97.200.30 野营设备和营地 标准查询与下载

GB/T 44010-2024 救灾帐篷 通用技术要求

General technical requirements for disaster relief tents

GB/Z 27735-2022 野营帐篷

本文件规定了野营帐篷(以下简称“帐篷”)的安全、性能和使用舒适度的要求。 本文件适用于野营帐篷。 注:对于大篷车的篷布参见ISO8936。 ISO7152 中给出了与野营帐篷和大篷车篷布有关的术语和定义。

Camping tents

GB/T 27735-2011 野营帐篷

本标准规定了野营帐篷(以下简称帐篷)要求、测试、使用说明及标识。 本标准适用于3.1定义的以野营及户外为目的的各类帐篷。

Camping tents

T/CAB 0292-2023 多功能营地推车安全技术规范

主要包括多功能营地推车的术语和定义、技术要求、试验方法、标识和使用说明等。

Safety technical specification for multifunctional camping wagon

T/CASME 620-2023 折叠车帐篷技术和检验要求

本文件规定了折叠车帐篷的术语和定义、技术要求、试验方法、检验规则、标志、包装、运输和贮存技术内容。

Folding car tent technical and inspection requirements

ISO 23537-2:2023 睡袋要求第 2 部分：织物和材料特性

Requirements for sleeping bags — Part 2: Fabric and material properties

ISO/FDIS 23537-2:2023 睡袋要求第 2 部分：织物和材料特性

Requirements for sleeping bags — Part 2: Fabric and material properties

T/NLPIA 0003-2023 户外折叠手推（拖）车

推车外观要求、外形尺寸和整车质量要求、安全要求、有害物质限量要求、推车整车性能要求、主要零部件品质要求、相应的试验方法、抽样规则标志、包装运输和贮存规定

Leisure goods-Outdoor folding trolley

T/GDTAS 003-2022 装配式建筑旅游营地建设与服务规范

本文件规定了装配式建筑旅游营地的建筑、选址、规划、设施与服务要求。

Construction and service specifications for travel campground with prefabricated buildings

BS EN ISO 23537-1:2022 睡袋要求 针对 -20°C 及更高极限温度设计的睡袋的热学、质量和尺寸要求

1   Scope This document specifies the requirements, test methods and other provisions for the labelling of adult sized sleeping bags for use in sports and leisure time activities at a limit temperature ≥ ‐20 °C regarding thermal characteristics, dimensions and mass. This document describes a method for the assessment of performance in steady‐state conditions of a sleeping bag with regard to the protection against cold. NOTE 1 Sleeping bags without homogeneous fillings designed to provide local extra insulation in certain parts pose issues with the calibration and/or test procedure. Ongoing work continues to provide suitable means of establishing temperature ratings. This document does not apply to sleeping bags intended for specific purpose such as military use and extreme climate zone expedition. It does not apply to sleeping bags for children or babies. NOTE 2 No prediction model exists for the determination of the limiting temperatures based on the thermal resistance of the sleeping bag for children and babies. Moreover, such a model for testing cannot be developed because the necessary controlled sleep trials with children or babies in climatic chambers are, out of ethical reasons, not possible.

Requirements for sleeping bags - Thermal, mass and dimensional requirements for sleeping bags designed for limit temperatures of -20°C and higher

EN ISO 23537-1:2022 睡袋-第1部分:热要求和尺寸要求

This document specifies the requirements, test methods and other provisions for the labelling of adult sized sleeping bags for use in sports and leisure time activities at a limit temperature ≥ ‐20 °C regarding thermal characteristics, dimensions and mass. This document describes a method for the assessment of performance in steady‐state conditions of a sleeping bag with regard to the protection against cold. NOTE 1 Sleeping bags without homogeneous fillings designed to provide local extra insulation in certain parts pose issues with the calibration and/or test procedure. Ongoing work continues to provide suitable means of establishing temperature ratings. This document does not apply to sleeping bags intended for specific purpose such as military use and extreme climate zone expedition. It does not apply to sleeping bags for children or babies. NOTE 2 No prediction model exists for the determination of the limiting temperatures based on the thermal resistance of the sleeping bag for children and babies. Moreover, such a model for testing cannot be developed because the necessary controlled sleep trials with children or babies in climatic chambers are, out of ethical reasons, not possible.

