R34 船用电气、观通、导航设备维护修理 标准查询与下载

JT/T 1300-2019 北斗船用应急无线电示位标技术要求及测试方法

Beidou Marine Emergency Radio Position Indicating Beacon Technical Requirements and Test Methods

BS ISO 19891-1:2017 船舶和海洋技术 船上使用的气体探测器规范 用于封闭空间气氛测试的便携式气体探测器

Ships and marine technology. Specifications for gas detectors intended for use on board ships. Portable gas detectors for atmosphere testing of enclosed spaces

ISO 19891-1:2017 船舶与海洋技术.船上使用气体探测器规格.第1部分:检测封闭空间内大气的便携式气体探测器

This document provides specifications on performance, gases to be measured, sensitivities, indications, alarm levels, protection against shock, temperature and water ingress, and testing requirements of portable gas detectors used for atmosphere testing of enclosed spaces onboard ships prior to entry into those spaces. This document specifies suitable portable gas detectors for compliance withISOLAS regulation XI-1/7 “Atmosphere testing instrument for enclosed spaces”, and may be used for deciding whether portable gas detectors available on the market are suitable for compliance with theseISOLAS requirements. NOTE 1ISOLAS regulation XI-1/7 requires appropriate portable atmosphere testing instrument or instruments to be carried onboard ships, by 1 July 2016. TheISOLAS regulation requires, as a minimum, the appropriate portable atmosphere testing instrument or instruments to be capable of measuring concentrations of oxygen, flammable gases or vapours, hydrogen sulphide and carbon monoxide prior to entry into enclosed spaces. For the purpose of measurement of concentrations of flammable gases or vapours, this document specifies the flammable gas as either “methane” or “propane and butane”, and requires clear marking of types of flammable gases which can be measured by the portable gas detectors. Flammable vapours/gases which are not marked cannot be measured or detected by the portable gas detector. NOTE 2 Iso-butane is an alternative calibration gas of portable gas detectors in measuring propane and butane. This document does not give any indication of toxicity of the flammable gases.

Ships and marine technology - Specifications for gas detectors intended for use on board ships - Part 1: Portable gas detectors for atmosphere testing of enclosed spaces

ISO/PAS 19891-1:2016 船舶与海洋技术. 船上使用气体探测器规格. 第1部分: 检测封闭空间内大气的便携式气体探测器

Ships and marine technology - Specifications for gas detectors intended for use on board ships - Part 1: Portable gas detectors for atmosphere testing of enclosed spaces

CB/T 3435-2013 船用继电器修理要求

本标准规定了船舶电磁式继电器、热继电器及晶体管继电器的修理工艺要求。本标准适用于各种电磁式继电器、热继电器及晶体管继电器的修理、调整及验收。本标准不适用于靠机械参量直接动作的继电器。

Repairing requirement for marine relay

CB/T 3434-2013 船用自动操舵仪修理要求

本标准规定了自动操舵仪故障及修理、检测与验收等技术要求。本标准适用于保持船舶航向用的电子—液压式自动操舵仪修理,其他类型自动操舵仪修理也可参照使用。

Repairing technical requirement for the marine autopilots

BS EN 62287-1:2006 航运和无线电通信设备和系统.自动识别系统(AIS)的B级船载设备.载波监听分时多路访问(CSTDMA)技术

This part of IEC 62287 specifies the minimum operational and performance requirements, methods of testing and required test results for Class B shipborne AIS equipment using CSTDMA techniques. This standard takes into account other associated IEC International Standards and existing national standards, as applicable. It is applicable for AIS equipment used on craft that are not covered by the mandatory carriage requirement of AIS under SOLAS Chapter V. An AIS station intended to operate in receive-only mode shall not be considered a Class B shipborne mobile AIS station.

