13.220.50;91.140.30 标准查询与下载

DIN EN 1366-10:2017 服务设施的防火试验.第10部分:排烟防火阀;德文版本EN 1366-10-2011+A1-2017

Fire resistance tests for service installations - Part 10: Smoke control dampers; German version EN 1366-10:2011+A1:2017

EN 1366-10:2011+A1:2017 服务设施的防火试验-第10部分:排烟控制阀

This European Standard specifies test methods for smoke control dampers to assess their performance under elevated temperature or fire conditions. It needs to be noted that the smoke control damper to be tested may require testing to EN 1366- 2 and that this needs to be considered before carrying out these tests. Smoke control damper tests are required to confirm that the furnace testing requirements of EN 12101-8 are met and EN 12101-8 needs to be considered before carrying out these tests. Smoke control dampers tested to this European Standard should be classified using EN 13501-4 and this European Standard needs to be considered before carrying out these tests. To this end this European Standard needs to be read in conjunction with EN 12101-8, EN 13501-4, EN 1366-2 and EN 1363-1, the latter giving further details for fire resistance testing. For installation details the requirements for smoke extraction ducts need to be considered and these are defined in EN 1366-8 and EN 1366-9.

Fire resistance tests for service installations - Part 10: Smoke control dampers

ISO 6944-1:2008/Amd 1:2015 防火系统.建筑结构的构件.第1部分:通风管道.修改件1

Fire containment - Elements of building construction - Part 1: Ventilation ducts; Amendment 1

ASTM E2816-15 防火金属采暖通风与空调管道系统的标准试验方法

5.1 These test methods are intended to evaluate the ability of the HVAC duct system and its supporting construction to do the following: 5.1.1 Resist the effects of a standardized fire exposure, and 5.1.2 Retain its integrity. 5.2 These test methods provide for the following measurements and evaluations where applicable: 5.2.1 Ability of the fire-resistive material to resist flaming (combustion) when exposed to 1382°F (750°C). 5.2.2 Ability of the tested support system to carry the load of the HVAC duct and its fire-resistive material(s) during a standardized fire-engulfment test. 5.2.3 Ability of the firestops to meet the requirements of Test Method E814 when used as part of a HVAC duct system. 5.2.4 Ability of the HVAC duct system to resist the passage of flames and hot gases onto its unexposed surface during a standardized fire-resistance test. 5.2.5 Transmission of heat through the HVAC duct system during a standardized fire-resistance test. 5.2.6 Ability of the firestop to resist the passage of water during a standardized hose stream test. 5.2.7 Comparative measurement of temperature aging of the fire-resistive material(s) when subjected to a standardized thermal cycling during the durability test. 5.2.8 Measurement of flame spread over the surface of the fire-resistive material or HVAC duct system. 5.2.9 Ability of the covering and lining to resist flaming, glowing, smoldering or smoking while in service. 5.3 These test methods do not provide the following: 5.3.1 Full information as to performance of the fire-resistive material, supporting construction, or the HVAC duct system constructed with components, densities, or dimensions other than those tested. 5.3.2 Evaluation of the degree by which the fire-resistive material or HVAC duct system contributes to the fire hazard by generation of toxic gases, or other products of combustion. 5.3.3 Measurement of the degree of control or limitation of the passage of smoke or products of combustion through the HVAC duct system. 5.4 The test specimens are subjected to one or more specific tests ......

Standard Test Methods for Fire Resistive Metallic HVAC Duct Systems

KS F 2840-2014 防火阀的耐火测试

이 표준은 공조 설비에 설치되어 화재 시 방화 구획을 관통하는 공조 설비를 통한 화재의 확산을 방지하는 방화 댐퍼의 내화 시험방법에 대하여 규정한다.

Fire resistance tests for fire dampers

ISO 10294-1:1996/Amd 1:2014 耐火试验 用于空气调节系统的防火阀 第1部分:试验方法;修改件1

Fire resistance tests - Fire dampers for air distribution systems - Part 1: Test method; Amendment 1

DIN EN 1366-1:2014 服务设施的耐火试验. 第1部分: 通风管道; 德文版本EN 1366-1-2014

Fire resistance tests for service installations - Part 1: Ventilation ducts; German version EN 1366-1:2014

DIN EN 1366-12:2014 服务设施的耐火试验. 第12部分: 通风管道系统的非机械防火隔板; 德文版本EN 1366-12-2014

Fire resistance tests for service installations - Part 12: Non-mechanical fire barrier for ventilation ductwork; German version EN 1366-12:2014

ANSI/ASTM E2816:2013 抗燃金属暖通空调(HVAC)输送管系统的试验方法

Test Methods for Fire Resistive Metallic HVAC Duct Systems

ANSI/ASTM E2816a:2013 防火金属暖通和空调(HVAC)风道系统试验方法

Test Methods for Fire Resistive Metallic HVAC Duct Systems

SS 333-2012 防火阀规范

This Singapore Standard specifies requirements for the materials, design, manufacture, performance, testing, marking, inspection and maintenance of fire dampers which may be of rectangular or circular face, of single or multi-blade construction, and having hinged, pivoted or curtain type action.

Specification for fire dampers

NF P92-530-1:2012 服务装置用耐火性试验结果的扩展应用 - 第1部分: 管道.

