K13;C80 标准查询与下载

DIN EN 50399:2012 着火条件下电缆的通用试验方法.火焰蔓延试验中测量热释放量和冒烟量.实验仪器,程序,结果.德文版本 EN 50399-2011

Common test methods for cables under fire conditions - Heat release and smoke production measurement on cables during flame spread test - Test apparatus, procedures, results; German version EN 50399:2011

DIN EN 60332-3-10:2010 着火情况下的电气和光缆试验.第3-10部分:垂直安装的捆绑线或电缆的垂直燃烧扩散试验.设备(IEC 60332-3-10-2000 + A1-2008).德文版本EN 60332-3-10-2009

Tests on electric and optical fibre cables under fire conditions - Part 3-10: Test for vertical flame spread of vertically-mounted bunched wires or cables - Apparatus (IEC 60332-3-10:2000 + A1:2008); German version EN 60332-3-10:2009

DIN EN 60332-3-25:2010 着火情况下的电气和光缆试验.第3-25部分:垂直安装的成束电线或电缆的垂直火焰传播测试.D类(IEC 60332-3-25-2000 + A1-2008).德文版本EN 60332-3-25-2009

Tests on electric and optical fibre cables under fire conditions - Part 3-25: Test for vertical flame spread of vertically-mounted bunched wires or cables - Category D (IEC 60332-3-25:2000 + A1:2008); German version EN 60332-3-25:2009

DIN EN 60332-3-21:2010 着火情况下的电气和光缆试验.第3-21部分:垂直安装的成束电线或电缆的垂直火焰蔓延的试验.A类F/R(IEC 60332-3-21:2000,修订本).德文版本EN 60332-3-21-2009

Tests on electric and optical fibre cables under fire conditions - Part 3-21: Test for vertical flame spread of vertically-mounted bunched wires or cables - Category A F/R (IEC 60332-3-21:2000, modified); German version EN 60332-3-21:2009

ANSI/IEEE 1202:2006 电线和电缆的火焰传播测试用标准

Establishes a test protocol and performance criteria to determine the flame propagation tendency of cables in a vertical cable tray.

Standard for Flame-Propagation Testing of Wire & Cable

IEC 61034-2:2005/COR1:2006 在规定条件下电缆燃烧烟密度的测量.第2部分:试验程序和要求.勘误1

This standard is about Measurement of smoke density of cables burning under defined conditions - Part 2: Test procedure and requirements; Corrigendum 1

Measurement of smoke density of cables burning under defined conditions - Part 2: Test procedure and requirements; Corrigendum 1

BS EN 50267-2-3:1999 燃烧情况下电缆的一般检验方法.电缆材料燃烧时产生的气体的试验.程序.通过测量Ph值和传导率的加权平均值测定电缆燃烧产生的气体的酸度

Specifies the test method and procedure for the determination of the degree of acidity of gases evolved during the combustion of electrical or optical cables by determination of the weighted average of pH and conductivity of the constituent materials.

Common test methods for cables under fire conditions - Tests on gases evolved during combustion of materials from cables - Procedures - Determination of degree of acidity of gases for cables by determination of the weighted average of pH and conductivity

BS EN 50267-2-1:1999 燃烧情况下电缆的一般检验方法.电缆材料燃烧时产生的气体的试验.程序.卤氢酸气体含量的测定

Specifies the procedure for the determination of the amount of halogen acid gas, other than hydroflouric acid, evolved during the combustion of compounds based on halogenated polymers, and compounds containing halogenated additives, taken from cable constructions.

Common test methods for cables under fire conditions - Tests on gases evolved during combustion of materials from cables - Procedures - Determination of the amount of halogen acid gas - Determination of the amount of halogen acid gas

BS EN 50267-2-2:1999 燃烧情况下电缆的通用试验方法.电缆材料燃烧时产生的气体的试验.程序.通过测量Ph值和传导性测定材料燃烧产生的气体的酸度

Specifies the test method and procedure for the determination of the degree of acidity of gases evolved during the combustion of materials taken from electric or optical cables by measuring pH and conductivity.

Common test methods for cables under fire conditions - Tests on gases evolved during combustion of materials from cables - Procedures - Determination of degree of acidity of gases for materials by measuring pH and conductivity - Determination of degree of

BS EN 50267-1:1999 失火情况下电缆的一般检验方法.电缆材料燃烧时产生的气体的检验.仪器

Specifies apparatus suitable for use with procedures for the quantitative determination of gases, especially acidic and corrosive gases, evolved when non-metallic materials taken from cables are subject to combustion.

Common test methods for cables under fire conditions - Tests on gases evolved during combustion of materials from cables - Apparatus

DIN EN 50267-2-2:1999 电缆通用着火试验方法.检测电缆燃烧时所产生的气体.第2-2部分:试验方法.通过测定Ph值和传导率确定电缆燃烧产生的气体的酸度

Common test methods for cables under fire conditions - Tests on gases evolved during combustion of material from cables - Part 2-2: Procedures; determination of degree of acidity of gases for materials by measuring pH and conductivity; German version EN 5