13.030.30 特殊废物 标准查询与下载

GOST R 52037-2003 放射性废料处置用浅层地下(近地面)仓库.一般要求

Shallow ground (near surface) repository for radioactive waste disposal. General requirements

GOST R 51883-2002 放射性水泥废料.一般技术要求

Настоящий стандарт устанавливает общие технические требования к цементированным радиоактивным отходам (цементным компаундам), полученн

Cemented radioactive waste. General technical requirements

ASTM C1310-95(2001) 用流动注射预浓缩电感耦合等离子体质谱法测定土壤中放射性核素的标准试验方法

Standard Test Method for Determining Radionuclides in Soils by Inductively Coupled Plasma-Mass Spectrometry Using Flow Injection Preconcentration

NF M60-317:2001 核能.燃料循环技术.废物.预先化学分离后通过液体闪烁测定废水和废物中的镍63

Énergie nucléaire - Technologie du cycle du combustible - Déchets - Détermination du nickel 63 dans les effluents et déchets par scintillation liquide, après séparation chimique préalable

ASTM D5830-95(2001) 使用气相色谱法测定危险废物溶剂分析的标准试验方法

Standard Test Method for Solvents Analysis in Hazardous Waste Using Gas Chromatography

ASTM D5659-95(2001) 用高效液相色谱法测定废物中氯苯氧酸除草剂的标准试验方法

Standard Test Method for Chlorophenoxy Acid Herbicides in Waste Using HPLC

GOST R 51768-2001 资源保护.废品处理.含汞废物中汞的测定方法.一般要求

Настоящий стандарт устанавливает методы определения массовой доли ртути и распространяется на твердые и шламообразные ртутьсодержащие

Resources saving. Waste treatment. Methods for determination of mercury in mercurycontaining waste. General requirements

ASTM E1368-00 石棉消减项目视觉检查标准实务

1.1 This practice covers the following procedures for performing visual inspections on asbestos abatement projects: 1.1.1 Establishing the need for the extent of the required abatement before the work begins. 1.1.2 Determining the progress of the work and the quality of work procedures during the work, and 1.1.3 Evaluating the completeness of the abatement and the cleanliness of the work area prior to, and subsequent to, final air testing for clearance. 1.2 The procedures discussed herein are intended to be used on a project performed under a contract between a building owner and an abatement contractor. 1.2.1 The responsibilities of the possible participants in such a project such as an architect, construction engineer, consultant, industrial hygienist, and a testing laboratory, should be described in the contract documents. 1.2.2 The concepts and methods are also applicable in varying degrees to repair and maintenance operations (small-scale), including work performed by the building owner's employees. 1.3 This practice provides the following information: 1.3.1 The objectives of the visual inspection process; 1.3.2 The responsibilities and qualifications of the individuals involved in the visual inspection, 1.3.3 The schedule of visual inspection activities during an abatement project and operations and maintenance (Oand;and;M) work; 1.3.4 The inspection procedures for the various types of abatement work and Oand;and;M tasks; and 1.3.5 The criteria for certifying work as complete on the basis of the visual inspections. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 13.

Standard Practice for Visual Inspection of Asbestos Abatement Projects

ONORM S 2606-1999 放射性废物．放射性衰变的废物管理指导

Diese ?NORM ist anzuwenden, wenn radioaktive Abf?lle wie inaktive Abf?lle entsorgt werden sollen und die dafür gelten-den Freigabegrenzwerte nur nach einer entsprechenden Abklingdauer unterschritten werden k?nnen. Gegenstand dieser ?NORM sind nur solche Abf?lle, die offene radioaktive Stoffe mit einer Halbwertszeit bis zu 100 Tagen enthalten und in Beh?ltern gesammelt und gelagert werden. Auch die M?glichkeit von unvermeidbaren Verunreinigungen mit langlebigen Radionukliden wird berücksichtigt (siehe 4.5 bzw. 9.3.2). Sollen flüssige radioaktive Abf?lle aufgrund einer Strahlenschutz-rechtlichen Bewilligung mit dem Betriebsabwasser entfernt werden und ist dabei eine entsprechende Abklingdauer zu be-achten, so ist ebenfalls nach dieser ?NORM vorzugehen. Hingegen ist das Abklingenlassen flüssiger radioaktiver Abf?lle in Abklinganlagen nicht Gegenstand dieser ?NORM (diesbezüglich wird auf ?NORM S 2601 verwiesen). Für Betriebe, in denen radioaktive Abf?lle anfallen, werden in dieser ?NORM die für das Abklingenlassen zu schaffenden Voraussetzungen und erforderlichen Ma?nahmen dargelegt. Für Betriebe (Abteilungen), die radioaktive Abf?lle von anderen Institutionen (bzw. von anderen Abteilungen desselben Be-triebes) zum Zwecke des Abklingenlassens übernehmen, wird darüber hinaus auf die zus?tzlich geltenden organisa-torischen Bestimmungen gem?? 8.2 hingewiesen. Die Anwendung dieser Norm stellt somit die Voraussetzungen für eine ordnungsgem??e ?bergabe des abgeklungenen Ab-falls an einen befugten Entsorgungsbetrieb sicher. Umschlossene radioaktive Stoffe sind nicht Gegenstand dieser ?NORM. Die Entsorgung des abgeklungenen, nicht mehr als radioaktiv zu betrachtenden, sondern wie inaktiv zu behandelnden Ab-falls ist ebenfalls nicht Gegenstand dieser ?NORM. ANMERKUNG: Es wird darauf hingewiesen, da? die Entsorgung radioaktiver Abf?lle an eine strahlenschutzrechtliche Bewilligung ge-bunden ist, sofern der Umgang mit den radioaktiven Stoffen der Bewilligungspflicht oder der Besitz der Meldepflicht nach dem Strahlenschutzgesetz unterliegt.

