Z64 流动污染源排放标准 标准查询与下载

DB34/T 1743-2012 在用汽车排气污染物限值及检测方法（遥测法）

本标准规定了遥测法实时检测在道路上行驶的在用汽车排气污染物排放限值、检测方法、数据处理和结果判定原则。 本标准适用于GB/T 15089规定的M类、N类及G类车辆（包括燃用气体燃料车辆、两用燃料车辆及双燃料车辆）。

Limits and detection methods of exhaust pollutants from in-use vehicles (telemetry method)

DB35/ 1300-2012 在用点燃式发动机轻型汽车简易瞬态工况法排气污染物排放限值

本标准规定了在用点燃式发动机轻型汽车简易瞬态工况法排气污染物排放限值。 本标准适用于装用点燃式发动机的在用轻型汽车。 本标准不适用于全时四轮驱动的轻型汽车，也不适用于路检和抽检。

Limits of Exhaust Pollutant Emissions for Light Vehicles with Ignition Engines in Simple Transient Conditions

DB35/ 1301-2012 在用压燃式发动机汽车加载减速法排气烟度排放限值

本标准规定了在用压燃式发动机汽车加载减速法排气烟度排放限值。 本标准适用于装用压燃式发动机、最大总质量大于400kg、最大设计速度大于或者等于50km/ｈ的在用汽车。 本标准不适用于紧密型多驱动轴或全时四轮驱动的车辆。

Limit value of exhaust smoke emission by loading deceleration method for compression ignition engine vehicles

ISO 23274-2:2012 混合动力道路车辆.废气排放和燃料消耗测量.第2部分:外部可充电车辆

This part of ISO 23274 specifies a chassis dynamometer test procedure to determine the end of CD (charge-depleting) state and consumed electric energy during CD state. The identification of the end of CD state is an important step for procedures to determine exhaust emissions and fuel consumption. Final determination of exhaust emissions and fuel consumption is not included in this part of ISO 23274. This part of ISO 23274 applies to vehicles with the following characteristics. — The vehicles are hybrid-electric road vehicles (HEV) with an internal combustion engine (ICE) and the on-board rechargeable energy storage system (RESS) for vehicle propulsion which is supplied by electric energy from the stationary external power source. — A CD state, in which the electric energy in RESS from the stationary external power source is consumed, is followed by a CS (charge-sustaining) state in which the fuel energy is consumed sustaining the electric energy of the RESS. — Only batteries are assumed as the RESS of a vehicle. — The RESS is not charged while driving unless by regenerative braking and/or by generating by ICE. NOTE 1 Trolleybuses and solar powered vehicles are not included in the scope. — The vehicle is classified as a passenger car or light duty truck, as defined in each regional annex. — Only liquid fuels (for example, gasoline and diesel fuel) are used. NOTE 2 In the case of vehicles with ICE using other fuel [for example, compressed natural gas (CNG), hydrogen (H2)], this part of ISO 23274 can apply except the measurement of consumed fuel; otherwise the measurement method for those using the corresponding fuel can apply.

Hybrid-electric road vehicles - Exhaust emissions and fuel consumption measurements - Part 2: Externally chargeable vehicles

DB46/ 231-2012 在用点燃式发动机汽车排气污染物排放限值（稳态工况法）

适用于使用汽油、 单一燃料和两用燃料的在用轻型汽车排气污染物检测， 但不适用于全时四轮驱动等类型汽车的排气污染物检测。

Limits of Exhaust Pollutant Emissions from In-use Ignition Engine Vehicles (Steady State Method)

DB46/ 230-2012 在用压燃式发动机汽车排气烟度排放限值（加载减速工况法）

适用于装用压燃式发动机、最大总质量大于400 kg、最大设计速度大于或者等于50km/h的在用汽车排气烟度检测。对紧密型多驱动轴车辆，双层客车、铰接客车、半挂牵引车、全挂牵引车、铰接列车和最大总质量大于10 000 kg的或车长大于12m的专用货车及全时四轮驱动车辆，可按自由加速法进行排气烟度的检测。

Exhaust Smoke Emission Limits of Compression Ignition Engine Vehicles in Use (Loading and Deceleration Condition Method)

JT/T 827-2012 营运船舶CO₂排放限值及验证方法

本标准规定了营运船舶CO排放限值的确定方法，CO排放指数的计算公式以及CO排放指数的验证方法。 本标准适用于拟投入营运市场、国内航行、以柴油机作为主推进动力、400总吨及以上的干散货船、集装箱船和油船，包括新建船舶、从国际市场购置的二手船舶、以光船租赁条件租赁的外国籍船舶，以及国内市场其他用途转为营运的船舶。集装箱和干散货两用船参照干散货船执行。

Limits and verification methods of CO emission for commercial ships

SAE J1151-2011 用气相色谱法进行甲烷测量

This SAE Recommended Practice describes instrumentation for determining the amount of methane in air and exhaust gas. This document provides a means for a batch measurement of the methane concentration in light-duty vehicle exhaust samples. Nonmethane hydrocarbon concentration can be obtained by subtracting the methane concentration from the total hydrocarbon concentration obtained by a separate measurement made in accordance with accepted practices such as SAE J1094, J254, or a current federal Test Procedure.

