Z11 气体介质与放射性物质采样方法 标准查询与下载

KS I 25640-2012 木制板状产品的甲醛释放量测量.封闭式环境测试法

이 표준은 대형 챔버를 사용하여 목질 판상 제품에서 방출되는 폼알데하이드 측정을 위한 시료

Determination of emission of formaldehyde from wood product－Large chamber method

ASTM D5111-12 非城市地区监测大气沉积物的选址和取样方法的标准指南

1.1 This guide assists individuals or agencies in identifying suitable locations and choosing appropriate sampling strategies for monitoring atmospheric deposition at non-urban locations. It does not purport to discuss all aspects of designing atmospheric deposition monitoring networks. 1.2 The guide is suitable for use in obtaining estimates of the dominant inorganic constituents and trace metals found in acidic deposition. It addresses both wet and dry deposition and includes cloud water, fog and snow. 1.3 The guide is best used to determine estimates of atmospheric deposition in non-urban areas although many of the sampling methods presented can be applied to urban environments. 1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

Standard Guide for Choosing Locations and Sampling Methods to Monitor Atmospheric Deposition at Non-Urban Locations

HJ 629-2011 固定污染源废气.二氧化硫的测定.非分散红外吸收法

本标准规定了测定固定污染源有组织排放废气中二氧化硫的非分散红外法。 本标准适用固定污染源有组织排放废气中二氧化硫的瞬时监测和连续监测，本方法的检出限为3mg/m³，测定下限为10mg/m³。

Stationary source emission.dtermination of sulphur dioxide.Non-dispersive infrared absorption method

KS I 20552-2010 车间空气.汞蒸气的测定.通过原子吸收光谱法或原子荧光光谱法的利用金汞合金收集及分析方法的定义.

이 표준은 차가운 증기 원자흡수분광법(CVAAS)이나 차가운 증기 원자형광분광법(CVAFS

Workplace air-Determination of mercury vapour-Method using gold-amalgam collection and analysis by atomic absorption spectrometry or atomic fluorescence spectrometry

KS I ISO 20988:2009 空气质量.评定测量不确定度指南

이 표준은 공기질 측정시 불확도를 추정하기 위한 종합적인 안내와 구체적 통계 절차를 제공하

Air quality-Guidelines for estimating measurement uncertainty

KS I 2107-2009 液体二氧化碳

이 표준은 고압가스용기에 충전시킨 공업용 액화이산화탄소(이하 액화이산화탄소라 한다.)에 대

Liquid carbon dioxide

BS EN 15169:2007 废弃物的表征.废弃物,污泥和沉渣的烧失量的测定

This European Standard specifies a method for the determination of the loss on ignition. This procedure is applicable to all kinds of waste, sludge and sediments. The loss on ignition is often used as an estimate for the content of non-volatile organic matter in waste, sludge and sediments. It should be noted that any content of elementary carbon and volatilisation of organic materials or chemical reactions by inorganic compounds, is included in the loss on ignition.

Characterization of waste - Determination of loss on ignition in waste, sludge and sediments

KS I 2007-2009 家具等的甲醛及挥发性有机化合物释放量测量方法.大房间试验方法

이 표준은 주거용 및 사무용 건물과 학교 등의 일반적인 환경에서 사용되는 가구, 사무기기,

Determination of the emission of formaldehyde and volatile organic compounds from furniture and buil

BS ISO 16000-17:2008 室内空气.霉菌的探测和计数.培养基方法

Indoor air - Detection and enumeration of moulds - Culture-based method

KS I ISO 9359:2008 空气质量.环境空气质量评定用分层采样法

이 표준은 층별 샘플링 원리를 사용하여 백분위수와 평균에 의한 대기질 상황을 평가하기 위

Air quality－Stratified sampling method for assessment of ambient air quality

KS I ISO 10312:2008 环境空气.石棉纤维的测定.直接传递电子显微镜法

표준은 대기 중 석면 구조(asbestos structures)의 농도를 측정하기 위한 투

Ambient air-Determination of asbestos fibers-Direct-transfer transmission electron microscopy method

DIN EN 15549:2008 空气质量.环境空气中苯并芘浓度的测量用标准方法

This document specifies a measurement method for the determination of particulate benzo[a]pyrene (BaP) in ambient air, which can be used in the framework of the Council Directive 96/62/EC [1] and the Directive 2004/107/EC [2]. This document specifies performance characteristics and performance criteria for the measurement method when it is used as a reference method. The performance characteristics of the measurement method are based on a sampling period of 24 h. This document describes a measurement method which comprises sampling of BaP as part of the PM10 particles, sample extraction and analysis by high performance liquid chromatography (HPLC) with fluorescence detector (FLD) or by gas chromatography with mass spectrometric detection (GC/MS). The method is applicable for the measurement of BaP in the concentration range from approx. 0,04 ng/m3 to approximately 20 ng/m3. The lower limit of the applicable range depends on the noise level of the detector and the variability of the laboratory filter blank. NOTE If the BaP concentration exceeds the calibration range the extract can be diluted.

