Z15 大气环境有毒害物质分析方法 标准查询与下载



共找到 764 条与 大气环境有毒害物质分析方法 相关的标准,共 51

Dieser Teil der ISO 16000 legt Anforderungen an die Erkundung von Bauwerken und deren technischen Anlagen hinsichtlich des Vorhandenseins von Schadstoffen fest. Diese dienen spater als Basis fur eine anschliesende Beprobung von Verdachtsbereichen und zur Bestimmung der Menge und Art der Schadstoffe, was aber in anderen Teilen der ISO 16000 beschrieben wird.

Indoor air - Part 32: Investigation of buildings for the occurrence of pollutants

ICS
13.040.20
CCS
Z15
发布
2014-07
实施

Ambient air. Standard gravimetric measurement method for the determination of the PM10 or PM2,5 mass concentration of suspended particulate matter

ICS
13.040.20
CCS
Z15
发布
2014-06-30
实施
2014-06-30

Le présent document décrit les procédures de mise au point, de validation et de mise en oeuvre de méthodes de prélèvement et d'analyse des gaz et vapeurs organiques pour l'évaluation des expositions professionnelles.Il est applicable au prélèvement par pompage sur tube à adsorption et à l'analyse réalisée généralement par chromatographie gazeuse, liquide ou ionique, après désorption au solvant.

Air des lieux de travail - Prélèvement et analyse de gaz et vapeurs organiques - Prélèvement par pompage sur tube à adsorption et désorption au solvant

ICS
13.040.30
CCS
Z15
发布
2014-06-14
实施
2014-06-14

This part of ISO 16000 specifies test methods of the performance of VOC detectors that are designed to monitor indoor and living atmosphere VOC concentration as well as to control indoor air quality in portable, mobile, and remote applications. The provisions in this part of ISO 16000 cover VOCs detectors as well as detectors for individual VOCs. This part of ISO 16000 sets out only the requirements applicable to a test method of VOC detectors such as response time, stability, and measuring range.

Indoor air - Part 29: Test methods for VOC detectors

ICS
13.040.20
CCS
Z15
发布
2014-06
实施

Indoor air - Part 27: Determination of settled fibrous dust on surfaces by SEM (scanning electron microscopy) (direct method)

ICS
13.040.20
CCS
Z15
发布
2014-06
实施

ERRATUM

ICS
CCS
Z15
发布
2014-05-07
实施

ERRATUM

ICS
CCS
Z15
发布
2014-05-07
实施

This International Standard specifies the determination of the number concentration of airborne inorganic fibres by phase contrast optical microscopy using the membrane filter method in workplace atmospheres, as defined by the counting criteria given in 6.5.4.

Air quality - Determination of the number concentration of airborne inorganic fibres by phase contrast optical microscopy - Membrane filter method

ICS
13.040.30
CCS
Z15
发布
2014-05-01
实施

Indoor air - Part 31: Measurement of flame retardants and plasticizers based on organophosphorus compounds - Phosphoric acid ester

ICS
13.020
CCS
Z15
发布
2014-05-01
实施
2014-05-01

Indoor air - Part 21: Detection and enumeration of moulds - Sampling from materials (ISO 16000-21:2013)

ICS
13.040.20
CCS
Z15
发布
2014-05
实施

Ambient air. Method for the measurement of benz[a]anthracene, benzo[b]fluoranthene, benzo[j]fluoranthene, benzo[k]fluoranthene, dibenz[a,h]anthracene, indeno[1,2,3-cd]pyrene and benzo[ghi]perylene

ICS
13.040.20
CCS
Z15
发布
2014-04-30
实施
2014-04-30

이 표준은 주어진 온도와 상대 습도 조건에서 피복되거나 피복되지 않은 금속 시험편 또는 제품에 미치는 부피분율 10-6 이하 농도의 한 가지 또는 여러 가지 오염 가스의 영향을 측정하기 위한 방법들을 규정한다.이 방법들은 아래에 적용한다.a) 금속과 그 합금b) 금속 코팅(모재금속에 대한 양극과 음극)c) 금속의 치환 코팅d) 금속 산화물 코팅e) 금속 위의 유기코팅

