共找到 601 条与 封闭管道中流量的测量 相关的标准,共 41 页
Measurement of fluid flow in closed pipes The flow is measured with a vortex flowmeter installed in a pipe of circular cross-section filled with fluid
Guidelines for the use of electromagnetic flowmeters for measuring fluid flow in closed pipes
本标准给出了测量质量流量和密度的科里奥利流量计的选型、安装、校准、性能和操作指南。本标准亦适当考虑了被测流体的类型,并对流体的体积流量和其他相关参数的测量提供了指南。 注:流体指空气、天然气、水、油、液化石油气、液化天然气、人工煤气、混合气体、各种浆料等。
Measurement of fluid flow in closed conduits—Guidance to the selection, installation and use of Coriolis flowmeters
Volume conversion device for gas meter
本标准规定了气体旋进旋涡流量计(以下简称流量计)的术语和定义、产品分类和基本参数、工作条件、要求、试验方法、检验规则以及标志、包装、运输和贮存。 本标准适用于带有或不带有气体体积修正装置的流量计。
Vortex precession flowmeters for gas
Measurement of fluid flow in closed conduits—Ultrasonic transit-time meters for liquid
Measurement of wet gas flow by means of pressure differential devices inserted in circular cross-section conduits
Measurement of fluid flow by means of pressure-differential devices—Guidelines for the specification of orifice plates,nozzles and Venturi tubes beyond the scope of GB/T 2624
Measurement of fluid flow in closed conduits—Ultrasonic meters for gas—Part 2: Meters for industrial applications
GB/T34041 的本部分规定了运用声学信号的渡越时间来测量封闭管道中单相同质气体流量的气体超声流量计(以下简称流量计)的要求和建议,还规定了适用于贸易交接计量和分输计量两个准确度等级的气体超声流量计的结构,流量测量性能、校准、和输出特性等要求以及安装条件。 本部分适用于贸易交接计量和分输计量用的渡越时间法气体超声流量计,包括等径、缩径高压、低压或这几种类型任意组合而成的气体超声流量计。 本部分对流量计的最大或最小太十没有限制。 本部分可以应用于测量各种类型的气体,包括空气天然气、乙烷等。
Measurement of fluid flow in closed conduits—Ultrasonic meters for gas—Part 1: Meters for custody transfer and allocation measurement
Intelligent flow instruments—General technical requirements
Measurement of fluid flow by means of pressure differential devices—Guidelines on the effect of departure from the specifications and operating conditions given in GB/T 2624 and the correction methods
Guidelines for the use of GB/T 2624—2006
本标准规定「科里奥利质量流量计的要求、试验方法、检验规则及标志、包装、贮运。 本标准适用于基于科里奥肃力原理的科里奥利质量流量计〔以下简称质量流量计)。
Coriolis mass flow meter
本标准规定了安装在充满流体的圆形截面管道中测量流体流量的V形内锥流量测量节流装置(以下简称V锥)的术语、产品分类、基本参数、要求、试验方法、检验规则、标志、包装及储存。本标准适用于测量单相流的V锥。本标准不适用于测量脉动流的V锥。
Measurement of fluid flow in closed conduits.Specifications for V-cone pressure differential flow measuring device
本标准规定了电磁流量计应用HART协议的术语和定义、要求和试验方法。本标准适用于应用HART协议的电磁流量计。
The electromagnetic flowmeter based on HART protocol general technical specification
本标准确定并描述了评定流体流量或总量测量不确定度的基本原则和程序。 附录A 给出了计算不确定度的步骤。 本标准适用于评定流体流量或总量测量的不确定度。
Measurement of fluid flow.Procedures for the evaluation of uncertainties
本标准规定了数控定量水表的术语和定义、一般要求、技术要求、试验方法、检验规则、标志、包装、运输和贮存的要求。 本标准适用于定量控制用水场所,口径为15mm~40mm,工作压力等级为MAP 10,水温度等级为T50 的数控定量水表。
Numerical batch control water meter
本标准规定了便携式水表校验仪的术语和定义、一般要求、计量要求、技术要求、试验方法、试验规则及标志、包装、运输和贮存。 本标准适用于采用标准表法的最大流量小于16m/h的便携式水表校验仪。
Portable calibration instrument for water meters
本标准规定了饮用冷水水表塑料表壳及承压件的术捂和定义、技术要求、试验方法和塑料制品回收标志、包装、运输及贮存要求。 本标准适用于水表口径DN
Plastic body and pressured parts of the meter for cold potable water.Technical specifications
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号