共找到 150 条与 xps半 相关的标准，共 10 页
XPS extruded foam sheet production line
5.1 规格尺寸 产品主要规格尺寸见表1，其他规格由供需双方商定。 5.2 尺寸允许偏差 应符合表2的规定。 5.3 外观质量 5.3.1 SDXPS应表面平整，无夹杂物，颜色均匀。不应有影响使用的可见缺陷，如起泡、裂口、变形等。 5.3.2 GDXPS产品表面除槽口外，应表面平整，槽口
Extruded polystyrene foam(XPS) board for floor heating
本标准规定了绝热用挤塑聚苯乙烯泡沫塑料(XPS)的分类、规格、要求、试验方法、检验规则、标志、包装、运输、贮存。 本标准适用于使用温度不超过75℃的绝热用挤塑聚苯乙烯泡沫塑料，也适用于带有塑料、箔片贴面以及带有表面涂层的绝热用挤塑聚苯乙烯泡沫塑料
Rigid extruded polystyrene foam board for thermal insulation (XPS)
Rigid extruded polystyrene foam board for thermal insulation(XPS)
XPS Composite Formwork External Thermal Insulation System Technical Regulations
Extruded polystyrene foam (XPS) for geotechnical applications
Extruded polystyrene foam (XPS) for cold storage
General technical requirements for building composite insulation board (insulation layer: EPS, XPS)
本标准规定了挤塑聚苯板(XPS)薄抹灰外墙外保温系统材料的术语和定义、一般规定、要求、试验方法、检验规则、产品合格证和使用说明书、包装、运输和贮存。本标准适用于民用建筑采用的挤塑聚苯板(XPS)薄抹灰外墙外保温系统材料
External thermal insulation composite systems based on extruded polystyrene
Factory Manufactured Extruded Polystyrene Foam (XPS) Products Specification
本标准规定了公路工程用保温隔热挤塑聚苯乙烯泡沫塑料板(XPS)的分类、主要规格与尺寸、性能要求、试验方法、检验规则、标志、包装、运输、贮存等。 本标准适用于使用温度在-50℃~75℃范围内的公路工程用隔热挤塑聚苯乙烯泡沫塑料板，也适用于公路工程用带有塑料、箔贴面以及带有表面涂层的隔热挤塑聚苯乙烯
Highway engineerning.Rigid extruded polystyrene foam board for thermal insulation(XPS)
Thermal insulation products for buildings - Factory made products of extruded polystyrene foam (XPS) - Specification
XPS thermal insulation decorative composite panel exterior wall external thermal insulation engineering technical regulations
Thermal insulation products for buildings - Manufactured extruded polystyrene foam (XPS) products - Specification
Thermal insulation products for buildings - Manufactured extruded polystyrene foam (XPS) products - Specification