Radioactive waste - Guidelines for waste management by radioactive decay

ASTM F1737-96(1999) 泄漏响应期间使用溢油分散剂应用设备的标准指南:喷枪和喷嘴系统

Standard Guide for Use of Oil Spill Dispersant Application Equipment During Spill Response: Boom and Nozzle Systems

HJ/T 22-1998 气载放射性物质取样一般规定

本标准规定了核设施中气载放射性物质的取样原则以及对取样方法与设备的一般要求。 本标准适用于实施气载放射性物质监测的各类工作场所、管道和烟囱以及大气环境的空气取样。

General rules for sampling airborne radioactive materials

HJ/T 23-1998 低、中水平放射性废物近地表处置设施的选址

本标准规定了低、中水平放射性废物近地表处置设施的选址目标，选址方法，选址过程的管理，选址准则和选址过程中需要收集的数据或资料。 本标准适用于低、中水平放射性废物近地表处置设施的选址。本标准不适用于铀水冶尾矿处置场的选址，也不适用于对免管废物进行处置的填埋设施的选址。

Siting of near surface disposal facilities of low-and intermediate-level radioactive wastes

ASTM D6160-98(2017) 采用气相色谱法测定废料中多氯联苯(PCB)的标准试验方法

5.1 This test method provides sufficient PCB data for many regulatory requirements. While the most common regulatory level is 508201;ppm (dry weight corrected), lower limits are used in some locations. Since sensitivities will vary for different types of samples, one shall demonstrate a sufficient method detection limit for the matrix of interest. 5.2 This test method differs from Test Method D4059 in that it provides for more sample clean-up options, utilizes a capillary column for better pattern recognition and interference discrimination, and includes both a qualitative screening and a quantitative results option. 1.1 This test method2 covers a two-tiered analytical approach to PCB screening and quantitation of liquid and solid wastes, such as oils, sludges, aqueous solutions, and other waste matrices. 1.2 Tier I is designed to screen samples rapidly for the presence of PCBs. 1.3 Tier II is used to determine the concentration of PCBs, typically in the range of from 28201;mg/kg8201;to 508201;mg/kg. PCB concentrations greater than 50 mg/kg are determined through analysis of sample dilutions. 1.4 This is a pattern recognition approach, which does not take into account individual congeners that might occur, such as in reaction by-products. This test method describes the use of Aroclors3 1016, 1221, 1232, 1242, 1248, 1254, 1260, 1262, and 1268, as reference standards, but others could also be included. Aroclors 1016 and 1242 have similar capillary gas chromatography (GC) patterns. Interferences or weathering are especially problematic with Aroclors 1016, 1232, and 1242 and may make distinction between the three difficult. 1.5 This test method provides sample clean up and instrumental conditions necessary for the determination of Aroclors. Gas chromatography (GC) using capillary column separation technique and electron capture detector (ECD) are described. Other detectors, such as atomic emission detector (AED) and mass spectrometry (MS), may be used if sufficient performance (for example, sensitivity) is demonstrated. Further details about the use of GC and ECD are provided in Practices E355, E697, and E1510. 1.6 Quantitative results are reported on the dry weights of waste samples. 1.7 Quantification limits will vary depending on the type of waste stream being analyzed. 1.8 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.9 This standard does not purport to address all of......

Standard Test Method for Determination of Polychlorinated Biphenyls (PCBs) in Waste Materials by Gas Chromatography

EJ/T 349.3-1997 岩石中微量钍的分析方法

The analysis method of micro thorium in rocks

GOST 22.8.02-1997 异常情况的安全.工农业生产的放射性废物的掩埋.一般要求

Safety in emergencies. Nuclear waste dumping in agriculture. General requirements

GOST R 50926-1996 高放射性固体废物.一般技术要求

Настоящий стандарт устанавливает общие технические требования к качеству отвержденных высокоактивных отходов независимо от способа их

High level solidified waste. General technical requirements

GOST R 50927-1996 放射性沥青废物.一般技术要求

Настоящий стандарт устанавливает общие технические требования к битумным компаундам, полученным путем включения в расплавленную битумн

Waste radioactive bitumenized. General technical requirements

GOST R 50888-1996 特种企业处理放射性废料的生态放射通行证.基本原则

Настоящий стандарт устанавливает основные требования к построению, изложению, оформлению и содержанию радиоэкологического паспорта спе

Radioecological passport of special enterprise on handling with radioactive waste. Basic principles

DIN 30743:1995 废弃物处理工程.专用垃圾箱的存放和运输用装载辅助装置

Waste disposal engineering - Loading aid for the storage and transportation of waste containers for special wastes

GOST R 22.8.02-1994 紧急事件安全性.农业核废物倾倒.一般要求

Настоящий стандарт устанавливает общие требования к захоронению радиоактивных отходов агропромышленного производства (РАО АПП), образую

Safety in emergencies. Nuclear waste dumping in agriculture. General requirements