T28 车前板金零件 标准查询与下载

QC/T 947-2013 汽车自动防眩目后视镜技术条件

本标准规定了汽车自动防眩目后视镜的术语、定义、要求、试验方法、检验规则、标志、包装、运输和存储。本标准适用于安装在M类和N类汽车上的自动防眩目后视镜。

Technology standards of auto-dimming rearview mirror for motor vehicle

QC/T 905-2013 汽车防护杠

本标准规定了汽车防护杠的术语和定义、类别、要求、试验方法、检验规则及标志、包装、运输和储存。本标准适用于汽车防护用的前、后、侧杠(以下简称“防护杠”)。

Protecting facility for automotive

SAE J686-2012 机动车牌照板

This document has been declared "Stabilized" and will no longer be subjected to periodic reviews for currency. Users are responsible for verifying references and continued suitability or technical requirements. New technology may exist. This SAE Standard establishes basic dimensions for motor vehicle license plates. It is based on data supplied by the American Association of Motor Vehicle Administrators, Motor vehicle Manufacturers Association, and Motorcycle, Scooter and allied Trades Association. The dimensions established in this standard have considered legibility and identification of the license plate. This standard is intended to facilitate attachment of license plates to motor vehicles by providing uniform overall dimensions, bolt hole sizes and spacing, and recommended beading practice.

Motor Vehicle License Plates (Stabilized Type)

SAE J1944-2000 卡车和公共汽车多功能车辆挡风玻璃喷洗器系统

This SAE Recommended Practice provides the following for the windshield washer system for trucks, buses, and multipurpose vehicles with GVW of 4500 kg (10 000 lb) or greater: a.) Minimum performance requirement; b.) Uniform test procedures. The test procedures are limited to those tests that can be conducted with uniform test equipment by commercially available laboratory facilities; and c.) Uniform terminology of windshield washer system characteristics and phenomena. the minimum performance requirements and test procedures, outlined in this document, are based on currently available engineering data. It is intended that all portions of the document will be periodically reviewed and revised as additional data on windshield washer system performance are developed.

Truck and Bus Multipurpose Vehicle Windshield Washer System

SAE J686-1999 机动车牌照板

This SAE Standard establishes basic dimensions for motor vehicle license plates. It is based on data supplied by the American Association of Motor Vehicle Administrators, Motor vehicle Manufacturers Association, and Motorcycle, Scooter and allied Trades Association. The dimensions established in this standard have considered legibility and identification of the license plate. This standard is intended to facilitate attachment of license plates to motor vehicles by providing uniform overall dimensions, bolt hole sizes and spacing, and recommended beading practice.

Motor Vehicle License Plates

QC/T 487-1999 汽车保险杠的位置尺寸

本标准适用于载货汽车、轿车和乘员在17人以下的小型客车。

Position size of car bumper