ISO 16362-2005
环境空气.高效液相色谱分析法测定粒相多环芳香烃

Ambient air - Determination of particle-phase polycyclic aromatic hydrocarbons by high performance liquid chromatography

标准号

ISO 16362-2005

发布日期

2005年02月

实施日期

废止日期

无

中国标准分类号

Z21

国际标准分类号

13.040.01

发布单位

IX-ISO

被代替标准

ISO/DIS 16362-2002

适用范围

This International Standard specifies sampling, clean-up and analysis procedures for the quantitative determination of low volatility (particle-bound) polycyclic aromatic hydrocarbons (PAHs) in ambient air. For sampling, a low-volume or a medium/high-volume sampling device may be used. Sampling times between 1 h and 24 h are possible. The sampling volume flowrates can range from 1 m/h to 4 m/h ("low volume sampler") or from 10 m/h to about 90 m/h ("medium/high-volume sampler"). In any case, the linear face velocity at the collection filter should range between about 0,5 m/s and 0,9 m/s. The method has been validated for sampling periods up to 24 h. The detection limits for single PAHs and the standard deviations resulting from duplicate measurements are listed in 9.2 and Annex D respectively. This International Standard describes a sampling and analysis procedure for PAH that involves collection from air onto a filter followed by analysis using high performance liquid chromatography usually with fluorescence detector (FLD). The use of a diode array detector (DAD) is possible. The combination of both detector types is also possible (see Annex B). Total suspended particulate matter is sampled. Generally, compounds having a boiling point above 430 ℃ (vapour pressure less than 10 kPa at 25 ℃, e.g. chrysene, benz[a]anthracene) can be collected efficiently on the filter at low ambient temperatures (e.g. below 10 ℃). In contrast, at higher temperatures (above 30 ℃, see also ISO 12884), only PAHs having boiling points above 475 ℃ (vapour pressure less than 10kPa at 25 ℃) are determined quantitatively (see Annex F).

ISO 16362-2005 中可能用到的仪器设备

谁引用了ISO 16362-2005 更多引用