J99 其他动力设备 标准查询与下载



共找到 121 条与 其他动力设备 相关的标准,共 9

本标准规定了反渗透能量回收装置的分类与型号、要求、试验方法、检验规贝讹以及标志、包装、运输和贮存的要求。 本标准适用于反渗透法海水淡化、苦咸水淡化等脱盐系统的功交换式能量回收装置。

General technical specifications for energy recovery devices in reverse osmosis system

ICS
21.020;23.100.01
CCS
J99
发布
2013-12-31
实施
2014-08-01

本标准规定了轻型燃气轮机排气冒烟的测试装置和测试程序。

Light weight gas turbine exhaust smoke measurement

ICS
27.040
CCS
J99
发布
1989-06-22
实施
1989-12-01

本标准规定了轻型燃气轮机(以下简称燃气轮机)使用与维护管理的基本要求和规则。 本标准适用于发电和驱动机械用的燃气轮机动力装置,为编制燃气轮机的使用与维护实施细则提供依据。

Light weight gas turbine operation and maintenance

ICS
27.040
CCS
J99
发布
1989-06-22
实施
1989-12-01

本标准规定了连续测量轻型燃气轮机气态污染物--氮氧化物(NOx)和二氧化硫(SO2)及氧气(O2-为计算用)等浓度的测试装置和测试程序。 本标准适用于长期固定工况运行的轻型燃气轮机。对经常变工况运行的轻型燃气轮机则应采用附录A(参考件)所推荐的测量方法。

Gas emissions measurement of light weight gas turbines

ICS
27.040
CCS
J99
发布
1989-06-22
实施
1989-12-01

This document specifies safety, constructional, and performance and testing requirements for thermoelectric flame supervision controls, energized by a thermocouple, intended for use with gas burners and gas-burning appliances, hereafter referred to as “controls”. This document applies to thermoelectric flame supervision controls for gas burners and gas-burning appliances of nominal connection size up to, and including DN 50, that can be used and tested independently of these appliances. These thermoelectric flame supervision controls are suitable for fuel gases, such as natural gas, manufactured gas or liquefied petroleum gas (LPG) at inlet pressures up to and including 50 kPa. It is not applicable to corrosive and waste gases. This document covers type testing only. This document is not applicable to: a) the thermocouple; and b) controls which use auxiliary energy (e.g. electrical energy supplied externally).

Safety and control devices for gas burners and gas-burning appliances - Particular requirements - Part 6: Thermoelectric flame supervision controls

ICS
27.060.20
CCS
J99
发布
2021-11-00
实施

Atmospheric fixed bed gas generator

ICS
27.060.20
CCS
J99
发布
2021-05-17
实施
2021-10-01

This European Standard specifies the safety requirements and test methods for artificial climbing structures with protection points (hereafter referred to as ACS). This European Standard is applicable for ACS in normal use for sport climbing. This European Standard is not applicable to ice climbing, dry tooling and playground equipment.

Artificial climbing structures - Part 1: Safety requirements and test methods for ACS with protection points

ICS
97.220.10
CCS
J99
发布
2017-01
实施

This European Standard specifies the safety requirements and test methods for climbing holds. This European Standard is applicable to climbing holds, which are used for the natural progression of the climber, i.e. without the use of artificial means (e. g. ice axes, crampons, hooks, nuts) on artificial climbing structures (ACS) and bouldering walls. Climbing holds are designed to be mounted on the ACS with bolts, screws, etc. Climbing holds include large volumes or features that are designed for use without additional climbing holds being attached to them. The main fixation points for climbing holds forms part of the existing layout of the ACS and are considered in EN 12572-1 and EN 12572-2. This European Standard is not applicable to ice climbing, dry tooling and playground equipment.

Artificial climbing structures - Part 3: Safety requirements and test methods for climbing holds

ICS
97.220.10
CCS
J99
发布
2017-01
实施

This European Standard specifies the safety requirements and calculation methods for bouldering walls, including the safety zone. This European Standard is applicable when the bouldering is in normal use. This European Standard is not applicable to ice climbing, dry tooling, playground equipment and deep water soloing.

Artificial climbing structures - Part 2: Safety requirements and test methods for bouldering walls

ICS
97.220.10
CCS
J99
发布
2017-01
实施

本标准规定了在用燃油大中型客车、大型货车改装为LNG单燃料汽车、LNG-燃油两用燃料汽车和LNG-燃油双燃料汽车的术语和定义、技术要求、检验方法、检验规则、质量保证、标志、铭牌及贮存。 本标准适用于液化天然气汽车的改装。

Technical Requirements for Refitting LNG Vehicles

ICS
27.060.20
CCS
J99
发布
2016-05-18
实施
2016-06-01

本标准规定了天然气汽车改装企业的术语和定义、基本要求、改装范围、设施条件、人员条件、装备条件、组织管理条件、安全生产条件、环境保护条件。 本标准适用于四川省境内将燃油汽车改装为天然气单燃料汽车、双燃料汽车、两用燃料汽车的企业的建设、搬迁和技术改造。

Specifications for refitting enterprises of natural gas vehicles

ICS
27.060.20
CCS
J99
发布
2016-05-18
实施
2016-06-01

本规范适用于陆上油田采出水用于注汽锅炉给水处理的新建、扩建和改建工程设计。

Code for design of oilfield produced water used as steam generator feed water after treatment

ICS
75.040;23.100.99
CCS
J99
发布
2016-01-07
实施
2016-06-01

Safety and control devices for gas burners and gas-burning appliances — Particular requirements — Part 1: Automatic and semi-automatic valves

ICS
27.060.20
CCS
J99
发布
2015-10-13
实施

Heat-recovery ventilators

ICS
23.120
CCS
J99
发布
2015-07-29
实施

Temperature control devices and temperature limiters for heat generating systems; German version EN 14597:2012

ICS
17.200.20;97.120
CCS
J99
发布
2015-02
实施

Flexible shaft assembly of brush cutter

ICS
65.060.80
CCS
J99
发布
2014-12-03
实施
2014/12/3

Safety and control devices for burners and appliances burning gaseous or liquid fuels - Combustion product sensing devices; German version EN 16340:2014

ICS
27.060.20
CCS
J99
发布
2014-10
实施

Safety and control devices for oil burners and oil-burning appliances - Particular requirements - Part 1: Automatic and semi-automatic valves (ISO 23553-1:2014); German version EN ISO 23553-1:2014

ICS
27.060.10
CCS
J99
发布
2014-09
实施

Safety and control devices for gas burners and gas-burning appliances. Particular requirements. Thermoelectric flame supervision controls

ICS
27.060.20
CCS
J99
发布
2014-08-31
实施
2014-08-31

Safety and control devices for burners and appliances burning gaseous or liquid fuels. Combustion product sensing devices

ICS
27.060.20
CCS
J99
发布
2014-07-31
实施
2014-07-31



Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号