ASTM D8375-23
使用液相色谱-串联质谱法（LC-MS/MS）测定干大麻和大麻原料中大麻酚浓度的标准试验方法

Standard Test Method for Determination of Cannabinoid Concentration in Dried Cannabis and Hemp Raw Materials using Liquid Chromatography Tandem Mass Spectrometry (LC-MS/MS)

非常抱歉，我们暂时无法提供预览，您可以试试： 免费下载 ASTM D8375-23 前三页，或者稍后再访问。

注意： 点击下载后，生成下载文件时间比较长，请耐心等待......

标准号

ASTM D8375-23

发布

2023年

发布单位

美国材料与试验协会

当前最新

ASTM D8375-23

 

 

适用范围

1.1 This test method allows for the concentration determination of the cannabinoids listed in Table 1 , and shall apply to any dried raw material from a cannabis plant ( Note 1 , Note 2 ) regardless of the type of cannabis plant from which it was derived. 2 For the sake of brevity, the term "cannabis" shall be used from now on to refer to any type of cannabis plant including those that can be classified as hemp. The procedure includes sub-sampling a ground, homogeneous sample, extraction with methanol:water (80:20, v:v), 3 , 4 dilution in methanol and analysis by liquid chromatography tandem mass spectrometry (LC-MS/MS). The method allows for a wide-range of sample concentrations to be determined by using a 1000-fold calibration range and the option to perform multiple levels of sample dilution. The calibration curve is prepared in methanol over a range of 10 ng/mL to 10 000 ng/mL for all seventeen cannabinoids, or a subset of cannabinoids if desired, while the sample extracts are diluted in methanol into the calibration range. 3 , 4 , 5 For example, a 1/500 dilution of sample extracts allows concentration determination over a range of 0.5 mg/g to 500 mg/g in cannabis. The method was validated with quality control samples prepared in methanol, a candidate certified reference material (CRM), and repeat extraction and analysis of cannabinoid samples. 3 Note 1: For this test method, dried raw material from a cannabis plant includes one or more of inflorescence, leaves, or stems. Note 2: Certain jurisdictions or regulations may require specific parts of the plant to be included or excluded for analysis and those regulations will take precedence for the selection of plant parts. 1.2 Units - The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 List of Measurable Analytes - See Table 1 . 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D8375-23相似标准

推荐

ASTM D8375-23 中可能用到的仪器设备