共找到 120 条与 相关的标准,共 8 页
本标准规定了显示管用防眩玻屏的主要技术指标及测试方法。 本标准适用于经过机械或化学处理后形成漫反射面的显示管用防眩玻屏。
Technical requirement and test method for the non-glare display glass tube
本标准规定了掺钕钇铝石榴石(简称Nd:YAG)激光棒的尺寸及尺寸系列。 本标准适用于Nd:YAG激光棒的直径、长度及直径与长度尺寸的组合,也可供其他掺杂钇铝石榴石激光棒参考。
Dimension series for neodymium-doped yttrium aluminum garnet laser rods
本标准规定了声表面波、体波器件用压电晶体性能测试常用名词术语的定义及符号,适用于压电晶体性能测试。
Terms for the measurements of the properties of the piezoelectric crystals
本标准规定了铌酸锂、钽酸锂等3m点群压电晶体的弹性、压电、介电常数和机电耦合系数的测试,适用于铌酸锂、钽酸锂等3m点群压电晶体。
Test methods for electroelastic constants of piezoelectric crystals
本标准规定了用波长为632.8nm的光波,沿铌酸锂、磷酸二氢钾和磷酸二氘钾晶体光轴方向消光比的测量方法。 本方法适用于测量100000:1的消光比。
Test method for extinction ratio of LN,kDP and kD*P electrooptic crystal
本标准适用于压电陶瓷材料纵向压电应变常数d的准静态测试。
Test methods for the properties of piezoelectric ceramics--Quasi-static test for piezoelectric strain constant d33
本标准适用于-65~十85℃温度范围内测试压电陶瓷材料的相对自由介电常数ε和ε的温度特性。*** **@@@@@1131100.TXT GB 11311-89 本标准适用于压电陶瓷材料泊松比σ的测试。
Test methods for the properties of piezoelectric ceramics--Test methods for temperature characteristics of relative free dielectric constants
本标准规定了在波长1.06μm的标准激光腔内测量掺钕钇铝石榴石激光棒连续激光阈值、斜率效率和输出功率的方法。
Test method for continuous lasing threshold,slope efficiency and output power of Nd:YAG laser rods
本方法适用于长方体和薄片锑化铟单晶样品的电阻率和霍耳系数的测量。 本方法所采用的样品是从锑化铟单晶中切割制备的,在特定位置上施加电极接触,用直流方法测量样品的电阻率和霍耳系数,而后计算该样品的载流子浓度和载流子迁移率。 本方法适用于电阻率10~10Ω·cm的锑化铟单晶样品。
Test method for resistivity and Hall coefficient in InSb single crystals
本方法采用硝酸-氢氟酸腐蚀剂腐蚀,适用于锑化铟原始晶片(111)铟面a位错的显示和测定。测量面偏离(111)面应不大于3°。
Standard method for showing and measuring dislocation etch pits in Indium Antimonide single crystal
本标准适用于波长为632.8nm的光波能透过的所有激光晶体棒。测量平面波前透过激光棒后,波前畸变的最大峰-谷值偏差,用以检测棒折射率的不均匀性。被测量波前畸变范围是1/20~1个波长。
Test method for wavefront distortion of laser rods
本标准适用于测试钽酸锂和三甘氨酸硫酸盐族热释电晶体材料的居里温度Tc,也适用于测试其它类似晶体材料的居里温度。
Test method for Curie temperature of pyroelectric materials
本标准适用于热释电材料低频介电常数的测量。
Test method for the dielectric constant of pyroelectric materials
本标准适用于热释电材料介质损耗角正切tanδ的测量。
Test method for dielectric tangent of loss angle of pyroelectric material
本标准规定了测量波长为632.8nm的线偏振光通过掺钕钇铝石榴石激光棒后,被退化成椭圆偏振光的退偏度的测量,并以此计量棒的消光比。
Test method for extinction ratio of Nd:YAG laser rods
本标准适用于测量三甘氨酸硫酸盐族和钽酸锂热释电单晶材料的热释电系数。本方法也适用于热释电系数在1×10C/(cm·℃)数量级以上其他单晶、陶瓷和有机热释电材料等热释电系数的测量。
Test method for pyroelectric coefficient of pyroelectric materials
本标准规定了固体激光材料常用名词术语的定义。 本标准适用于固体激光材料。 本标准不包括半导体激光材料。
The terms and definitions of solid-state laser material
本标准规定了测量波长为632.8nm的光波透过激光棒时,遇到棒内折射率不均匀和散射颗粒而产生的侧向散射光强的测量和计算方法。
Test method for side direction scattering coefficient of laser rods
本标准适用于激光晶体棒的命名。
The rule of designation for laser crystal rods
本标准规定了红外探测器用化合物半导体材料、热释电材料的型号命名方法。
Designations for types of infrared detecting materials
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号