X86 烟草加工 标准查询与下载

DB53/T 1191-2023 烤烟 配方打叶模块加工评价要求

Processing evaluation requirements for flue-cured tobacco formula leaf breaking module

DIN ISO 13276:2021 烟草和烟草制品. 烟碱纯度的测定. 使用钨硅酸的重量分析法(ISO 13276-2020)

This document specifies a method for the gravimetric determination of the purity of nicotine using tungstosilicic acid. The method is applicable to pure nicotine or nicotine salts used to calibrate analytical methods for the determination of nicotine in the field of tobacco, toba

Tobacco and tobacco products - Determination of nicotine purity - Gravimetric method using tungstosilicic acid (ISO 13276:2020)

YC/T 584-2019 再造烟叶工艺规范

Technical specifications for reconstituted tobacco leaves

YC/Z 575-2018 打叶复烤 初烤烟选叶指南

Guide to leaf selection for threshed, re-cured and first-cured tobacco

YC/T 574-2018 打叶复烤 原烟接收入库规范

Specifications for receipt and storage of threshed and re-cured raw tobacco

YC/Z 576-2018 打叶复烤 分类加工技术指南

Technical guide for classification and processing of threshed and re-roasted leaves

EN 16789:2016 环境空气监测与高等植物的烟草暴露的方法标准化

This European Standard applies to the determination of the impact of ground-level ozone on a bioindicator plant species (tobacco Nicotiana tabacum cultivars Bel-W3, Bel-B and Bel-C) in a given environment. The present document specifies the procedure for setting-up and use of a system designed to expose these plants to ambient air. It also describes the procedure for leaf injury assessment. Leaf injury caused by ozone appears in the form of necrosis or accelerated aging (senescence) on the leaves of the bioindicator. The macroscopically detectable leaf injury is used as the effect measure (see pictures in Annex A). The measure is the percentage of dead leaf area on the entire leaf surface. The results of the standardized tobacco exposure indicate ozone-caused injury of the exposed bioindicators and thus enable a spatial and temporal distribution of the impact of ozone on plants to be determined. This Standard applies to the outside atmosphere in all environments. This standard does not apply to the assessment of air quality inside buildings. The method described in this European Standard does not replace modelling or physico-chemical methods of direct measurement of air pollutants, it complements them by demonstrating the biological effect.

Ambient air - Biomonitoring with Higher Plants - Method of the standardized tobacco exposure

BS PD ISO/TR 19478-1:2014 ISO和加拿大卫生部的强烈吸烟参数. 国际机器吸烟研究结果

ISO and Health Canada intense smoking parameters. Results of an international machine smoking study

DB53/T 644-2014 烟叶 抗张强度的测定 恒速拉伸法

本标准规定了烟叶抗张强度恒速拉伸法的测定原理、仪器、检测环境、样品要求、操作步骤、结果计算、检测报告内容的方法。 本标准适用于烤烟烟叶抗张强度的测定。

Determination of Tensile Strength of Tobacco Leaf by Constant Speed Tensile Method

DB53/T 643-2014 烟叶分选质量检验规程

本标准规定了烟叶分选质量检验的术语和定义、仪器、抽样、烟叶外观质量检验及非烟物质的检验、判定、样品的处置及记录。 本标准适用于打叶复烤企业对烤烟、白肋烟烟叶分选的质量检验。

Tobacco Leaf Sorting Quality Inspection Regulations

DB53/T 642-2014 烤烟配方打叶技术规范

本标准规定了配方打叶的术语和定义、试验仪器和设备、基本工艺过程和主要技术要求。 本标准适用于以初烤烟叶为原料的配方打叶生产加工。

Technical specification for flue-cured tobacco formula leaf threshing

YC/T 498-2014 再造烟叶(造纸法)感官评价方法

本标准规定了卷烟用再造烟叶(造纸法)感官评价的术语和定义、要求、评价方法及评价规则。本标准适用于造纸法再造烟叶的感官评价分析。辊压法和稠浆法再造烟叶可参照使用。

The evaluation methods of sensory quality for reconstituted tobacco(paper-process)

YC/T 16-2014 再造烟叶

本标准规定了再造烟叶的术语和定义、要求、抽样、测定方法、质量判定、标志、包装、运输、贮存与养护。本标准适用于再造烟叶。

Reconstituted tobacco

DB43/T 861-2014 新型无机非金属加热设备密集烤房

New Inorganic Non-metallic Heating Equipment Intensive Baking Room

KS H ISO 20193:2013 香烟及香烟制品.生切烟丝的宽度测定

이 표준은 각초의 각폭 측정에 대한 방법을 규정한다. 이 방법은 각폭이 균일한 경우에만 적용할 수있다.

