Z23 工业废水、污染物分析方法 标准查询与下载

DIN 38404-10:1995 德国检验水、废水和污泥的标准方法.物理的及物理化学的特性参数(C组).第10部分:水的碳酸钙饱和度 (C 10)

This document describes five chemical methods for the determination of the calcit saturation of water. According to special peripheral conditions (e.g. pH-value, acid-capacity, calcium content), which are given in advance by the water to be analized, one of the five methods can be used.

German standard methods for the examination of water, waste water and sludge - Physical and physico-chemical parameters (group C) - Part 10: Calcit saturation of water (C 10)

DIN 38415-1:1995 德国对水、废水和淤泥的标准试验法.亚有机体试验方法(T组).第1部分:抗胆硷脂酶有机磷杀虫剂和尿素杀虫剂测定(胆硷脂酶试验)

The document describes a sub-animal test for the determination of organophosphorus and carbamate pesticides in water. The test is useful to determine the inhibition of the development of acetyl cholinesterase from beef-erythrocytes by these pesticides. For this purpose the analytical solution has to be measured photometric and the result has to be calculated with the given formulas.

German standard methods for the examination of water, waste water and sludge - Sub-animal testing (group T) - Part 1: Determination of cholinesterase inhibiting organophosphorus and carbamate pesticides (cholinesterase inhibition test) (T 1)

JB/T 7519-1994 热处理盐浴（钡盐、硝盐）有害固体废物.分析方法

本标准规定了热处理盐浴(钡盐、硝盐)有害固体废物的化学分析方法及允许偏差范围。 本标准适用于热处理盐浴有害固体废物--钡盐渣浸出液氯化钡和硝盐渣浸出液亚硝酸钠的测定。

Harmful solid waste of heat treatment salt bath (barium salt and nitric salt) Analysis method

JIS B 9930:1993 液压液.粒子计数法测定颗粒污染物

Hydraulic fluids -- Determination of particulate contamination by the particle count method

DIN 38406-24:1993 德国检验水、废水和污泥的标准方法.阳离子(E组).用原子吸收光谱法(AAS)测定钴含量

This document describes 2 chemical methods for the determination of cobalt in water by atomic absorption spectrometry (AAS). Method 1 uses the measurement in the air-acetylene-flame, method 2 the measurement under electrothermal atomisation conditions.#,,#

German standard methods for the examination of water, waste water and sludge; cations (group E); determination of cobalt by atomic absorption spectrometry (AAS) (E 24)

ASTM D4698-92(1996) 各种金属化学分析用沉淀样品的完全消解的标准规程

1.1 This practice covers two procedures for the total digestion of sediments for subsequent determination of metals by such techniques as flame atomic absorption spectrophotometry, graphite-furnace atomic absorption spectrophotometry, atomic emission spectroscopy, etc.1.2 This practice is applicable in the subsequent determination of volatile, semivolatile, and nonvolatile metals of sediments.1.3 Actual metal quantitation can be accomplished by following the various test methods outlined under other appropriate ASTM standards for the metal(s) of interest. Before selecting either of the digestion techniques outlined in this practice, the user should consult the appropriate quantitation standard(s) for any special analytical considerations, and Practice D3976 for any special preparatory considerations.1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see Note 7. 1.5 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

Standard Practice for Total Digestion of Sediment Samples for Chemical Analysis of Various Metals

DIN 38402-22:1991 德国对水.废水和淤泥的统一检验方法.总则(A组).工业用冷却水取样(A22)

The standard describes the unified proceeding for the sampling, the transport and the conservation of water samples from cooling water for industrial use. The water samples serve the chemical, physical and microbiological examination of water. In the appendix is given an example for a sampling-report.

German standard methods for the examination of water, waste water and sludge; general information (group A); sampling of cooling water for industrial use (A 22)

ISO/TR 9122-2:1990 燃烧生成物毒性试验 第2部分:测试大量吸入燃烧生成物中有毒物质的生物鉴定指南(基本原理、判据和方法)

This Technical Report provides basic background information on methods suitable to define the acute inhalation toxicity of fire effluents, as generated by fire models. Contains terms and definitions.

