BS 7412-2007
未增塑聚氯乙烯(PVC-U)挤制空心型窗和门具规范
Specification for windows and doorsets made from unplasticized polyvinyl chloride (PVC-U) extruded hollow profiles
- 标准号
- BS 7412-2007
- 发布日期
- 2007年04月30日
- 实施日期
- 2007年04月30日
- 废止日期
- 无
- 中国标准分类号
- Q74
- 国际标准分类号
- 91.060.50
- 发布单位
- GB-BSI
- 引用标准
- BS 4255-1 BS 6100-1 BS 6100-1.3.5 BS 6100-1.3.6 BS 6100-1.5.1 BS 6100-1.6 BS 6262 BS 6375 BS 7722 BS 7950-1997 BS 8000-7 PAS 24-1-1999 BS EN 485-2 BS EN 514 BS EN 755-9 BS EN 515 BS EN 572 BS EN 1027 BS EN 1096 BS EN 1279 BS EN 1670-1998 BS EN 1863 BS EN
- 被代替标准
- BS 7412-2002 06/30143171 DC-2006
- 适用范围
- This British Standard specifies requirements for the design, fabrication and performance of windows and glazed doorsets made from PVC-U extruded hollow profiles. This British Standard applies to windows and doorsets manufactured from PVC-U hollow profiles incorporating fusion welded corner joints. It applies to windows and doors fabricated into frames in a factory, to be installed vertically (within 15°) into the external face of buildings, as single or multi-light units, in coupled assemblies when appropriate, of the following types: a) windows: 1) hinged: side-hung (open in or out), top-hung (open out), bottom-hung (open in), tilt and turn or turn before tilt; 2) projecting: side-hung (open in or open out) and top-hung (open out or reversible); 3) pivoted: horizontal and vertical (hung centrally or off-centre) including reversible; 4) sliding: horizontal and vertical; 5) side-hung: fully reversible; 6) fixed light; b) doors: 1) single leaf single-swing doors with or without side lights and top panels; 2) double leaf single-swing doors with or without side lights and top panels. It is applicable to assemblies in which any frame member is not longer than 3 m. It does not apply to curtain walls that span across horizontal structural members of floors but is applicable to windows within a curtain walling system. It is applicable to assemblies up to the point of installation. NOTE Guidance on the evaluation of conformity is given in Annex A. Guidance on durability and recycling is given in Annex B.