Methane Measurement Using Gas Chromatography

SAE J1145-2011 排放物术语和命名

This document has been declared "Stabilized" by the SAE IC Powertrain Steering Committee and will no longer be subjected to periodic reviews for currency. Users are responsible for verifying references and continued suitability of technical requirements. Newer technology may exist. This SAE Recommended Practice applies to nomenclature of emissions and emissions reduction apparatus as applied to various engines and vehicles. Modifying adjectives are omitted in some cases for the sake of simplicity. However, it is considered good practice to use such adjectives when they add to clarity and understanding. This document was prepared to standardize terminology and nomenclature in order to facilitate clearer understanding for engineering discussions, comparisons, and the preparation of technical papers.

Emissions Terminology and Nomenclature

DB36/ 618-2011 在用压燃式发动机汽车加载减速法排气烟度排放限值

Limit value of exhaust smoke emission by loading deceleration method for compression ignition engine vehicles

DB36/ 617-2011 在用点燃式发动机轻型汽车简易瞬态工况法排气污染物排放限值

Limits of Exhaust Pollutant Emissions for Light Vehicles with Ignition Engines in Simple Transient Conditions

DB34/ 1444-2011 在用点燃式发动机轻型汽车稳态工况法排气污染物排放限值

Limits for exhaust pollutant from in-use light-duty spark ignition vehicles under steady- state mode conditions

DB11/ 206-2010 储油库油气排放控制和限值

本标准规定了储油库在储存、收发汽油过程中汽油油气排放的控制要求、限值和检测方法。本标准适用于存储汽油的储油库新建、改建、扩建和现有油库油气回收改造项目的设计、验收、环境影响评价和建成后的油气排放管理。本标准对汽油发油平台的要求也适用于柴油发油平台。

Oil and gas emission control and limit value of oil depot

DB11/ 207-2010 油罐车油气排放控制和限值

本标准规定了油罐汽车（以下简称“油罐车”）在燃油运输过程中油气泄漏排放的控制要求、排放限值和检测方法。本标准适用于油罐车（包括制造厂新生产的油罐车）油气排放控制的管理。

Oil and gas emission control and limit value of oil tanker

DB11/ 208-2010 加油站油气排放控制和限值

{[4]}本标准规定了加油站汽油油气排放控制的技术要求、排放限值和检测方法。本标准适用于加油站新建、改建和扩建项目和现有加油站油气回收改造项目的设计、安装、验收、环境影响评价和建成后的汽油油气排放管理。

Oil and gas emission control and limit value of gas station

DB11/ 121-2010 在用柴油车加载减速烟度排放限值及测量方法

本标准规定了在用柴油车加载减速烟度排放的检测方法和检查项目、限值及结果判定、测量结果与数据记录要求。本标准适用于装用柴油机、最大总质量大于400kg、最大设计速度大于或等于50km/h的在用汽车。

Limit value and measurement method of smoke emission during deceleration of diesel vehicles in use

DB11/ 183-2010 在用三轮汽车和低速货车加载减速烟度排放限值及测量方法

本标准规定了在用三轮汽车和低速货车加载减速烟度排放的检测方法和检查项目、限值及结果判定、测量结果与数据记录要求。本标准适用于装用压燃式发动机、最大设计总质量不大于4500kg、最大设计速度不大于70km/h的在用三轮汽车和低速货车。

Smoke emission limits and measurement methods during deceleration of three-wheeled vehicles and low-speed trucks

DB11/ 122-2010 在用汽油车稳态加载污染物排放限值及测量方法

本标准规定了在用车稳态加载试验排气污染物排放限值、判定方法和测量方法。本标准适用于装用以汽油、液化石油气（LPG）和天然气（NG）为燃料的点燃式发动机，最大设计车速等于或大于50km/h的M类和N类在用车。

Pollutant Emission Limits and Measurement Methods for Steady-state Loading of In-use Gasoline Vehicles

HJ 553-2010 烟度卡

本标准规定了滤纸式烟度计用标准烟度卡(以下简称烟度卡)的基本性能和技术要求。该烟度卡适用于滤纸式烟度计的检定和校准。

Standard for smokemetric tablet

SAE AIR5715-2009 飞机排放物的计算规程

This AIR describes procedures for calculating emission resulting from the main engines of commercial jet and turboprop aircraft through all modes of operation for all segments of a flight. Piston engine aircraft emissions are not included in this AIR. Some information about piston engine aircraft emission can be found in FOCA 2007. The principal purpose of the procedures is to assist model developers in calculating aircraft emissions in a consistent and accurate manner that can be used to address various environmental assessments including those related to policy decision and regulatory requirements.

Procedure for the Calculation of Aircraft Emissions