共找到 364 条与 绝缘系统 相关的标准,共 25 页
Electrical insulation systems — Thermal evaluation of modifications to an established electrical insulation(EIS)— Part 1:Wire-wound winding EIS
Electrical insulating materials and systems - General method of evaluation of electrical endurance under repetitive voltage impulses
Electrical insulating materials and systems - General method of evaluation of electrical endurance under repetitive voltage impulses
IEC 61857-31:2017(E) establishes an EIS evaluation for applications with a designed life of 5 000 h or less. This test method follows the procedures of IEC 60505 and is modified based on the range of designed life.
Electrical insulation systems - Procedures for thermal evaluation - Part 31: Applications with a designed life of 5 000 h or less
Evaluation and qualification of electrical insulation systems; Corrigendum 1
This part of IEC 61857 establishes an EIS evaluation for applications with a designed life of 5000 h or less. This test method follows the procedures of IEC 60505 and is modified based on the range of designed life.
Electrical insulation systems - Procedures for thermal evaluation - Part 31: Applications with a designed life of 5000 h or less
本标准规定了额定电压为10kV~27kV的大型旋转电机定子线棒冷热循环试验的试验程序、温度要求、试验参数、性能检验和数据记录。
Thermal cycle testing method of stator bars for large rotating machines
Insulation coordination for equipment within low-voltage systems - Part 3: Use of coating, potting or moulding for protection against pollution
Insulation coordination for equipment within low-voltage systems - Part 3: Use of coating, potting or moulding for protection against pollution
Guidance on clearances and creepage distances in particular for distances equal to or less than 2 mm. Test results of research on influencing parameters
Multi-factor aging test method and evaluation method for marine variable frequency motor stator winding
Electrical insulation systems (EIS). Thermal evaluation of combined liquid and solid components. Hermetic motor-compressors
Electrical insulation systems (EIS) - Thermal evaluation of combined liquid and solid components - Part 3: Hermetic motor-compressors
Evaluation of electrical endurance of electrical insulation systems-Part 1:General considerations and evaluation procedures based on normal distributions
Evaluation of electrical endurance of electrical insulation systems-Part 2:Evaluation procedures based on extreme-value distributions
Electrical insulation systems-Electrical stresses produced by repetitive impulses-Part 2:State of the art
Evaluation of electrical endurance of electrical insulation systems-Part 2:Evaluation procedures based on extreme-value distributions
Evaluation of electrical endurance of electrical insulation systems-Part 1:General considerations and evaluation procedures based on normal distributions
Electrical insulation systems-Electrical stresses produced by repetitive impulses-Part 2:State of the art
This part of IEC/TS 62332 is applicable to EIS containing solid and liquid components where the thermal stress is the dominant ageing factor, without restriction to voltage class. This part specifies a dual-temperature test procedure for the thermal evaluation and qualification of electrical insulation systems (EIS).
Electrical insulation systems (EIS) - Thermal evaluation of combined liquid and solid components - Part 1: General requirements
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号