142 标准查询与下载

DS/IEC 811-1-2:1992 国际电工委员会IEC标准No．811-1-2-1985以及附录No．1-1989 电缆绝缘和铠装材料的通用试验方法

Common test methods for insulating and sheathing materials of electric cables. Part 1: Methods for general application. Section two: Thermal ageing methods

DS/IEC 811-1-1:1992 国际电工委员会IEC标准No．811-1-1-1985以及附录No．1-1988+附录2-1989 电缆绝缘和铠装材料的通用试验方法

Common test methods for insulating and sheathing materials of electric cables. Part 1: Methods for general application. Section One: Measurement of thickness and overall dimensions. Tests for determining the mechanical properties

DS/IEC 881-1-3:1992 国际电工委员会IEC标准No．881-1-1985以及附录No．1-1990 电缆绝缘和铠装材料的通用试验方法

Common test methods for insulating and sheathing materials of electric cables Part 1: Methods for general application. Section three: Methods for determining the density. Water absorption tests. Shrinkage test

DS/IEC 455-3-5:1992 国际电工委员会IEC标准No．455-3-5-1989 电绝缘使用的无溶剂可聚合树脂复合物规范．第3部分：不同材料规范

Specification for solventless polymerisable resinous compounds used for electrical insulation. Part 3: Specifications for individual materials. Sheet 5: Unsaturated polyester impregnating resins

DS/IEC 216-2:1991 电绝缘材料耐热性能的测定导则.第2部分:材料和适用试验一览表

Guide for the determination of thermal endurance properties of electrical insulating materials. Part 2: Choice of test criteria

DS/IEC 216-1:1991 电绝缘材料耐热性能的测定导则.第1部分:老化过程和试验结果评定的一般导则

Guide for the determination of thermal endurance properties of electrical insulating materials. Part 1: General guidelines for ageing procedures and evaluation of test results

DS/IEC 243-2:1991 固体绝缘材料的介电强度测试方法.用直流电压测试的补充技术要求

Methods of test for electric strength of solid insulating materials. Part 2: Additional requirements for tests using direct voltage

DS/IEC 811-4-2:1991 电缆绝缘护套材料的通用试验方法.第4部分:聚乙烯与聚丙烯复合物专用方法.第2节:预处理后的断裂伸长率、预处理后的翘曲试验、在空气中热老化后的翘曲试验、增加量测量、长期稳定性试验(附录A);铜催化氧化解除作用试验方法(附录B)

Common test methods for insulating and sheething materials of electric cables. Part 4: Methods specific to polyethylene and polypropylene compounds. Section two: Elongation at break after pre-conditioning. Wrapping test after pre-conditioning. Wrappi

DS/IEC 811-5-1:1991 电缆绝缘护套材料的通用试验方法.第5部分:填充复合物的专用方法.第1节:滴点、分离油、较低温脆性、总酸值、不腐蚀组分.在23℃时的电容率、在23℃和100℃时的电阻率

Common test methods for insulating and sheathing materials of electric cables. Part 5: Methods specific to filling compounds. Section one: Drop point. Separation of oil. Lower temperature brittleness. Total acid number. Absence of corrosive component

DS/IEC 684-3-100/105:1990 绝缘软套管规范.第3部分:各种型式套管的规范要求.第100至105活页:挤制聚氯乙烯套管

Specification for flexible insulating sleeving. Part 3: Specification requirements for individual types of sleeving. Sheets 100 to 105: Extruded PVC sleeving.

DS/IEC 464-3-2:1990 含溶剂的绝缘漆的规范.第3部分:单项材料规范.第2活页:热固化浸渍清漆的要求

Specification for insulating varnishes containing solvent. Part 3: Specifications for individual materials. Sheet 2: Requirements for hot curing impregnating varnishes

DS/IEC 684-3-121/122:1990 绝缘软套管规范.第3部分:各种型式套管的规范要求.第121和122活页:挤制硅橡胶套管

Specification for flexible insulating sleeving. Part 3: Specification requirements for individual types of sleeving. Sheets 121 and 122 : Extruded silicone sleeving

DS/IEC 829:1990 暴露在电热丝源下的固体绝缘材料可燃性的测定方法

Methods of test for the determination of the ignitability of solid electrical insulating materials when exposed to electrically heated wire sources

DS/IEC 243-1:1990 固体绝缘材料的介电强度试验方法.第1部分:在市电频率下的试验

Methods of test for electric strength of solid insulating materials. Part 1: Tests at power frequencies

DS/IEC 781:1990 在低压径向配电制中短路电流计算的应用指南

Application guide for calculation of short-circuit currents in low-voltage radial systems

DS/IEC 684-3-403/405:1990 绝缘软套管规范.第3部分:各种型式套管的规范要求,第304至305活页:有聚丙烯为基底涂覆物的玻璃丝织套管

Specification for flexible insulating sleeving. Part 3: Specification requirements for individual types of sleeving. Sheets 403 to 405 : Glass textile sleeving with acrylic based coating

DS/IEC 674-2:1990 电工用塑料薄膜规范.第2部分:试验方法

Specification for plastic films for electrical purposes. Part 2: Methods of test

DS/IEC 811-4-1:1990 电缆绝缘和护套材料通用试验方法.第4部分:聚乙烯和聚丙烯专用方法.第1节:耐环境应力破裂性.在空气中热老化后的卷绕试验.熔体流动指数测量.聚乙烯中炭黑和(或)矿物质含量的测定

Common test methods for insulating and sheathing materials of electric cables. Part 4: Methods specific to polythylene and polypropylene compounds. Section One: Resistance to environmental stress cracking: Wrapping test after thermal ageing in air. M

DS/IEC 455-3-11:1990 电气绝缘用无溶剂可聚合树脂化合物规范.第3部分:单项材料规范.第11活页:环氧树脂基粉末涂料

The standard contains the general and special requirements for thermosetting epoxy resin-based coating powders.

Specification for solventless polymerisable resinous compounds used for electrical insulation. Part 3: Specifications for individual materials. Sheet 11: Epoxy resin-based coating powders

DS/IEC 694:1990 高压开关设备和控制设备的通用条款

Common clauses for high-voltage switchgear and controlgear standards