Maritime navigation and radiocommunication equipment and systems - Class B shipborne equipment of the automatic identification system (AIS) - Carrier-sense time division multiple access (CSTDMA) techniques

JT/T 8100.34-2000 船用通信导航设备的安装、使用、维护、修理技术要求 9GHz搜救雷达应答器

Technical requirement for the installation,operation,maintenance and repair of marine navigation equipment.9GHz SART

JT/T 8100.33-2000 船用通信导航设备的安装、使用、维护、修理技术要求 406MHz卫星应急无线电示位标

Technical requirement for the installation,operation,maintenance and repair of marine navigation equipment 406MHz EPIRB

CB/T 3937-1999 船用电机修理技术要求

Repairing specification of marine electrical machine

JT/T 219-1996 船用通信、导航设备安装、使用、维护、修理技术要求 全球定位系统(GPS)接收机

本标准规定了船用全球定位系统(GPS)接收机的安装、使用、维护、修理技术要求。 本标准符合JT/ T8100.1《船 用通信、导航设备的安装、使用、维护、修理技术要求 总则》所规定的适用范围。

Requirements for installation,operation,maintenance and repair of marine navigation and communications equipment Global positioning system (GPS) receiver

JT/T 220-1996 船用无线电室技术管理规则 海洋船舶

本标准规定了海洋船舶无线电室及相关无线电设备的技术管理规则。 本标准适用于悬挂中华人民共和国国旗、从事海上航行并设置无线电室的船舶。????

The Technical Management Regulations for Marine Radioroom(for ocean ships)

SC/T 8045-1994 渔船无线电通信设备 修理、安装及调试技术要求

本标准规定了渔业船舶的主收发信机、备用收发信机、超短波无线电话机、无线电话遇险频率值班接收机、应急无线电示位标的修理、安装、调试技术要求。 本标准适用于渔船及渔业辅助船的无线电通信设备技术要求。

Technical requirements for repair, installation and commissioning of radio communication equipment for fishing vessels

SC/T 8046-1994 渔船导航设备 修理、安装及调试技术要求

本标准规定了雷达、劳兰A、劳兰C、卫星导航仪修理、安装、调试的技术要求。 本标准适用于渔船及渔业辅助船的导航设备。

Technical requirements for repair, installation and commissioning of fishing vessel navigation equipment

SC/T 8044-1994 渔船电气设备修理技术要求

本标准规定了渔船主配电板、变压器、控制装置、船内通信、灯具及其附具、蓄电池、电缆的修理技术要求。 本标准适用于渔船及渔业辅助船的电气设备修理．不包括无线电设备、导航、助渔设备及其他特种设备的修理技术要求。

Technical requirements for repairing electrical equipment of fishing boats

CB/T 3578-1994 船舶修理期间接岸电技术要求

本标准规定了船舶在进厂修理期间，经船舶岸电箱接用岸电的技术要求。 本标准适用于钢质海船，其它船舶也可参照执行。

Technical requirements for shore power connection during ship repair

CB/T 3577-1994 船舶电缆修理技术要求

本标准规定了船舶电力、控制、通讯电缆的勘验、修理和检验等要求。 本标准适用于额定电压0.6～1kV及以下的船舶电缆。

Technical requirements for ship cable repair

CB/T 3575-1994 船舶配电箱修理技术要求

本标准规定了船舶交、直流配电箱的勘验，修理技术要求和检验。 本标准适用于船舶交流50 Hz(或60 Hz)1000V、直流1200V及以下的照明和动力配电箱的修理。

Technical Requirements for Ship Distribution Box Repair

CB/T 3574-1994 船舶配电板修理技术要求

本标准规定了船舶交、直流低压配电板的勘验、修理技术要求及检验。 本标准适用于船舶三相交流50 Hz(或60 Hz)、1000 V或直流1200 V及以下的主配电板、应急配电板、区配电板的修理。

Technical requirements for ship switchboard repair

CB/T 3573-1994 船舶电磁起动器修理技术要求

本标准规定了船舶电磁起动器的勘验、修理技术要求及检验。 本标准适用于船舶交流50Hz(或60 Hz)1000 V、直流1200 v及以下的电动机电磁起动器的修理，亦适用于组合电磁起动屏。

Repair Technical Requirements for Ship Electromagnetic Starter