Corrosion tests in artificial atmosphere at very low concentrations of polluting gas(es)

ICS
77.060
CCS
Z15
发布
2014-04-17
实施
2014/4/17

本标准规定了测定固定污染源废气中铍的石墨炉原子吸收分光光度法。 本标准适用于固定污染源废气中铍的测定。 当采样体积为0.5 m3,定容体积为50 ml 时,铍的方法检出限为0.03 μg/m3,测定下限为0.12 μg/m3。 2

Stationary source emission-Determination of beryllium -Graphite furnace atomic absorption spectrophotometric method

ICS
CCS
Z15
发布
2014-04-01
实施
2014-04-01

Workplace exposure - Procedures for measuring a chemical agent present as a mixture of airborne particles and vapour - Requirements and test methods; German version EN 13936:2014

ICS
13.040.30
CCS
Z15
发布
2014-04
实施

This part of ISO 10121 aims to provide an objective laboratory test method, a suggested apparatus, normative test sections and normative tests for evaluation of three different solid gas-phase air cleaning media (GPACM) or GPACM configurations for use in gas-phase air cleaning devices intended for general filtration applications. This part of ISO 10121 is specifically intended for challenge testing and not for general material evaluation or pore system characterization. The three different types of GPACM identified in this part of ISO 10121 are GPACM-LF (particles of different shape and size intended for e.g. Loose Fill applications), GPACM-FL (FLat sheet fabric intended for e.g. flat one layer, pleated or bag type devices) and GPACM-TS (three dimensional structures that are many times thicker than flat sheet and e.g. used as finished elements in a device). The tests are conducted in an air stream and the GPACM configurations are challenged with test gases under steady-state conditions. Since elevated gas challenge concentrations (relative to general ventilation applications) are used, test data should be used to compare GPACM within the same configuration and not for the purpose of predicting performance in a real situation. It is also not implied that different GPACM configurations can be directly compared. The primary intention is to be able to compare like GPACM configurations to like, not between GPACM configurations. Testing of complete devices is described in ISO 10121-2. To ensure objectivity for test equipment suppliers, no specific design of the test apparatus is defined: an example is illustrated in Annex C (informative). Instead normative demands for media sample holder design, apparatus properties and validation tests are specified. The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. general ventilation — Part 2: Gas-phase air cleaning devices (GPACD) ASTM D2854, Standard Test Method for Apparent Density of Activated Carbon 3 Terms and definitions For the purposes of this document, the terms and definitions given in ISO 29464 and the following apply. 3.1 absorption transport and dissolution of a sorbate into an absorbent  Licensee=University of Alberta/5966844001, User=sharabiani, shahramfs 1

Test method for assessing the performance of gas-phase air cleaning media and devices for general ventilation - Part 1: Gas-phase air cleaning media

ICS
91.140.30
CCS
Z15
发布
2014-04
实施

Air quality -- Bulk materials -- Part 1: Sampling and qualitative determination of asbestos in commercial bulk materials

ICS
13.040.20
CCS
Z15
发布
2014-03-28
实施

Characterization of waste - Determination of gross calorific value and calculation of net calorific value; German version CEN/TS 16023:2013

ICS
13.030.01
CCS
Z15
发布
2014-03
实施

Workplace exposure - Measurement of the dustiness of bulk materials - Part 1: Requirements and choice of test methods; German version EN 15051-1:2013

ICS
13.040.30
CCS
Z15
发布
2014-03
实施

Workplace exposure - Measurement of the dustiness of bulk materials - Part 3: Continuous drop method; German version EN 15051-3:2013

ICS
13.040.30
CCS
Z15
发布
2014-03
实施

Indoor air. Detection and enumeration of moulds. Sampling from materials

ICS
13.040.20
CCS
Z15
发布
2014-02-28
实施
2014-02-28



Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号