F04 基础标准与通用方法 标准查询与下载
共找到 460 条与 基础标准与通用方法 相关的标准，共 31 页
(a) This part establishes an energy efficiency performance standard for the new Federal commercial and multifamily high-rise buildings, for which design for construction began on or after January 3, 2007, as required by section 305(a) of the Energy Conservation and Production Act, as amended (42 U.S.C. 6834(a)).
Energy. Part433:Energy efficiency standards for the design and construction of new federal commercial and multi-family high-rise residential buildings. Section433.1:Purpose and scope.
- ICS
- CCS
- F04
- 发布
- 2014-10-14
- 实施
- 2014-10-14
(a) The COSTSAFR Program (Version 3.0) provides a computerized calculation procedure to determine the most effective set of energy conservation measures, selected from among the measures included within the Program that will produce the practicable optimum life cycle cost for a type of residential building in a specific geographic location. The most effective set of energy conservation measures is expressed as a total point score that serves as the energy consumption goal.
Energy. Part435:Energy efficiency standards for the design and construction of new federal low-rise residential buildings. SubpartE:Mandatory Energy Efficiency Standards for Federal Residential Building. Section435.504:The COSTSAFR Program.
- ICS
- CCS
- F04
- 发布
- 2014-10-14
- 实施
- 2014-10-14
(a) If a Federal agency chooses to use a green building certification system to certify a new Federal building or a Federal building undergoing a major renovation and such building is also either a public building (as defined in 40 U.S.C. 3301) for which transmittal of a prospectus to Congress is required under 40 U.S.C. 3307, or a Federal building for which estimated new building or major renovation design and construction costs are at least $2,500,000 (in 2007 dollars, adjusted for inflation), and design for construction began on or after October 14, 2015.
Energy. Part433:Energy efficiency standards for the design and construction of new federal commercial and multi-family high-rise residential buildings. SubpartC:Green Building Certification for Federal Buildings. Section433.300: Green building certificati
- ICS
- CCS
- F04
- 发布
- 2014-10-14
- 实施
- 2014-10-14
(a) If a proposed building design includes unusual or innovative energy conservation measures which are not covered by the COSTSAFR program, the Federal agency shall determine whether that design meets or exceeds the applicable energy consumption goal in compliance with the procedures set forth in this section.
Energy. Part435:Energy efficiency standards for the design and construction of new federal low-rise residential buildings. SubpartE:Mandatory Energy Efficiency Standards for Federal Residential Building. Section435.505:Alternative compliance procedure.
- ICS
- CCS
- F04
- 发布
- 2014-10-14
- 实施
- 2014-10-14
(a) Each Federal Agency shall discount to present values the future cash flows established in either current or constant dollars consistent with the nominal or real discount rate, and related tables, published in the annual supplement to the Life Cycle Costing Manual for the Federal Energy Management Program (NIST 85–3273) and determined annually by DOE as follows—
Energy. Part439:Federal energy management and planning programs. SubpartA:Methodology and Procedures for Life Cycle Cost Analyses. Section439.14:Methodological assumptions.
- ICS
- CCS
- F04
- 发布
- 2014-10-14
- 实施
- 2014-10-14
(a) The head of each Federal agency responsible for the construction of Federal residential buildings shall establish an energy consumption goal for each residential building to be designed or constructed by or for the agency, for which design for construction began before January 3, 2007.
Energy. Part435:Energy efficiency standards for the design and construction of new federal low-rise residential buildings. SubpartE:Mandatory Energy Efficiency Standards for Federal Residential Building. Section435.503:Requirements for the design of a Fed
- ICS
- CCS
- F04
- 发布
- 2014-10-14
- 实施
- 2014-10-14
(a) The energy conservation performance standards in this subpart will apply to all Federal residential buildings for which design of construction began before January 3, 2007 except multifamily buildings more than three stories above grade.
Energy. Part435:Energy efficiency standards for the design and construction of new federal low-rise residential buildings. SubpartE:Mandatory Energy Efficiency Standards for Federal Residential Building. Section435.501:Scope.
- ICS
- CCS
- F04
- 发布
- 2014-10-14
- 实施
- 2014-10-14
(a) ANSI means American National Standards Institute.
Energy. Part435:Energy efficiency standards for the design and construction of new federal low-rise residential buildings. SubpartE:Mandatory Energy Efficiency Standards for Federal Residential Building. Section435.502:Definitions.
- ICS
- CCS
- F04
- 发布
- 2014-10-14
- 实施
- 2014-10-14
(a) (1) All Federal agencies shall design new Federal buildings that are commercial and multi-family high-rise residential buildings, for which design for construction began on or after January 3, 2007, but before August 10, 2012, to:
Energy. Part433:Energy efficiency standards for the design and construction of new federal commercial and multi-family high-rise residential buildings. SubpartA:Energy Efficiency Performance. Section433.100:Energy efficiency performance standard.
- ICS
- CCS
- F04
- 发布
- 2014-10-14
- 实施
- 2014-10-14
(a) This part establishes energy efficiency performance standard for the construction of new Federal low-rise residential buildings as required by section 305(a) of the Energy Conservation and Production Act, as amended (42 U.S.C. 6834(a)).
Energy. Part435:Energy efficiency standards for the design and construction of new federal low-rise residential buildings. SubpartA:Mandatory Energy Efficiency Standards for Federal Low-Rise Residential Buildings. Section435.1:Purpose and scope.
- ICS
- CCS
- F04
- 发布
- 2014-10-14
- 实施
- 2014-10-14
Each Federal agency shall determine life-cycle cost-effectiveness by using the procedures set out in subpart A of 10 CFR part 436. A Federal agency may choose to use any of four methods, including lower life-cycle costs, positive net savings, savings-to-investment ratio that is estimated to be greater than one, and an adjusted internal rate of return that is estimated to be greater than the discount rate as listed in OMB Circular Number A–94 ‘‘Guidelines and Discount Rates for BenefitCost Analysis of Federal Programs.’’
