U99 造船用其他设备 标准查询与下载

GB/T 40074-2021 饱和潜水系统通用要求

本标准规定了饱和潜水系统的分类和组成、技术要求、检验规则及标志、包装、运输和储存。本标准适用于饱和潜水系统设计、建造和验收。

General requirements for saturation diving system

GB/T 35371-2017 载人潜水器供氧及二氧化碳吸收设计要求

Oxygen supplying and carbon dioxide absorbing for human occupied vehicles

GB/T 35370-2017 潜水呼吸器检测方法

Testing methods for self-contained underwater breathing apparatus(SCUBA)

KS V 0925-2012 船用机油滤清器

이 표준은 선박용 유수 분리기의 성능 시험에 대하여 규정한다.

Oil filtering equipment for marine use

KS V 0924-2012 流水分界面探测器

이 표준은 선박용 유수 경계면 검출기의 성능 시험과 관련된 내용에 대하여 규정한다.

Oil-water interface detector

KS V 0926-2012 油料流出监控和控制系统

이 표준은 선박용 기름 배출 감시 제어 장치의 감시 기록 장치에 관한 성능 시험과 관련된

Oil discharge monitoring and control system for marine use

KS V 0923-2012 馏分浓度计和舱底污水容量警报装置

이 표준은 선박용 유분 농도계 및 선저 폐수 농도 경보 장치의 성능 시험과 관련된 내용에

Oil concentration meter and bilge wastewater concentration alarm device

KS V 3984-2012 挖泥船用船外排放管道漂浮物

이 표준은 주로 준설선용 선외 매송관로의 해상관에 사용하는 배송관 띄우개(이하 띄우개라 한

Floaters of discharge pipes for dredger

KS V 3987-2012 船舶用救生衣

이 표준은 선박용 구명동의(이하 동의라 한다.)에 대하여 규정한다.

Lifejacket for marine use

KS V 3982-2012 挖泥船用普通绳轮

이 표준은 준설선용 일반 시브에 대하여 규정한다.

Dredger’s sheaves for general use

KS V 3989-2012 船用消防水管喷嘴

이 표준은 선박용 소방 호스나 이동 가능 소화전 또는 소방 호스용 연결 금속구에 연결되어

Water nozzles of fire hose for marine use

KS V 3988-2012 船舶用救生圈

이 표준은 선박용 구명 부환(이하 부환이라 한다.)에 대하여 규정한다.

Lifebuoy for marine use

CB/T 8523-2011 机械化滑道设计规范

本规范规定了修造船厂中船舶上墩、下水的机械化滑道的工艺、主要配套设备及电气设计的要求。 本规范适用于新建船舶下水重量为3000t以下的滑道及配套设备设计。对新建、改造和扩建的船舶下水重量为3000t以上，5000t以下的滑道设计，经论证后可参照使用。

Code for design of mechanical slipway

CB/T 8522-2011 舾装码头设计规范

本标准规定了舾装码头工艺设计、结构设计、给排水设计、供电和照明设计、动力设计、环境保护和职业卫生设计等要求。 本标准适用于船舶行业新建固定式舾装码头的工程设计。扩建、改建的舾装码头以及修船码头的工程设计可参照使用。

Code of design for fitting-out quay

CB/T 8504-2011 船厂门座起重机技术规定

本标准规定了船厂门座起重机的分类、要求、试验方法、检验规则及包装运输等。 本标准适用于船厂安装类型的门座起重机及类似的其他工程建设用的起重机的设计、制造、试验和验收。

Technical specification of portal cranes for shipyards

NAVY QPL-24712-3 ADMIN NOTICE 3-2007 粉末涂料(米制)

This list has been prepared for use by or for the Government in the acquisition of products covered by the subject specification and such listing of a product is not intended

COATINGS, POWDER (METRIC)

NAVY QPL-24596-19-2006 防火涂层化合物(米制)

This list has been prepared for use by orfor the Government in the acquisition of products covered by the subject specification and such listing of a productis not intended to and does not connote endorsement of the product by the Department of Defense. All products listed herein have been qualified under the requirements for the product as specified in the latest effective issue of the applicable specification. This list is subject to change without notice revision or amendment of this list will be issued as necessary. The listing of a product does not release the contractor from compliance with the specification requirements.

COATING COMPOUNDS, NONFLAMING, FIRE PROTECTIVE (METRIC)

NAVY QPL-24728-7-2006 度量光纤互连箱的一般规格

This list has been prepared for use by or for the Government in the acquisition of products covered by MIL-I-24728. Listing of a product is not intended to and does not connote endorsement of the product by the Department of Defense. All products listed herein have been qualified under the requirements for the product as specified in the latest effective issue of the applicable specification.

INTERCONNECTION BOX, FIBER OPTIC, METRIC, GENERAL SPECIFICATION FOR

CB/T 8520-2005 船厂卷扬式垂直升船机设汁规范

本标准规定了船厂卷扬式垂直升船机（以下简称升船机）主要参数的确定方法、计算载荷的种类、安全保护装置、机构和结构设计的安全系数、电气控制设计要求及升船机对建设地址自然条件的要求和升船机的总体布置形式。 本规范适用于提升载重量不大于15000t船舶的设计。提升载重量大于15000t船舶的升船机的设计可参照使用。

Code of design for vertical hoisting shiplift of shipyard

NAVY QPL-24508-16-2005 多用途高性能润滑脂(米制)

endorsement of the product by the Department of Defense. All products listed herein have been qualified under the requirements for the

GREASE, HIGH PERFORMANCE, MULTI-PURPOSE (METRIC)