V39 燃油系统及其附件 标准查询与下载

HB 6756-1993 飞机燃油箱重力加油快卸口盖

本标准规定了飞机燃油箱重力加油快卸加油口盖的设计、制造、试验方法及检验规则。 　　本标准适用于飞机燃油箱快卸加油口盖。

Aircraft fuel tank gravity refueling quick release cap

HB 6757-1993 飞机燃油箱晃动和振动试验要求

本标准规定了飞机燃油箱晃动和振动复合试验的要求和方法。 　　本标准适用于飞机用可拆卸的机身、机翼内部和外部燃油箱及外挂副油箱的晃动和振动试验。

Aircraft fuel tank sloshing and vibration test requirements

SAE ARP4024-1994 飞机/发动机燃油泵净正吸力压的性能测试和评估

This procedure applies to engine or airframe-mounted fuel pumps. The procedure recommends single-pass operation to minimize changes in fuel properties affecting NPSP capability. An optional method using a recirculation system is also included and may be specified at the discretion of the equipment specification. This procedure defines the recommended test setup, test procedure, data acquisition, and data presentation.

Aircraft/Engine Fuel Pump Net Positive Suction Pressure Performance Test and Evaluation

NAVY MIL-W-19623 B-1994 海军舰载使用的纵向和海军型电动液压起锚机

This specification covers electric hydraulic, vertical shaft, anchor windlass installation on Naval ships.

WINDLASS: ANCHOR, ELECTRIC-HYDRAULIC, VERTICAL AND NAVY TYPE, NAVAL SHIPBOARD

SAE ARP492C-1994 飞机发动机燃油泵气穴现象的耐久性试验

This SAE Aerospace Recommended Practice (ARP) defines procedures for testing aircraft engine fuel pumps for the purpose of determining their resistance to deterioration, during steady state endurance test, while receiving MIL-T-5624 Grade JP-4 fuel as a homogenous mixture of gas and liquid expressed as a ratio of vapor volume to liquid volume (V/L). If any of the above conditions do not apply, refer to Section 2. The procedure recommended herein is based on experience gathered by a number of laboratories conducting component qualification tests to MIL-E-5009, currently MIL-E-5007. It is intended to produce a uniform reproducible steady state test condition for fuel pump cavitation testing as required by various military engine specifications. This test is not intended to establish altitude or climb rate, starting, or other transient performance of the article tested.

Aircraft Engine Fuel Pump Cavitation Endurance Test

NAVY MIL-P-85364 A-1993 CTBN 23-17型推进剂

This specification covers the minimum requirements for one type of solid propellant grain (see 6.1).

PROPELLANT, CTBN 23-17

JIS W 3202:1993 飞行器.压力加油连接件

この規格は，航空機用燃料加圧補給接続部の基準寸法及び接近用すきまについて規定する。

Aircraft -- Pressure refuelling connections

NAVY MIL-HDBK-1151-1993 用于检查的手册针对海军预备役中心的保养和操作

MAINTENANCE AND OPERATION OF NAVAL RESERVE CENTERS, HANDBOOK FOR INSPECTION

MAINTENANCE AND OPERATION OF NAVAL RESERVE CENTERS, HANDBOOK FOR INSPECTION

NAVY MIL-STD-1322-58 NOTICE 2-1993 MK 57型水雷的推进剂,用于国内和海外输送的集装物资,置于DL 5166866型集装箱内

MIL-STD-1322-58(OS) is inactive for new design and is no longer used by the Navy except for replacement purposes.

UNIT LOAD FOR DOMESTIC AND OVERSEAS SHIPMENT PROPELLANT, FOR MK 57 UNDERWATER MINE IN CONTAINER DL 5166866

NAVY MIL-STD-1322-65 NOTICE 1-1993 用于MK 67型水雷的MK 141型目标探测装置引信,用于国内和海外输送的集装物资,置于图号为5003172的集装箱内

This notice should be filed in front of MIL-STD-1322-65(OS) dated 25 September 1985.

