31.120;31.260 标准查询与下载

GB/T 38246-2019 家用激光显示系统光辐射安全特性评价要求

Evaluation requirements of optical radiation safety for household laser display systems

GB/T 38248-2019 家用激光显示系统光辐射安全特性评价方法

Evaluation methods of optical radiation safety for household laser display systems

IEC 62595-2-3:2018 显示照明装置.第2-3部分:LED前照灯单元的光电测量方法

This part of IEC 62595 specifies the standard measurement conditions and measuring methods for determining electrical, optical, and electro-optical properties of LED frontlight units (FLUs) for reflective displays. NOTE: See 3. for a definition of reflective display.

Display lighting unit - Part 2-3: Electro-optical measuring methods for LED frontlight unit

IEC 62341-6-3:2017 有机发光二极管(OLED)显示器.第6-3部分:图像质量测量方法

This part of IEC 62341 specifies the standard measurement conditions and measuring methods for determining the image quality of organic light emitting diode (OLED) display panels and modules.

Organic light emitting diode (OLED) displays - Part 6-3: Measuring methods of image quality

IEC 62715-5-3:2017 软性显示装置. 第5-3部分: 图像质量和缺陷的视觉评估

This part of IEC 62715 provides the framework and procedures for performing the visual assessment of flexible display devices. Visual assessment stipulated in this document is applicable to flexible display modules in the following states: initial states and ageing states under standard ambient conditions; mechanically or environmentally stressed conditions; states after mechanical endurance test(s), after environmental endurance test(s) and after a combination of mechanical and environmental endurance tests. NOTE Visual assessment under the mechanical or environmental stress is usually difficult to do, but this document can be applied when it is possible. Visual assessment is performed by comparing a test sample to a limit sample or to a set of grade samples. This document provides the framework and procedures for visual assessments that use a limit sample or a set of grade samples. This document describes the framework and procedure that are followed while preparing limit samples and a set of grade samples. This document also describes visual assessment when limit samples and grade samples are not available for the same type of defect. This document provides sets of test patterns that can be used in visual assessments.

Flexible display devices - Part 5-3: Visual assessment of image quality and defects

IEC 62715-6-2:2017 软性显示装置. 第6-2部分: 环境试验方法

This part of IEC 62715 specifies testing methods for evaluating the environmental endurance of flexible display panels and modules for use, storage and transport under assumed usage environment. This part of IEC 62715 is applicable to flexible display panels and modules such as liquid crystal display devices (LCDs), electric paper display devices (EPDs), and organic light emitting diode display devices (OLEDs). This part of IEC 62715 will also be suitable for flexible panel or module with mechanical operation.

Flexible display devices - Part 6-2: Environmental testing methods

IEC 62341-6-1:2017 有机发光二极管(OLED)显示器.第6-1部分:光学参数及光电学参数的测量方法

This part of IEC 62341 specifies the standard measurement conditions and measuring methods for determining optical and electro-optical parameters of organic light-emitting diode (OLED) display modules and, where specified, OLED display panels. These methods are limited to flat displays measured in a dark room.

Organic light emitting diode (OLED) displays - Part 6-1: Measuring methods of optical and electro-optical parameters

BS IEC 62679-4-2:2016 电子纸显示器. 环境试验方法

Electronic paper displays. Environmental test methods

IEC 62679-3-3:2016 电子纸显示器. 第3-3部分: 带集成照明装置的显示器光学测量方法

This part of IEC 62679 specifies the standard measurement conditions and measurement methods for determining the optical performance of electronic paper display (EPD) devices which have an operating integrated lighting unit (such as a front light). The scope of this document is restricted to EPDs using segmented or matrix structures with either monochromatic or colour type displays. The measurement methods are intended for EPDs operated in a reflective mode with the integrated lighting unit (ILU) turned on in a dark or indoor ambient lighting environment. Colour systems beyond three primaries are not covered in this document.

Electronic paper displays - Part 3-3: Optical measuring methods for displays with integrated lighting units

IEC 62679-4-2:2016 电子纸显示器. 第4-2部分: 环境试验方法

This part of IEC 62679 specifies the environmental conditions to determine the environmental reliability of electronic paper display (EPD) panels and/or modules for storage under the assumed usage environment. The scope of this document is restricted to EPDs using either segment, passive, or active matrix with either monochromatic or colour type displays. The measuring methods are intended for EPDs operated in a reflective mode.

Electronic paper displays - Part 4-2: Environmental test methods

IEC 62595-2-1:2016 显示照明装置. 第2-1部分: LED背光单元的光电测量方法

This part of IEC 62595 specifies the standard measurement conditions and measuring methods for determining the electrical and optical parameters of LED backlight units for liquid crystal displays.

Display lighting unit - Part 2-1: Electro-optical measuring methods of LED backlight unit

IEC TS 62715-5-2:2016 柔性显示设备 第 5-2 部分：曲面显示器光学特性的测量方法

This part of IEC 62715, which is a technical specification, specifies the general rules and the details of optical measuring methods from a fixed point (the so-called vantage point) for curved emissive and transmissive type displays such as OLED and LCD in dark room conditions. This document focuses on concave shape large screen displays (non-portable) around a horizontal and/or vertical axis with fixed or variable curvature radius. The measuring method stipulated in this technical specification is applied to the curved display modules under the following states: vantage-point luminance variation by viewing angles; vantage-point contrast ratio variation by viewing angles; vantage-point chromaticity variation of white colour by viewing angles; vantage-point colour gamut area variation by viewing angles; vantage-point chromaticity variation of primary colours by viewing angles; luminance uniformity and its uniformity variation by viewing angles; chromaticity uniformity and its uniformity variation by viewing angles; viewing angle of half-luminance; viewing angle of half-contrast

Flexible display devices - Part 5-2: Measuring methods of optical characteristics from the vantage point for curved displays

IEC TR 62977-3-2:2016 电子显示设备. 第3-2部分: 光学特性的评价. 不均匀

This part of IEC 62977, which is a Technical Report, provides an optical measuring method of mura for electronic displays. It defines general measuring procedures for mura measurement and an evaluation method of electronic displays.

Electronic display devices - Part 3-2: Evaluation of optical characteristics - Mura

IEC 62341-2-1:2015 有机发光二极管 (OLED) 显示器. 第2-1部分: OLED显示模块的基本额定值和特性

This part of IEC 62341 describes the essential ratings and characteristics of organic light emitting diode (OLED) display modules.

Organic light emitting diode (OLED) displays - Part 2-1: Essential ratings and characteristics of OLED display modules

GOST R IEC 62341-1-1-2015 有机发光二极管 (OLED) 显示器. 第1-1部分. 通用规格

Organic light emitting diode (OLED) displays. Part 1-1. Generic specification

BS IEC 62679-3-1:2014 电子纸显示器. 光学测量方法

Electronic paper displays. Optical measuring methods

BS IEC 62679-3-2:2013 电子纸显示器. 测量方法. 电光

Electronic paper display. Measuring method. Electro-optical

BS IEC 61988-4-2:2012 等离子体显示板. 环境试验方法. 板强度

Plasma display panels. Environmental testing methods. Panel strength

BS IEC 62679-1-1:2014 电子纸显示器. 术语

Electronic paper displays. Terminology

BS IEC 62629-12-1:2014 三维显示设备. 使用玻璃的立体显示器用测量方法. 光学

3D Display devices. Measuring methods for stereoscopic displays using glasses. Optical