SIS SS-ISO 6621-5:1991
内燃机．活塞环．第5部分：质量要求

Internal combustion engines — Piston rings — Part 5: Quality requirements

非常抱歉，我们暂时无法提供预览，您可以试试： 免费下载 SIS SS-ISO 6621-5:1991 前三页，或者稍后再访问。

您也可以尝试购买此标准，
点击右侧 “购买” 按钮开始采购（由第三方提供）。

注意： 点击下载后，生成下载文件时间比较长，请耐心等待......

标准号

SIS SS-ISO 6621-5:1991

发布

1991年

发布单位

SE-SIS

 

 

适用范围

This part of ISO 6621 specifies those quality aspects which are capable of definition but not normally found on a drawing specification. It covers the following : — single-piece piston rings of grey, carbidic, malleable, spheroidal graphite cast iron or steel; — multi-piece piston rings (oil control rings) consisting of cast iron parts and spring components; — single-piece and multi-piece rings of steel, i.e. oil control rings in the form of strip steel components or steel segments (rails) with spring expander components. In addition to specifying certain of the limits of acceptance relating to inspection measuring principles {covered by ISO 6621-2), this part of ISO 6621 also covers those features for which no recognized quantitative measurement procedures exist and which are only checked visually with normal eyesight (spectacles if worn normally) and without magnification. Such features (superficial defects) are additional to the standard tolerances of ring width, radial wall thickness and closed gap. This part of ISO 6621 does not establish acceptable quality levels (AQL), it being left to manufacturer and purchaser to decide the appropriate levels jointly. In this case the recom-mendations of ISO 2859 should be followed. The requirements of this part of ISO 6621 apply to all rings up to and including 200 mm diameter covered by the above classi-fication for both reciprocating internal combustion engines and compressors.

SIS SS-ISO 6621-5:1991相似标准

推荐