F91 医用加速器 标准查询与下载

GB/T 40618-2021 回旋加速器术语

本文件规定了回旋加速器分类、物理、工程等相关的术语及定义。 本文件适用于回旋加速器，其他类型加速器也可参考使用。

Terminology for cyclotron

GB/T 39325-2020 超导回旋质子加速器辐射屏蔽规范

本标准规定了超导回旋质子加速器机房屏蔽的一般要求、剂量率参考控制水平、屏蔽计算和辐射监测等要求。 本标准适用于质子能量在 70MeV～1000MeV 范围内的超导回旋质子加速器的辐射屏蔽设计，也可用于质子能量在 70MeV～1000MeV 范围内的其他类型质子加速器的辐射屏蔽设计。

Specification for radiation shielding of superconducting proton cyclotron

GB 15213-2016 医用电子加速器 性能和试验方法

Medical electron accelerators—Functional performance characteristics and test methods

GB/T 19046-2003 医用电子加速器 验收试验和周期检验规程

本标准规定了医用电子加速器验收试验和周期检验的性能指标、试验方法、试验条件和检验周期。 本标准适用于医用电子加速器初次安装后，制造方、使用方和第三方共同进行的验收试验，以及设备正常工作中，使用方进行的周期检验。 本标准适用于医疗事业中以放射治疗为目的、能产生X一辐射和电子辐射、能量为l MeV～50 MeV的医用电子加速器。 本标准适用于配备有等中心机架的医用电子加速器，对非等中心设备的性能和试验方法亦可参照执行。

Medical electron accelerators acceptance and periodic tests

GB 15213-1994 医用电子加速器性能和试验方法

本标准规定了医用电子加速器的性能指标和试验方法。 本标准适用于医疗事业中以治疗为目的的医用电子加速器。 本标准适用于能产生X-辐射和电子辐射的医用电子加速器，其标称能量为1～50MeV，在距辐射源1m处的最大剂量率为0.001～1Gy/s，正常治疗距离（NTD）在50～200cm之间。本标准适用于配备有等中心机架的医用电子加速器，对非等中心设备的性能和试验方法可以作适当修正。 除非随机文件中有其他规定，本标准适用于在下列条件的环境中安装、使用的设备： a.温度15～35℃ b.相对湿度30％～75％ c.大气压7×104～11×10Pa（700～1100mbar） 随机文件必须说明运输和贮存的环境条件。 电源必须符合GB9706.1中第1.4b.2）项的规定。 电源必须有足够低的内阻使有载和空载的电压波动不超过±5％。 注：NTD为正常治疗距离英文名称的缩写，下文同。

Medical electron accelerators-Functional performance characteristics and test methods

DB34/T 3767-2020 超导回旋加速器 射频谐振腔技术管理要求

Superconducting Cyclotron RF Resonator Technology Management Requirements

DB34/T 3766-2020 超导回旋加速器 水冷系统技术管理要求

Technical management requirements for superconducting cyclotron water cooling system

DB34/T 3768-2020 超导回旋加速器 旋转治疗室技术管理要求

Superconducting Cyclotron Rotary Therapy Room Technical Management Requirements

DB34/T 3112-2018 超导回旋加速器 潘宁内离子源测试平台磁场测量方法

本标准规定了超导回旋加速器潘宁内离子源测试平台磁场测量方法的术语和定义、测量原理、测量条件、测量设备、测量步骤和测量报告。 本标准适用于磁场强度为 0.5T～1T，真空度为 10-4 Pa～10-2 Pa 环境下潘宁内离子源测试平台的磁场测量。

Magnetic Field Measurement Method of Superconducting Cyclotron Penning Internal Ion Source Test Platform

ISO 28057:2014 放射治疗中光子和电子辐射用固体热释光探测器的放射量测定

Dosimetry with solid thermoluminescence detectors for photon and electron radiations in radiotherapy

DIN 6847-6:2012 医用电子加速器.第6部分:电子射野影像装置(EPID).仪器性能恒定性测试

Medical electron accelerators - Part 6: Electronic portal imaging device(EPID) - Constancy testing

DIN 6847-2:2008 医疗电子加速器.第2部分:结构辐射防护的构造规则

Medical electron accelerators - Part 2: Rules for construction of structural radiation protection

JIS Z 4705:2006 医用电子设备.第2-1部分:1MeV～50MeV范围电子加速器安全性特殊要求

この個別規格は，形式試験及ぴ現地試験を含んでおり，それぞれ次に示す電子加速 装()の，製造及び設置()のある段階に適用する。

Medical electrical equipment -- Part 2-1: Particular requirements for the safety of electron accelerators in the range 1 MeV to 50 MeV

DIN 6847-2:2003 医用电子加速器.安装用辐射防护规则

The document contains rules for installation of medical electron accelerators for use of X-radiation and electron radiation in a range of 1 MeV to 50 MeV.

Medical electron accelerators - Part 2: Radiation protection rules for installation

IEC 60976/AMD1:2000 医用电气设备 医用电子加速器 功能特性 修改1

Medical electrical equipment - Medical electron accelerators - Functional performance characteristics; Amendment 1

DIN 6847-5:1998 医用电子加速器.仪器性能恒定性测试

The document describes the constancy tests of functional performance characteristics of medical electron accelerators in the range 1 MeV to 50 MeV. Simple test methods are given which indicate reliable the relevant changes of functional performance characteristics. The recommended test frequencies are comprehended in an annex.

Medical electron accelerator - Part 5: Constancy test of functional performance characteristics

IEC 60976:1989 医用电气设备 医用电子加速器 功能特性

Applies to accelerators which deliver either a X or electron radiation beam with nominal energies in the range of 1 MeV to 50 MeV at maximum absorbed dose rates between 0.001 Gys-1 and 1 Gys-1 at 1 m from the radiation source and normal treatment distanc

Medical electrical equipment; medical electron accelerators; functional performance characteristics

YY 91121-1999 医用电子加速器名词术语

Medical electron accelerators.Terminology

IEC 60601-2-1/AMD1:1984 医疗电气设备.第2部分:1-50MeV范围内医用电子加速器的特殊要求.第1节:总则.第2节:设备的辐射安全.第1次修改

INTRODUCTION This amendment to the Particular Standard specifies the particular requirements for the electrical and mechanical safety of MEDICAL ELECTRON ACCELERATORS. It forms a further section of a comprehensive standard for such accelerators of which Section One: General and Section Two: Radiation Safety for Equipment@ have already been issued as IEC Publication 601-2-1. This amendment to the Particular Standard contains new Sub-clauses 1.2@ 3.3.1@ 3.3.2@ 3.4 and 3.5 which are additions to Section One@ and a new Section Three giving the electrical and mechanical safety requirements for equipment. The clause numbering used in this amendment to the Particular Standard is a continuation of that of IEC Publication 601-2-1. This amendment to the Particular Standard complements the General Standard@ IEC Publication 601-1: Safety of Medical Electrical Equipment Part 1: General Requirements@ in respect of electrical and mechanical safety and should be used in conjunction with that standard. In order to facilitate its use in conjunction with IECpublication 601-1@ the table below describes the link between clauses of this Particular Standard and those of IEC Publication 601-l. A requirement of this Particular Standard replacing or modifying requirements of IEC Publication takes priority over the general requirements

Medical electrical equipment. Part 2 :. Particular requirements for medical electron accelerators in the range 1 MeV to 50 MeV. Section One: General. Section Tw