UNIT LOAD FOR DOMESTIC AND OVERSEAS SHIPMENT ADAPTER, TARGET DETECTING DEVICE MK 141 IN CONTAINER DWG. 5003172 FOR MK 67 UNDERWATER MINE

NAVY MIL-STD-1322-78 NOTICE 2-1993 MK 7型尾部,用于国内和和海外输送的集装物资,置于图号为5363565的集装箱内

MIL-STD-1322-78(OS) is inactive for new design and is no longer used by the Navy except for replacement purposes.

UNIT LOAD FOR DOMESTIC AND OVERSEAS SHIPMENT TAIL SECTION MK 7 TYPE IN CONTAINER DWG 5363565

SAE AMS3387E-1993 纺织材料增强,覆有氯丁二烯的非塌陷型丁腈橡胶飞机加油管

This specification covers a synthetic rubber in the form of a non-rigid, smooth bore, noncollapsinghose with textile reinforcement.

Hose, Aircraft Fueling, Acrylonitrile Butadiene (NBR) Rubber Textile Reinforced, Chloroprene Covered Noncollapsing

NAVY MIL-P-82887-1993 76MM/62 口径弹药筒M6+2推进剂

This specification covers the requirements for M6+2 Propellant for use in the 76MM/62 Caliber Propelling Charge (see 6.1).

PROPELLANT, M6+2 FOR THE 76MM/62 CALIBER CARTRIDGE

SAE AMS3386D-1993 折叠的织物增强包覆氯丁二烯的丁腈橡胶(NBR)的航空器加燃料用软管

This specification covers a synthetic rubber in the form of soft wall, smooth bore, collapsing-type hose. This hose has been used typically for fueling aircraft from tank trucks or pits where the hose will be rolled flat for stowage on a reel, but usage is not limited to such applications. Not recommended for operating pressures higher than 125 psi (862 kPa).

Hose, Aircraft Fueling, Acrylonitrile Butadiene (NBR) Rubber, Textile Reinforced, Chloroprene Covered, Collapsing

SAE AMS3389D-1993 双金属丝编织增强,覆有氯丁二烯的非塌陷型丁腈橡胶飞机加油管

This specification covers a synthetic rubber in the form of a nonrigid, smooth bore,noncollapsing-type hose.

Hose, Aircraft Fueling, Acrylonitrile Butadiene (NBR) Rubber, Double Wire Braid Reinforced, Chloroprene Covered, Noncollapsing

SAE AMS3388D-1993 单金属丝编织增强,覆有氯丁二烯的非塌陷型丁腈橡胶飞机加油管

This specification covers a synthetic rubber in the form of a non-rigid, smooth bore,noncollapsing-type hose.

Hose, Aircraft Fueling, Acrylonitrile Butadiene (NBR) Rubber Single Wire Braid Reinforced, Chloroprene Covered, Noncollapsing

NAVY MIL-P-19264 B-1993 THE5的 BS-NACO推进剂

This specificatcion ovnerstherequiremenfto rBS-NACO Propellanftoruseinthe5“/54 CalibePrropellinCgharg

PROPELLANT, BS-NACO, FOR THE 5"/54 CALIBER PROPELLING CHARGE

NAVY OO-D-1388 B (1)-1992 无架传输商用洗碗机

This amendment w h i c h forms a part of 00-D-l388B, dated May 21, 1984, is approved by the Commissioner, Federal Supply Service, General Services Administration, for the use of all Federal agencies.

DISHWASHING MACHINES, COMMERCIAL (RACKLESS CONVEYOR)

NAVY MIL-S-87005 D-1992 女式制服衬衫(海岸巡逻队队员)

This specification covers the requirements for a polyester and wool woman's skirt.

SKIRT, WOMAN'S, DRESS (CG)

NAVY MIL-STD-1362 A VALID NOTICE 1-1992 海军动力锅蒸汽纯度测量程序

MIL-STD-l362A(SH), dated 06 July 1987, has been reviewed and determined to be valid for use in acquisition.

PROCEDURES FOR STEAM PURITY MEASUREMENT NAVAL PROPULSION BOILERS