71.080.30 有机氮化物 标准查询与下载

23/30445735 DC BS ISO 8112 工业用己内酰胺 测定 50% 己内酰胺水溶液的颜色 以 Hazen 单位（铂钴标度）表示 光谱法

BS ISO 8112. Caprolactam for industrial use. Determination of colour of 50 % aqueous caprolactam solution, expressed in Hazen units (platinum-cobalt scale). Spectrometric method

ASTM E579-04(2023) 溶液中硫酸奎宁荧光检测限的标准试验方法

1.1 This test method employs the signal-to-noise ratio to determine the sensitivity of a fluorescence measuring system in testing for the limit of detection (LOD) of quinine sulfate dihydrate in solution. The results obtained with quinine sulfate dihydrate in solution are suitable for specifying instrument performance on samples having excitation and fluorescence bands wider than 10 nm at or near room temperature. 1.1.1 This test method is not intended to be used as (1) a rigorous test of performance of instrumentation, or (2), to intercompare the quantitative performance of instruments of different design. Intercomparison of the LOD between instruments is commonly expressed as the ratio of the water Raman peak intensity to the root-mean-square (rms) noise as measured on a fluorometer using an excitation wavelength of 350 nm This test method uses the excitation and emission peak wavelengths for quinine sulfate dihydrate in solution, which are approximately 350 nm and 450 nm, respectively. 1.2 This test method has been applied to fluorescencemeasuring systems utilizing non-laser, low-energy excitation sources. There is no assurance that extremely intense illumination will not cause photodecomposition2 of the compound suggested in this test method. For this reason, it is recommended that this test method not be indiscriminately employed with high intensity light sources. This test method is not intended to determine minimum detectable amounts of other materials. If this test method is extended to employ other chemical substances, the user should be aware of the possibility that these other substances may undergo decomposition or adsorption onto containers. 1.3 A typical LOD for conventional fluorometers using this test method is 1 ng of quinine sulfate per mL. 1.4 The suggested shelf life of a 1 mg/mL stock solution of quinine sulfate dihydrate is three months, when stored in the dark in a stoppered glass bottle. 1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.6 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Test Method for Limit of Detection of Fluorescence of Quinine Sulfate in Solution

SH/T 1498.2-2022 尼龙66盐 第2部分：灰分的测定

Nylon 66 Salt——Part 2：Determination of ash

SH/T 1498.6-2022 尼龙66盐 第6部分：硝酸盐含量的测定 高效液相色谱法

Nylon 66 Salt——Part 6：Determination of content of nitrates

SH/T 1498.1-2022 尼龙66盐 第1部分：规格

Nylon 66 Salt- Part 1: Specification

HG/T 6015-2022 工业用2,2'-联吡啶

2,2'-bipyridine for industrial use

HG/T 6016-2022 工业用2,3,5,6-四氯吡啶

2,3,5,6-tetrachloropyridine for industrial use

HG/T 6018-2022 3-氯亚氨基二苄

3-Chloroiminodibenzyl

HG/T 6013-2022 工业用丙烯酰氧乙基三甲基氯化铵

Acryloxyethyltrimethylammonium Chloride for Industrial Use

KS M 1801-2022 工业己内酰胺结晶温度和290 nm吸水率的测定方法

Measuring methods of crystalizing temperature and water absorption in 290 nm for industrial caprolactam

ASTM D4471-22 用直接滴定法测定甲酚酸中吡啶碱的标准试验方法

1.1 This test method covers the determination of pyridine and other basic nitrogen impurities in crude and refined cresylic acids streams, including mixtures. 1.2 This test method is applicable for pyridine base levels of 0.001 % to 0.5 %. 1.3 In determining the conformance of the test results using this method to applicable specifications, results shall be rounded off in accordance with the rounding-off method of Practice E29. 1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 8. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Test Method for Pyridine Bases in Cresylic Acid by Direct Titration

T/CCPIA 205-2022 农药中间体 2-硝基亚氨基咪唑烷

本文件规定了农药中间体2-硝基亚氨基咪唑烷的技术要求、试验方法、检验规则、验收期以及标志、标签、包装、储运。

Pesticides intermediate 2-Nitroiminoimidazolidine

T/SDSCCE 024-2022 副产N-叔丁基丙烯酰胺

本文件规定了副产N-叔丁基丙烯酰胺的要求、试验方法、检验规则、标志和随行文件、包装、运输及贮存。 本文件适用于以丙烯腈、浓硫酸、异丁烯为原料生产2-丙烯酰胺基-2-甲基丙磺酸过程中，经过溶剂提取、固液分离、干燥得到的副产N-叔丁基丙烯酰胺。

By-product N-tert-butylacrylamide

T/SDSCCE 020-2022 回收二甲基甲酰胺

本文件规定了回收二甲基甲酰胺的要求、试验方法、检验规则、标志和随行文件、包装、运输及贮存。 本文件适用于以医药行业合成头孢菌素类、美罗培南类、阿维菌素类、青霉素类医药产生的废液为原料，经过预处理、精馏等工艺得到的回收二甲基甲酰胺，用于化工生产。

Reclaimed dimethylformamide

T/SHXCL 0010-2022 1，3，6-己烷三腈

本文件规定了1，3，6-己烷三腈的性能要求、试验方法、检验规则及标志、包装、运输、贮存。产品用作电解液添加剂和许多工业应用产品的中间体。 主要技术指标有：外观、1，3，6-己烷三腈纯度、色度、微量金属元素含量等。

1,3,6-Hexanetricarbonitrile

T/CPCIF 0162-2021 3,5-二甲基吡啶

项    目　要    求 　优等品　合格品 3,5-二甲基吡啶含量，w/%　≥99.5　≥99.0 水分含量，w/%　≤0.10　≤0.20

3,5·-Dimethylpyridine

T/CPCIF 0161-2021 2,3-二甲基吡啶

项    目　要    求 　优等品　合格品 2,3-二甲基吡啶含量，w/%　≥99.5　≥99.0 水分含量，w/%　≤0.10　≤0.20

2,3-Dimethylpyridine

T/SDSCCE 005-2021 1,2-丙二胺

       本文件规定了1,2-丙二胺的要求、试验方法、检验规则、标志、包装、运输、贮存等。        本文件适用于以异丙醇胺为主要原料制得的1,2-丙二胺，用于有机合成药、活性染料、医药、环氧树脂固化剂等原料制造。同时也是合成氨纶的主要材料，在生产氨纶弹性纤维中，可用作增链剂。

1,2-Diaminopropane

T/SDSCCE 004-2021 二异丙醇胺

本文件规定了二异丙醇胺的相关要求、试验方法、检验规则、标志、包装、运输、贮存等。 本文件适用于以环氧丙烷为主要原料制得的二异丙醇胺，用于天然气、炼厂气中脱除硫化氢和二氧化碳，以及纤维助剂、鞣革剂、杀虫剂、切削油等生产。

Diisopropanolamine

T/ZZB 2138-2021 高速纺尼龙-6用己内酰胺

本文件规定了高速纺尼龙-6用己内酰胺的基本要求、技术要求、试验方法、检验规则、标志、包装、运输和贮存、质量承诺。 本文件适用于以环己酮为原料，通过肟化、转位、精制等工序生产出能作为制造高速纺尼龙-6 的原料的己内酰胺。 分子式：C6H11NO 结构式：CH2—CH2—CH2—CH2—CH2—C=O NH 相对分子质量：113.16（按 2020 年国际相对原子质量）

Caprolactam for high-speed spinning PA6