Air quality - Standard method for the measurement of the concentration of benzo[a]pyrene in ambient air; German version EN 15549:2008

KS I ISO 22892:2007 土质.用气相色谱法和质谱法对靶子化合物识别的指南

이 규격은 가스크로마토그래프와 질량분석기(GC-MS)를 이용한 토양 시료 중의 대상 화합물

Soil quality－Guidelines for the identification of target compounds by gas chromatography and mass spectrometry

BS EN 15259:2007 空气质量.固定源排放的测量.测量区域和场所的要求及测量对象、规划和报告的要求

This European Standard specifies the following requirements: a) requirements for measurement sections and sites with respect to performing emission measurements; b) requirements for the measurement objective, plan and report of emission measurements of air pollutants and reference quantities to be carried out in waste gas ducts at industrial plants. This European Standard applies to periodic measurements using manual or automated reference methods (RM). This European Standard specifies generic principles which can be applied to perform emission measurements at different plant types and to meet different measurement objectives. NOTE The measurement objective is specified by the customer. The testing institute identifies the measurement objective and related regulatory requirements at the beginning of the measurement planning. Where measurements are being made for regulatory purposes, the customer should seek approval from the competent authority. This European Standard specifies procedures for taking representative samples in waste gas ducts. This European Standard specifies a procedure for finding the best available sampling point for automated measuring systems used for continuous monitoring of emissions. The planning and reporting aspects of this European Standard are applicable to emission measurements at diffusive and fugitive emission sources. This European Standard does not address aspects of structural safety of chimneys and ducts, construction of working platforms and safety of personnel using them.

Air quality - Measurement of stationary source emissions - Requirements for measurement sections and sites and for the measurement objective, plan and report

KS I 2006-2007 洁净工作台

이 규격은 송풍기 및 HEPA 필터 또는 ULPA 필터를 내장하고 작업 공간을 일정한 공기

Clean work station

JJG 688-2007 汽车排放气体测试仪检定规程

本规程适用于汽车排放气体测试仪（以下简称测试仪）的首次检定、后续检定和使 用中的检验，型式评价试验的相关项目可参照本规程执行。

Vehicle Exhaust Emissions Measuring Instruments

BS EN ISO 20988:2007 空气质量.评定测量不确定度指南

This International Standard provides comprehensive guidance and specific statistical procedures for uncertainty estimation in air quality measurements including measurements of ambient air, stationary source emissions, indoor air, workplace atmospheres and meteorology. It applies the general recommendations of the Guide to the Expression of Uncertainty in Measurement (GUM) to boundary conditions met in air quality measurement. The boundary conditions considered include measurands varying rapidly in time, as well as the presence of bias in a series of observations obtained under conditions of intended use of methods of air quality measurement. The methods of measurement considered comprise - methods corrected for systematic effects by repeated observation of reference materials, - methods calibrated by paired measurement with a reference method, - methods not corrected for systematic effects because they are unbiased by design, and - methods not corrected for systematic effects in intended use deliberately taking into account a bias. Experimental data for uncertainty estimation can be provided either by a single experimental design in a direct approach or by a combination of different experimental designs in an indirect approach.

Air quality - Guidelines for estimating measurement uncertainty

ISO 16000-8:2007 室内空气.第8部分:建筑物特种通风条件下局部空气存留时间的测定

This part of ISO 16000 describes the use of single tracer gas for determining the local mean age of air as an indicator of ventilation conditions in a building. The procedures include concentration decay and homogeneous constant emission. The described methods are intended for air quality studies and can be used for a) checking whether the building ventilation requirements are met, b) estimating the adequacy of ventilation in buildings with indoor air quality problems, and c) characterizing the strength and distribution of indoor emission sources. In principle, the methods can be applied to all indoor spaces, regardless of the type of ventilation used and the state of mixing of air between zones. The prevailing ventilation conditions need not be disturbed by the measurement. This part of ISO 16000 does not address the details of the analytical methods for tracer gases. The availability of such analysis services should be checked before planning actual field measurements.

Indoor air - Part 8: Determination of local mean ages of air in buildings for characterizing ventilation conditions

ISO 20988:2007 空气质量.评定测量不确定度指南

This International Standard provides comprehensive guidance and specific statistical procedures for uncertainty estimation in air quality measurements including measurements of ambient air, stationary source emissions, indoor air, workplace atmospheres and meteorology. It applies the general recommendations of the Guide to the Expression of Uncertainty in Measurement (GUM) to boundary conditions met in air quality measurement. The boundary conditions considered include measurands varying rapidly in time, as well as the presence of bias in a series of observations obtained under conditions of intended use of methods of air quality measurement. The methods of measurement considered comprise - methods corrected for systematic effects by repeated observation of reference materials, - methods calibrated by paired measurement with a reference method, - methods not corrected for systematic effects because they are unbiased by design, and - methods not corrected for systematic effects in intended use deliberately taking into account a bias. Experimental data for uncertainty estimation can be provided either by a single experimental design in a direct approach or by a combination of different experimental designs in an indirect approach.

Air quality - Guidelines for estimating measurement uncertainty

ISO 16000-5:2007 室内空气.第5部分:挥发性有机化合物(VOCs)取样法

This part of ISO 16000 is intended as an aid to planning volatile organic compound (VOC) indoor pollution measurements. In the case of indoor air measurements, the careful planning of sampling and the entire measurement strategy are of particular significance since the result of the measurement may have farreaching consequences, for example, with regard to the need for remedial action or the success of such an action. An inappropriate measurement strategy may contribute to the complete uncertainty of the measurement result in a larger extent than the measurement procedure itself. This part of ISO 16000 uses the definition for indoor environment defined in ISO 16000-1.

Indoor air - Part 5: Sampling strategy for volatile organic compounds (VOCs)