Requirements for sleeping bags - Part 1: Thermal, mass and dimensional requirements for sleeping bags designed for limit temperatures of ‐20°C and higher (ISO 23537-1:2022)

ASTM F1955-22 睡袋易燃性的标准试验方法

1.1 This fire-test response test method contains a method to assess the flammability, expressed as a burn rate, of sleeping bags which use various materials and constructions in their manufacture. 1.2 Sleeping bags that comply with the requirements in this test method shall be permitted to be labeled as complying with the appropriate requirements, to facilitate the identification of products conforming to this test method. 1.3 This test method is technically equivalent to the flammability standard CPAI-75, issued by the Industrial Fabrics Association International (see 2.2), and which has been in use as a flammability requirement for the sleeping bag industry in the U.S. NOTE 1—CPAI-75 expresses burn rate in units of inches/minute while this test method expresses burn rate in units of centimetres/minute. 1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.5 This standard is used to measure and describe the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not by itself incorporate all factors required for fire hazard or fire risk assessment of the materials, products, or assemblies under actual fire conditions. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.7 Fire testing is inherently hazardous. Adequate safeguards for personnel and property shall be employed in conducting these tests. 1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Test Method for Flammability of Sleeping Bags

ISO 23537-1:2022 睡袋要求.第1部分:极限温度为-20°C及以上的睡袋的热、质量和尺寸要求

This document specifies the requirements, test methods and other provisions for the labelling of adult sized sleeping bags for use in sports and leisure time activities at a limit temperature ≥ ‐20 °C regarding thermal characteristics, dimensions and mass. This document describes a method for the assessment of performance in steady‐state conditions of a sleeping bag with regard to the protection against cold. NOTE 1 Sleeping bags without homogeneous fillings designed to provide local extra insulation in certain parts pose issues with the calibration and/or test procedure. Ongoing work continues to provide suitable means of establishing temperature ratings. This document does not apply to sleeping bags intended for specific purpose such as military use and extreme climate zone expedition. It does not apply to sleeping bags for children or babies. NOTE 2 No prediction model exists for the determination of the limiting temperatures based on the thermal resistance of the sleeping bag for children and babies. Moreover, such a model for testing cannot be developed because the necessary controlled sleep trials with children or babies in climatic chambers are, out of ethical reasons, not possible.

Requirements for sleeping bags — Part 1: Thermal, mass and dimensional requirements for sleeping bags designed for limit temperatures of ‐20°C and higher

T/ZGTX 7-2021 《探险营地质量等级划分与评定》

1　范围 2　规范性引用文件 3　术语和定义 4　一般性要求 5　营地质量等级划分及标志 6   营地质量等级划分 7   营地质量等级评定 8   等级复核 9   监督管理

Classification and evaluation of adventure campground

OENORM EN ISO 23537-1:2021 睡袋要求 第1部分：设计用于 -20°C 及更高极限温度的睡袋的热、质量和尺寸要求（ISO/DIS 23537-1:2021）

Requirements for sleeping bags - Part 1: Thermal, mass and dimensional requirements for sleeping bags designed for limit temperatures of -20°C and higher (ISO/DIS 23537-1:2021)

ANSI/ASHRAE 55 ERTA-2021 人类居住热环境条件

Thermal Environmental Conditions for Human Occupancy

GSO ISO 23537-1:2021 睡袋要求 第1部分：热和尺寸要求

ISO 23537-1:2016 specifies the requirements and test methods as well as provisions for labelling of adult sized sleeping bags for use in sports and leisure time activities. ISO 23537-1:2016 does not apply to sleeping bags intended for specific purpose such as military use and extreme climate zone expedition. It does not apply to sleeping bags for children or babies. NOTE 1 No prediction model exists for the determination of the limiting temperatures based on the thermal resistance of the sleeping bag for children and babies. Moreover, such a model for testing cannot be developed because the necessary controlled sleep trials with children or babies in climatic chambers are, out of ethical reasons, not permitted. NOTE 2 The limit temperature for extreme climate conditions is seen to be −20 °C. ISO 23537-1:2016 describes the method for the assessment of the performance in steady-state conditions of a sleeping bag with regard to the protection against cold. NOTE 3 Sleeping bags without homogeneous fillings designed to provide local extra insulation in certain parts pose issues with the calibration and/or test procedure. Ongoing work continues to provide suitable means of establishing temperature ratings.

Requirements for sleeping bags — Part 1: Thermal and dimensional requirements

GSO ISO 23537-2:2021 睡袋要求 第2部分：织物和材料特性

ISO 23537-2:2016 specifies the fabric and material properties as well as provisions for labelling of adult sized sleeping bags for use in sports and leisure time activities. Thermal and dimensional requirements are specified in ISO 23537‑1. ISO 23537-2:2016 does not apply to sleeping bags intended for specific purpose such as military use and extreme climate zone expedition. It does not apply to sleeping bags for children or babies. NOTE No prediction model exists for the determination of the limiting temperatures based on the thermal resistance of the sleeping bag for children and babies. Moreover, such a model for testing cannot be developed because the necessary controlled sleep trials with children or babies in climatic chambers are, out of ethical reasons, not permitted.

Requirements for sleeping bags — Part 2: Fabric and material properties

KS K 7830-2021 野营帐篷

Camping tents

prEN ISO 23537-1:2021 睡袋要求 第1部分：设计用于 -20°C 及更高极限温度的睡袋的热、质量和尺寸要求（ISO/DIS 23537-1:2021）

Requirements for sleeping bags - Part 1: Thermal, mass and dimensional requirements for sleeping bags designed for limit temperatures of -20°C and higher (ISO/DIS 23537-1:2021)