ISO/TS 15530-3-2004
产品几何量的技术规范(GPS).坐标测量仪(CMM):测量不确定度的测定技术.第3部分:校准工件或标准件的使用
Geometrical Product Specifications (GPS) - Coordinate measuring machines (CMM): Technique for determining the uncertainty of measurement - Part 3: Use of calibrated workpieces or standards
ISO/TS 15530-3-2004 发布历史
This part of ISO 15530 specifies the evaluation of measurement uncertainty for results of measurements obtained by a CMM and by using calibrated workpieces. It provides an experimental technique for simplifying the uncertainty evaluation of CMM measurements, whose approach (substitution measurements) leads to measurements being carried out in the same way as actual measurements, but with calibrated workpieces of similar dimension and geometry instead of the unknown workpieces to be measured. Non-substitution measurements on CMMs are also covered, as are the requirements of the uncertainty evaluation procedure, the measurement equipment needed, and the reverification and the interim check of the measurement uncertainty. NOTE The evaluation of measurement uncertainty is always related to a specific measuring task.
ISO/TS 15530-3-2004由国际标准化组织 IX-ISO 发布于 2004-03。
ISO/TS 15530-3-2004 在中国标准分类中归属于: J04 基础标准与通用方法，在国际标准分类中归属于: 17.040.30 测量仪器仪表。
ISO/TS 15530-3-2004的历代版本如下：
- 2004年03月 ISO/TS 15530-3-2004 产品几何量的技术规范(GPS).坐标测量仪(CMM):测量不确定度的测定技术.第3部分:校准工件或标准件的使用
ISO/TS 15530-3-2004 产品几何量的技术规范(GPS).坐标测量仪(CMM):测量不确定度的测定技术.第3部分:校准工件或标准件的使用 于 2011-10 变更为 ISO 15530-3-2011 产品几何形状规范(GPS).坐标测量仪(CMM).测量结果不确定性测定法.第3部分:校准工件的使用或测量标准。
- 标准号
- ISO/TS 15530-3-2004
- 发布日期
- 2004年03月
- 实施日期
- 废止日期
- 无
- 中国标准分类号
- J04
- 国际标准分类号
- 17.040.30
- 发布单位
- IX-ISO
- 代替标准
- ISO 15530-3-2011
- 适用范围
- This part of ISO 15530 specifies the evaluation of measurement uncertainty for results of measurements obtained by a CMM and by using calibrated workpieces. It provides an experimental technique for simplifying the uncertainty evaluation of CMM measurements, whose approach (substitution measurements) leads to measurements being carried out in the same way as actual measurements, but with calibrated workpieces of similar dimension and geometry instead of the unknown workpieces to be measured. Non-substitution measurements on CMMs are also covered, as are the requirements of the uncertainty evaluation procedure, the measurement equipment needed, and the reverification and the interim check of the measurement uncertainty. NOTE The evaluation of measurement uncertainty is always related to a specific measuring task.