共找到 61 条与 相关的标准,共 5 页
Technical Specification for plumbing and drainage products - Prefabricated bathroom modules
Technical Specification for plumbing and drainage products - Grey water diversion device (GWDD)
Technical Specification for plumbing and drainage products - Urinal flushing cisterns
Technical Specification for plumbing and drainage products - Positive air pressure attenuator
Technical Specification for plumbing and drainage products - Waste pipe connection outlets and gratings, separate or integral
Technical Specification for plumbing and drainage products - Jointing materials
Sets out requirements for a demand-activated hot water pumping system for use in a dedicated plumbing hot water supply recirculation line.
Technical Specification for plumbing and drainage products - Hot water manual or sensor-activated pumping systems
Provides requirements for low pressure automated changeover devices of nominal sizes DN15 and DN20, which enable the interconnection of a pressurized rainwater tank supply and a mains water supply to designated fixtures and outlets.
Technical Specification for plumbing and drainage products - Rainwater tank connection devices
Technical Specification for plumbing and drainage products - Stainless steel tubes and mechanical compression fittings for pressure applications
Technical Specification for plumbing and drainage products - Waterless urinals - Wall hung (Level 1)
Sets out the requirements and test methods for water hammer arrestors.
Technical Specification for plumbing and drainage products - Water hammer arrestors
Plumbing and drainage - Sanitary plumbing and drainage
This Standard sets out the requirements for the design and installation of heated water services. It includes aspects of the installation from, and including, the valve(s) on the cold water inlet to any cold water storage tank or water heater and the dow
Plumbing and drainage - Heated water services
Specifies requirements for the design and construction of sanitary plumbing and drainage installations, from sanitary fixtures and appliances to an improved disposal system.
National Plumbing and Drainage - Sanitary plumbing and drainage - Performance requirements
Specifies the requirements for the design and installation of sanitary plumbing and sanitary drainage from the fixtures to a sewer, common effluent system or on-site disposal system, as appropriate. The Standard applies to new installations as well as al
National Plumbing and Drainage - Sanitary plumbing and drainage - Acceptable solutions
Technical Specification for plumbing and drainage products - Soil waste dump fitting
Technical Specification for plumbing and drainage products - Pressure compensating tank
Technical Specification for plumbing and drainage products - Appliances (miscellaneous)
Ruling clarifying Clause 4.12.3, Installation.
Rulings to plumbing and piping systems Standards - Installation (Ruling to AS 3500.4-1994)
Ruling clarifying Section 6, General design requiremnts for sanitary plumbing systems.
Rulings to plumbing and piping systems Standards - General design requirements for sanitary plumbing systems (Ruling to AS 3500.2-1990)
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号