This document specifies the product characteristics and the corresponding test methods for static thermoplastic tanks made of: ?? blow moulded polyethylene@ or ?? rotationally moulded polyethylene@ or ?? rotationally moulded anionically polymerized polyamide 6@ with or without factory assembled reinforcement. The products covered by this European Standard: ?? are intended to be used for internal or external installations@ for above ground storage of fuels limited to kerosene@ heating oil@ diesel@ fatty acid methyl ester (FAME) and bioliquids (containing up to 15 % FAME); ?? have a maximum filling capacity from 400 l up to and including 10 000 l@ except for those made of anionically polymerized polyamide 6 where the maximum filling capacity will be limited to 3 000 l; ?? are subject to atmospheric pressure but not to any external loading (e.g. installation@ wind and snow@ earthquakes@ flooding); ?? are not manufactured using recycled thermoplastic material; ?? are not manufactured using regrind thermoplastic material for rotationally moulded tanks; ?? are not manufactured using more than 50 % of regrind thermoplastic material for blow moulded tanks. This document does not include tanks for the transport and distribution of fuels or gasses@ or tanks for the storage of gas. Flammable fuels with a flash point > 55 ??as determined by EN ISO 2719:2016 are eligible for storage in the tanks described in this standard without further provisions. Flammable fuels with a flash point ??55 ??as determined by EN ISO 2719:2016 are also eligible for storage in the tanks described in this standard if the provisions concerning electrostatic behaviour according to CLC/TR 60079-32-1:2015 are fulfilled