Tobacco and tobacco products-Determination of the width of the strands of cut tobacco

KS H ISO 15592-3:2013 细切烟丝和其烟气物质.取样、调节和分析的方法.第3部分:日常分析用自动吸烟装置使用的细切烟丝制品总粒子相物的测定.水分及尼古丁测定的试料调剂和尼古丁除外的干燥粒子相物的计算

이 표준은 일상 분석용 자동흡연장치를 사용하여 흡연용 각초제품으로부터 생성되고 포집된 연기의총 입자상물질 측정방법과 이어지는 니코틴을 제외한 건조 입자상물질의 측정을 위한 시료조제방법을 규정한다.이 표준은 알려지지 않은 권지를 사용하여 만든 흡연용 각초제품과 표준권지를 사용하여 만든 흡연용 각초제품을 비교하여 알려지지 않은 권지를 분류하는 방법을 규정한다.이 표준은 첨부된 필터가 있거나 없는 경우 모두 규정된 권지를 사용하여 흡연용 각초제품을 만드는방법과 부착되지 않은 필터와 권지 내부로 삽입된 각초를 사용하여 만들어진 흡연용 각초제품의 연기 생성량을 측정하는 방법을 규정한다.

Fine-cut tobacco and smoking articles made from it-Methods of sampling, conditioning and analysis-Part 3:Determination of total particulate matter of smoking articles using a routine analytical smoking machine, preparation for the determination of water a

KS H ISO 15592-1:2013 细切烟丝和其烟气物质.取样、调节和分析的方法.第1部分:取样

이 표준은 흡연용 제품을 만들고 판매하기 위해 제조된 각초 모집단의 두 가지 시료채취 방법을 규정한다.이 표준은 제품이 규정된 절차에 따라 채취될 때, 특히 흡연용 제품이 채취된 각초로 만들어지고 니코틴을 제외한 건조 입자상물질(NFDPM)을 측정하기 위해 흡연될 때 순차적 순서의 실제경험을 바탕으로 한 가이드라인과 데이터의 통계적 처리에 대한 정보를 제공한다.

Fine-cut tobacco and smoking articles made from it－Methods of sampling, conditioning and analysis－Part 1：Sampling

KS H ISO 15592-2:2013 细切烟丝和其烟气物质.取样、调节和分析的方法.第2部分:调节和测定的大气环境

이 표준은 각초시료와 이로부터 만들어진 시험편의 조화 및 시험을 위한 환경조건을 규정한다.이 표준은 각초와 제품 그리고 사전에 조화가 필요한 흡연용 각초제품 제조에 사용되는 재료품의 시험에 적용될 수 있다. 이 표준은 특별한 시험조건을 갖는 시험방법의 경우(예를 들면 KS M ISO 187에 주어진 궐련지와 판지 또는 KS H ISO 3402에 주어진 다른 담배제품)에는 적용되지 않는다.

Fine-cut tobacco and smoking articles made from it-Methods of sampling, conditioning and analysis-Part 2:Atmosphere for conditioning and testing

CFR 27-41.85-2013 酒精,烟草和枪支. 第41部分:烟草制品的进口,过滤嘴香烟和烟草半成品. 第41.85节:海关扣押的烟草产品及半成品的释放.

(a) General. This section applies only to tobacco products and cigarette papers and tubes that are not put up into packages in which they will be sold to consumers. Subject to the requirements of § 41.86, the Port Director of Customs or authorized customs officer may release the following articles from customs custody without payment of internal revenue tax under the internal revenue bond of the manufacturer or export warehouse proprietor to whom the articles are released:

Alcohol,tobacco products and firearms. Part41:Importation of tobacco products, cigarette papers and tubes, and processed tobacco. Section41.85:Release from customs custody of imported tobacco products or cigarette papers or tubes.

CFR 27-41.85a-2013 酒精,烟草和枪支. 第41部分:烟草制品的进口,过滤嘴香烟和烟草半成品. 第41.85a节:海关扣押返还物的放行.

(a) Domestically manufactured tobacco products (classifiable under item 9801.00.80 of the Harmonized Tariff Schedule of the United States, 19 U.S.C. 1202) exported from and returned to the United States without change to the product or the shipping container may be released from customs custody in the United States, under the bond of the original manufacturer or of the export warehouse proprietor who has been authorized by the original manufacturer (see § 41.82), without payment of that part of the duty attributable to internal revenue tax, for delivery to the bonded premises of the original tobacco products manufacturer or to the bonded premises of the export warehouse proprietor.

Alcohol,tobacco products and firearms. Part41:Importation of tobacco products, cigarette papers and tubes, and processed tobacco. Section41.85a:Release from customs custody of returned articles.