共找到 941 条与 电子管 相关的标准,共 63 页
Measurements of the electrical properties of electronic tubes and valves-Part 4:Methods of measuring noise factor
Measurements of the electrical properties of electronic tubes and valves-Part 2:Measurement of heater or filament current
Measurements of the electrical properties of electronic tubes and valves-Part 1:Measurement of electrode current
Measurements of the electrical properties of electronic tubes and valves-Part 0:Precautions relating to methods of measurement of electronic tubes and valves
Measurements of the electrical properties of electronic tubes and valves-Part 3:Measurement of equivalent input and output admittances
本规范规定了阴极射线管的要求、质量保证规定、交货准备等。 本规范适用于阴极射线管。
General specification for cathode ray tubes
MIL-C-14041B remains inactive for new design, however, the document is valid for use.
CARRIER, HOSPITAL PROTECTOR HEADPIECE, M12
Mechanical Safety of Cathode Ray Tubes (Second Edition)
Mechanical safety of cathode ray tubes (IEC 61965:2003)
This International Standard is applicable to cathode ray tubes and cathode ray tube assemblies (hereinafter referred to as CRTs) which are intended for use as components in apparatus and which have integral protection with respect to the effects of implosion. These requirements apply to CRTs intended for use in apparatus including electrical and electronic measuring and testing equipment, information technology equipment, medical equipment, telephone equipment, television equipment and other similar electronic apparatus. This standard is intended to apply only to those CRTs in which the face of the CRT forms part of the enclosure for the apparatus. The test
Mechanical safety of cathode ray tubes
Detail specification for color display tube of type 26SG301Y22-DC70
Detail specification for color display tube of type 16SG302Y22-DC60
Detail specification for oscilloscope of type 20SJ260Y14
Detail specification for photomultiplier tube of type GDB-593
Detail specification for monochrome display tube of the type 2SG707
Detail specification for monochrome display tube of type 5SG31Y43
PREVIOUS CAGE CODE 14933 SUPERSEEDED BY 037Z3. THE ORIGINAL FIRST PAGE OF THIS DRAWING HAS BEEN REPLACED.
CAP, SERVICE, MILITARY POLICE, WHITE
This document defines a constant voltage stress test procedure for characterizing time-dependent dielectric breakdown or “wear-out” of thin gate dielectrics. The test is designed to obtain voltage and temperature acceleration parameters required to estimate oxide life at use conditions. Unlike highly accelerated ramp tests that are designed to be extremely fast and performed at the waferlevel, the constant voltage test procedure may be conducted over long periods of time. It may be applied at the wafer-level or with packaged devices.
Procedure for Characterizing Time- Dependent Dielectric Breakdown of Ultra-Thin Gate Dielectrics
Applicable to cathode ray tubes and cathode ray tube assemblies which are intended for use as components in apparatus and which have integral protection with respect to the effects of implosion. A CRT covered by this standard is intended to be installed
Mechanical safety of cathode ray tubes
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号