Energy. Part435:Energy efficiency standards for the design and construction of new federal low-rise residential buildings. SubpartA:Mandatory Energy Efficiency Standards for Federal Low-Rise Residential Buildings. Section435.6:Life-cycle costing.
- ICS
- CCS
- F04
- 发布
- 2014-10-14
- 实施
- 2014-10-14
(a) This subpart establishes voluntary energy conservation performance standards for new residential buildings. The voluntary energy conservation performance standards are designed to achieve the maximum practicable improvements in energy efficiency and increases in the use of non-depletable sources of energy.
Energy. Part435:Energy efficiency standards for the design and construction of new federal low-rise residential buildings. SubpartE:Mandatory Energy Efficiency Standards for Federal Residential Building. Section435.500:Purpose.
- ICS
- CCS
- F04
- 发布
- 2014-10-14
- 实施
- 2014-10-14
In selecting between or among proposed building designs which comply with the applicable energy consumption goal under this part, each Federal agency shall select the design which, in comparison to the applicable COSTSAFR prototype, has the highest Net Savings or lowest total life cycle costs calculated in compliance with subpart A of 10 CFR part 436.
Energy. Part435:Energy efficiency standards for the design and construction of new federal low-rise residential buildings. SubpartE:Mandatory Energy Efficiency Standards for Federal Residential Building. Section435.506:Selecting a life cycle effective pro
- ICS
- CCS
- F04
- 发布
- 2014-10-14
- 实施
- 2014-10-14
The capacity of covered products shall be determined as follows:
Commercial Practices. Part305:Energy and water use labeling for consumer products under the energy policy and conservation act ("energy labeling rule"). Section305.7:Determinations of capacity.
- ICS
- CCS
- F04
- 发布
- 2014-07-23
- 实施
- 2014-07-23
Except in a case where the Board finds that the public interest requires otherwise, a meeting may be closed and information pertinent to such meeting otherwise required by §§1704.5, 1704.6, and 1704.7 to be disclosed to the public may be withheld if the Board properly determines that such meeting or portion thereof or the disclosure of such information is likely to:
Energy. Part1704:Rules implementing the government in the sunshine act. Section1704.4:Grounds on which meetings may be closed or information may be withheld.
- ICS
- CCS
- F04
- 发布
- 2014-07-21
- 实施
- 2014-07-21
TABLE 1 TO § 431.107—TEST PROCEDURES FOR COMMERCIAL HEAT PUMP WATER HEATERS
Energy. Part431:Energy efficiency program for certain commercial and industrial equipment. SubpartG:Commercial Water Heaters, Hot Water Supply Boilers and Unfired Hot Water Storage Tanks. Section431.107:Uniform test method for the measurement of energy ef
- ICS
- CCS
- F04
- 发布
- 2014-07-11
- 实施
- 2014-07-11
(a) Certification. Each manufacturer, before distributing in commerce any basic model of a covered product or covered equipment subject to an applicable energy conservation standard set forth in parts 430 or 431, and annually thereafter on or before the dates provided in paragraph (d) of this section, shall submit a certification report to DOE certifying that each basic modelmmeets the applicable energy conservation standard(s). The certification report(s) must be submitted to DOE in accordance with the submission procedures of paragraph (h) of this section.
Energy. Part429:Certification, compliance, and enforcement for consumer products and commercial and industrial equipment. SubpartB:Certification. Section429.12:General requirements applicable to certification reports.
- ICS
- CCS
- F04
- 发布
- 2014-07-03
- 实施
- 2014-07-03
This International Standard specifies the process requirements for carrying out an energy audit in relation to energy performance. It is applicable to all types of establishments and organizations, and all forms of energy and energy use. This International Standard specifies the principles of carrying out energy audits, requirements for the common processes during energy audits, and deliverables for energy audits. This International Standard does not address the requirements for selection and evaluation of the competence of bodies providing energy audit services, and it does not cover the auditing of an organization’s energy management system, as these are described in ISO 50003. This International Standard also provides informative guidance on its use (see Annex A).
Energy audits - Requirements with guidance for use
- ICS
- 27.010
- CCS
- F04
- 发布
- 2014-07
- 实施
This part of IEC 62325 specifies a package for the transmission capacity allocation business process through explicit or implicit auctions and the associated document contextual models@ assembly models and XML schema for use within European style markets. This International standard is based on the European style market contextual model (IEC 62325-351).The scheduling business process covered by this International Standard is described in Clause 5. The relevant aggregate core components (ACCs) defined in IEC 62325-351 have been contextualised into aggregated business information entities (ABIEs) to satisfy the requirements of these business processes. The contextualised ABIEs have been assembled into the relevant document contextual models. Related assembly models and XML schema for the exchange of transmission capacity allocation information between market participants are automatically generated from the assembled document contextual models.
Framework for energy market communications - Part 451-3: Transmission capacity allocation business process (explicit or implicit auction) and contextual models for European market
- ICS
- 33.200;35.240.50;35.240.60
- CCS
- F04
- 发布
- 2014-07
- 实施
- 2017-05-09
(a) Scope. This section provides test procedures for measuring, pursuant to EPCA, the energy consumption of walk-in coolers and walk-in freezers.
Energy. Part431:Energy efficiency program for certain commercial and industrial equipment. SubpartR:Walk-in Coolers and Walk-in Freezers. Section431.304:Uniform test method for the measurement of energy consumption of walkin coolers and walk-in freezers.
- ICS
- CCS
- F04
- 发布
- 2014-06-03
- 实施
- 2014-06-03
