规定了对额定工作压力为〔g〕（1～8公斤·力/平方厘米）绝对过滤度为5～75微米燃油过滤器的一般技术要求。 　　本标准适用于航空燃油过滤器及滤芯的新品研制及其新产品转批生产和老产品的改进改型。

General specification for aviation fuel filter

ARMY MIL-S-70547-1986 M38型发射装药使用的类似球体的推进剂 M218.M219和XM220型81MM催泪弹.XM879.M853和M819型照明使用

This specification covers the requirements and quality acceptance provisions for manufacture and acceptance of Spher oidal Propellant,M38, for use in propelling charges M218, M219, and XM220 for cartridges,81MM, Smoke, RP, M819, Illuminating M853 and Practice,XM879.

SPHEROIDAL PROPELLANT, M38 FOR USE IN PROPELLING CHARGES M218, M219, AND XM220 FOR CARTRIDGES, 81MM SMOKE, M819, ILLUMINATING M853 AND PRACTICE, XM879

NAVY MIL-F-8615 D (2)-1986 燃油系统的组成部分一般规格

This amendment forms a part of MIL-F-8615D, dated 29 March 1976, and is approved for use by all Departments and Agencies of the Department of Defense.

FUEL SYSTEM COMPONENTS: GENERAL SPECIFICATION FOR

SAE AIR1408A-1986 航空航天燃料系统的规范和标准

This report lists documents that aid and govern the design of gas turbine powered aircraft and missile fuel systems. The report lists the military and industry specifications and standards and the most notable design handbooks that are commonly used in fuel system design. The specifications and standards section has been divided into two parts, a master list arranged numerically of all industry and military specifications and standards and a component list that provides a functional breakdown and a cross-reference of these documents. It is intended that this report be a supplement to specifications MIL-F-8615; MIL-F-17874; MIL-F-38363 and MIL-F-87154. Revisions and amendments which are correct for the specifications and standards are not listed. The fuel system design handbooks are listed for fuels and for system and component design.

Aerospace Fuel System Specifications and Standards

NAVY MIL-P-85759-1986 MARK 93 MOD 0式推进剂药柱

This specification covers the requirements for the manufacture and acceptance of the Mark 93 Mod O Propellant Grain (see 6.1). Propellant grain, as used herein, refers to an extruded hollow cylinder of propellant with an ethyl cellulose inhibitor disc cemented to one end.

PROPELLANT GRAIN, MARK 93 MOD 0

NAVY MIL-P-18942 A NOTICE 2-1986 20MM防空用枪 MARK 12推进剂

This notice should be filed in front of MIL-P-l8942A(3)(OS) dated 25 August 1971.

PROPELLANT FOR 20MM ANTI-AIRCRAFT GUN MARK 12

NAVY MIL-V-18683 A (1)-1986 海军舰载使用功率驱动离心泵服务的真空泵

This amendment forms a part of MIL-V-l8683A(SHIPS), dated 15 November 1971, and is approved for use within the Naval Sea Systems Command, Department of the Navy and is available for use by all Departments and Agencies of the Department of Defense.

VACUUM PUMPS, POWER DRIVEN, CENTRIFUGAL PUMP PRIMING SERVICE, NAVAL SHIPBOARD

NAVY MIL-P-17639 F-1986 海军舷侧用的综合服务离心泵

This specification covers the requirements applicable to the design an?? construction of centrifugal pumps.

PUMPS, CENTRIFUGAL, MISCELLANEOUS SERVICE, NAVAL SHIPBOARD USE