ISO/TR 22849:2011
锥齿轮设计推荐规范
Design recommendations for bevel gears
- 标准号
- ISO/TR 22849:2011
- 发布
- 2011年
- 发布单位
- 国际标准化组织
- 当前最新
- ISO/TR 22849:2011
- 适用范围
- This Technical Report provides information for the application of bevel and hypoid gears using the geometry in ISO 23509, the capacity as determined by ISO 10300 (all parts) and the tolerances in ISO 17485. This Technical Report provides additional information on the application, manufacturing, strength and efficiency of bevel gears for consideration in the design stage of a new bevel gear set. The term “bevel gear” is used to mean straight, spiral, zerol bevel and hypoid gear designs. Where this Technical Report pertains to one or more, but not all, the specific forms are identified. The manufacturing process of forming the desired tooth form is not intended to imply any specific process, but rather to be general in nature and applicable to all methods of manufacture. This Technical Report is intended for use by an experienced gear designer capable of selecting reasonable values for the required data based on his/her knowledge and background. It is not intended for use by the engineering public at large.
ISO/TR 22849:2011相似标准
推荐
主动锥齿轮轴花键断裂分析
1.失效齿轮轴情况该齿轮轴为已经断裂的SUV汽车主动锥齿轮轴，断口保存完好，其表面未见明显锈蚀，以下简称为“锥齿轮”。据4S店反映：该锥齿轮在车行驶五万公里时发生断裂（见图1、图2），其材质为20CrMnTiH，规格为SUV越野车型；锥齿轮的主要生产工序：锻造→正火→机械加工→搓花键→切齿→渗碳淬火→低温回火→喷丸→螺纹退火。...
创新测量方法，有效解决面齿轮齿廓精度计量检测
1.按照锥齿轮的设计原理，计算出面轮齿的大端模数；对面齿轮的设计基准进行转换。将面齿轮副的设计坐标原点放在如图1所示的锥齿轮副的M点上，标示出如图2所示的相关参数数值。2.根据面齿轮的理论设计，计算出如图3所示的点阵坐标（最多为15×15点），生成如图4格式的齿面坐标文件。3.按测量软件要求输入相应的参数数据，导入齿面坐标文件，按软件提示进行检测。4.测得面齿轮齿部轮廓误差、面齿轮齿距累积误差。...