Toxicity testing of fire effluents; part 2: guidelines for biological assays to determine the acute inhalation toxicity of fire effluents (basic principles, criteria and methodology)

ASTM E1279-89(1995) 用摇瓶衰减弱法作生物降解的试验方法

1.1 This test method describes procedures for assessing the biodegradation of chemicals in natural surface water samples.1.2 This test method provides an opportunity to evaluate rates of biodegradation in the presence and absence of natural sediment materials. It also may provide limited information on the abiotic degradation rate, and sorption to sediment and vessel walls.1.3 This test method allows for the development of a first-order rate constant, based on the disappearance of the test compound with time, and a second-order rate constant, normalized for changes in microbial biomass.1.4 This test method requires a chemical specific analytical method and the concentrations of test substance employed are dependent on the sensitivity of the analytical method.1.5 This test method is designed to be applicable to compounds that are not inhibitory to bacteria at the concentrations used in the test method, which do not rapidly volatilize from water, that are soluble at the initial test concentration and that do not degrade rapidly by abiotic processes, such as hydrolysis.1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Biodegradation By a Shake-Flask Die-Away Method

ASTM D4994-89(2009) 废水污垢中毒素的分离的标准实施规范

Although many laboratories are presently isolating viruses from sludge, a valid comparison of data generated has not been possible because of the lack of a standard test method(s).1.1 This practice is used for the recovery of viruses from wastewater sludges and favors the enteroviruses. 1.2 Both procedures are applicable to raw, digested, and dewatered sludges. Sections Procedure A—Adsorption 6 to 10 Procedure B—Sonication11 to 15 1.3 This practice was tested on standardized sludges as described in 10.1. It is the user's responsibility to ensure the validity of this practice for untested matrices. 1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 1.6 Only adequately trained personnel should be allowed to perform these procedures and should use safety precautions recommended by the U.S. Public Health Service, Center for Disease Control, for work with potentially hazardous biological organisms.

Standard Practice for Recovery of Viruses from Wastewater Sludges

ASTM D4994-89(2002) 废水污垢中毒素的分离

Although many laboratories are presently isolating viruses from sludge, a valid comparison of data generated has not been possible because of the lack of a standard test method(s).1.1 This practice is used for the recovery of viruses from wastewater sludges and favors the enteroviruses.1.2 Both procedures are applicable to raw, digested, and dewatered sludges.SectionsProcedure A-Adsorption6 to 10Procedure B-Sonication11 to 151.3 This practice was tested on standardized sludges as described in 10.1 and 17.1. It is the user's responsibility to ensure the validity of this practice for untested matrices.1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.1.4 Only adequately trained personnel should be allowed to perform these procedures and should use safety precautions recommended by the U.S. Public Health Service, Center for Disease Control, for work with potentially hazardous biological organisms.

Standard Practice for Recovery of Viruses from Wastewater Sludges

DIN 51365:1988 润滑剂的试验.使用过的发动机油的总污染物的测定.离心分离法

Testing of lubricants; determination of total dirt in used engine oils; separation by centrifuging

ASTM F873-84(2003) 在临时油田现场焚烧漏洒废油的规则

1.1 This guide addresses incineration as a means of waste disposal and specifically discusses incinerating oil spill wastes at temporary field locations.1.2 The purpose of this guide is to provide the user with general information on incineration as a means of disposal, not to define a rigid set of standards. It is intended as a reference to plan or execute disposal by incineration.1.3 This guide outlines procedures and describes some equipment that can be applied to a land-based field incineration process. Included in the guide is a description of typical oil spill wastes that can be incinerated; an outline of procedures to select, prepare, operate, and restore a temporary site; and a summary of general site safety considerations.1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary information is given in Section 7.

Standard Guide for Incinerating Oil Spill Wastes at Temporary Field Locations

ANSI PH4.38-1983 摄影(处理).废水.铁-和铁氰化物化学分析

Establishes a laboratory test method for the determination of ferro- and ferricyanide in photographic processing effluents.

Photography (Processing)-Effluents-Chemical Analysis for Ferro- and Ferricyanide

HG/T 20590-1997（条文说明） 硫酸、磷肥工业废水处理设计技术规定

Design technical regulation for the treatment of wastewater from sulphuric acid &phosphatic fertilizer industries (explanation)