IEC 62428:2008
电力工程.三相交流系统用典型部件.量和变换
Electric power engineering - Modal components in three-phase a.c. systems - Quantities and transformations
- 标准号
- IEC 62428:2008
- 发布
- 2008年
- 发布单位
- 国际电工委员会
- 当前最新
- IEC 62428:2008
- 引用标准
- IEC 60050-141
- 被代替标准
- IEC 25/382/FDIS:2008
- 适用范围
- This International Standard deals with transformations from original quantities into modal quantities for the widely used three-phase a.c. systems in the field of electric power engineering. The examination of operating conditions and transient phenomena in three-phase a.c. systems becomes more difficult by the resistive, inductive or capacitive coupling between the phase elements and line conductors. Calculation and description of these phenomena in three-phase a.c. systems are easier if the quantities of the coupled phase elements and line conductors are transformed into modal quantities. The calculation becomes very easy if the transformation leads to decoupled modal systems. The original impedance and admittance matrices are transformed to modal impedance and admittance matrices. In the case of decoupling of the modal quantities, the modal impedance and admittance matrices become diagonal matrices.
IEC 62428:2008相似标准
推荐
电力变压器的工作原理及安装工艺
变压器是变换交流电压、电流和阻抗的器件，当初级线圈中通有交流电流时，铁芯（或磁芯）中便产生交流磁通，使次级线圈中感应出电压（或电流）。变压器由铁芯（或磁芯）和线圈组成，线圈有两个或两个的绕组，其中接电源的绕组叫初级线圈，其余的绕组叫次级线圈。 ...
变压器容量选择计算
1变压器铭牌容量标示 变压器的容量是个功率单位(视在功率)，用VA(伏安)或KVA(千伏安)表示。它是交流电压和交流电流有效值的乘积，计算公式S=UI。变压器额定容量的大小会在其的铭牌上标明。 选择变压器需要清楚使用多大容量的变压器，这个通常根据实际用电系统的负荷大小来考虑。一个供电系统，经过计算后，按计算负荷S选择变压器的容量。...
智能配电网中三相APF-STATCOM谐波及无功电流复合控制
电流PR谐振控制器设计 由于APF-STATCOM跟踪的电流指令是多种频率正弦量的叠加信号，传统SPWM调制采用PI控制必定存在稳态误差和相位偏移，补偿效果不佳，往往采用电流滞环调制，但变频调制不可避免带来滤波器设计及噪声控制问题[9]。 通过旋转坐标变换可以将正弦信号变为直流信号，从而在新的坐标系下采用PI控制器。...