Extended application of results from fire resistance tests for service installations - Part 1 : ducts.

DS/EN 15882-1:2012 服务设施耐火试验结果的扩展应用 第1部分：管道

This European Standard identifies parameters that affect the fire resistance of ducts for ventilation purposes. It also identifies the factors that need to be considered when deciding whether, or by how much a parameter can be extended either positively or negatively when contemplating the fire resistance on an untested variation in the construction. This European Standard, where applicable, gives guidance on additional tests that are needed to extend the field of application.The European Standard gives the principles behind how a conclusion on the influence of specific parameters/constructional details relating to the relevant criteria (E, I, S) can be ach

Extended application of results from fire resistance tests for service installations - Part 1: Ducts

DIN EN 15882-1:2012 服务设备的耐火试验的结果的扩展应用.第1部分:导管.德文版本 EN 15882-1-2011

Extended application of results from fire resistance tests for service installations - Part 1: Ducts; German version EN 15882-1:2011

BS EN 15882-1:2011 用于装置耐火性试验结果的扩展应用.管道

Extended application of results from fire resistance tests for service installations. Ducts

EN 15882-1:2011 服务设备的耐火试验的结果的扩展应用.第1部分:导管.

This European Standard identifies parameters that affect the fire resistance of ducts for ventilation purposes. It also identifies the factors that need to be considered when deciding whether, or by how much a parameter can be extended either positively or negatively when contemplating the fire resistance on an untested variation in the construction.This European Standard, where applicable, gives guidance on additional tests that are needed to extend the field of application. The European Standard gives the principles behind how a conclusion on the influence of specific parameters/constructional details relating to the relevant criteria (E, I, S) can be achieved.This European Standard only applies to ducts tested to EN 1366-1. Duct sections for use other than in fire resisting heating, ventilation and air conditioning (HVAC) systems are not covered byThis European Standard. It does not cover ducts used for smoke control which are tested in accordance with EN 1366-8 or EN 1366-9.

Extended application of results from fire resistance tests for service installations - Part 1: Ducts

DS/ISO 6944-2:2009 防火围堵 建筑结构要素 第2部分：厨房抽气管道

This International Standard establishes a method of test where kitchen extract ducts are required to provide fire resistance. The requirements are intended to limit the spread of fire from the duct when a fire occurs within the duct and assesses the structural integrity of the duct when a fire occurs in the area surrounding the duct.

Fire containment - Elements of building construction - Part 2: Kitchen extract ducts

ISO 6944-2:2009 防火系统.建筑结构的构件.第2部分:厨房排气管道

Fire containment - Elements of building construction - Part 2: Kitchen extract ducts

BS EN 15423:2008 建筑物的通风.建筑物中空气配送系统用防火措施

This document gives guidance for system designers, installers, commissioners and maintenance teams on the incorporation of protective measures for air distribution systems including dual purpose systems for smoke and heat exhaust systems within buildings, to prevent the initiation and the spread of fire, smoke and other byproducts of combustion. This document intends to only support any national (building) regulations, which are the basis of any design of a building or parts of it. It is up to the designer to enquire about the suitability (in particular in legal terms) of a specific solution given in this document (e.g. although “dual purpose systems” are covered in this document, they may not be permitted in some Member States or only in certain types of buildings). This document applies to all air distribution systems including dual purpose systems (except systems only dedicated to smoke exhaust systems, which are dealt in other European standards) including technical rooms or spaces for the installation of devices to assist in ventilation of a building (e.g. distance of storage of combustible materials to devices and not the fire resistance of the building structure), penetrations, and following components/products used in the system like:  inlet/outlet louvres;  fans not exposed / exposed to the smoke;  air control dampers;  ducts;  fire control dampers;  air terminal devices;  anchors and supports;  duct fittings;  control panels;  cables and connections;  air handling units;  air filters;  sound attenuators;  heat exchangers.

Ventilation for buildings - Fire precautions for air distribution systems in buildings

DIN EN 15423:2008 建筑物的通风.建筑物中空气分配系统的防火措施.德文版本EN 15423-2008

This document gives guidance for system designers, installers, commissioners and maintenance teams on the incorporation of protective measures for air distribution systems including dual purpose systems for smoke and heat exhaust systems within buildings, to prevent the initiation and the spread of fire, smoke and other by- products of combustion. This document intends to only support any national (building) regulations, which are the basis of any design of a building or parts of it. It is up to the designer to enquire about the suitability (in particular in legal terms) of a specific solution given in this document (e.g. although "dual purpose systems" are covered in this document, they may not be permitted in some Member States or only in certain types of buildings). This document applies to all air distribution systems including dual purpose systems (except systems only dedicated to smoke exhaust systems, which are dealt in other European standards) including technical rooms or spaces for the installation of devices to assist in ventilation of a building (e.g. distance of storage of combustible materials to devices and not the fire resistance of the building structure), penetrations, and following components/products used in the system like: -- inlet/outlet louvres; -- fans not exposed / exposed to the smoke; -- air control dampers; -- ducts; -- fire control dampers; -- air terminal devices; -- anchors and supports; -- duct fittings; -- control panels; -- cables and connections; -- air handling units; -- air filters; -- sound attenuators; -- heat exchangers.

Ventilation for buildings - Fire precautions for air distribution systems in buildings; German version EN 15423:2008