G40 橡胶制品综合 标准查询与下载



共找到 1276 条与 橡胶制品综合 相关的标准,共 86

Rubber,vulcanized or thermoplastic—Determination of permeability to gases—Part 1:Differential-pressure methods

ICS
83.060
CCS
G40
发布
2018-09-17
实施
2019-04-01 00:00:00.0

Rubber,vulcanized—Determination of adhesion to single wire—Pull out test

ICS
83.060
CCS
G40
发布
2018-09-17
实施
2019-04-01 00:00:00.0

Rubber and rubber products—Determination of the composition of vulcanizates and uncured compounds by thermogravimetry—Part 3:Hydrocarbon rubbers,halogenated rubbers and polysiloxane rubbers after extraction

ICS
83.060
CCS
G40
发布
2018-03-15
实施
2018-10-01 00:00:00.0

Rubber—Determination of polyisoprene content

ICS
83.060
CCS
G40
发布
2018-03-15
实施
2018-10-01 00:00:00.0

Rubber, vulcanized or thermoplastic—Resistance to weathering

ICS
83.060
CCS
G40
发布
2018-02-06
实施
2018-09-01 00:00:00.0

Rubber,vulcanized—Test method of salt mist aging

ICS
83.060
CCS
G40
发布
2018-02-06
实施
2018-09-01 00:00:00.0

Rubber, vulcanized or thermoplastic-Resistance to ozone cracking-Test methods for determining the ozone concentration in laboratory test chambers

ICS
83.060
CCS
G40
发布
2018-02-06
实施
2018-09-01 00:00:00.0

Rubber, vulcanized—Determination of thermal diffusivity—Flash method

ICS
83.060
CCS
G40
发布
2018-02-06
实施
2018-09-01 00:00:00.0

本标准规定了测定硫化橡胶恒定形变压缩永久变形特性的试验方法。 本标准适用于评价硫化橡胶在规定的温度和压缩率条件下,经持续压缩后保持其弹性的能力。

Rubber,vulcanized—Determination of compression set at constant strain

ICS
83.060
CCS
G40
发布
2018-02-06
实施
2018-09-01 00:00:00.0

Rubber,raw—Determination of volatile-matter content—Part 2:Thermogravimetric methods using an automatic analyser with an infrared drying unit

ICS
83.060
CCS
G40
发布
2017-12-29
实施
2018-07-01 00:00:00.0

Determination of organotin content of latex products—GC-MS method

ICS
83.140.01
CCS
G40
发布
2017-12-29
实施
2018-07-01 00:00:00.0

Thermoplastic elastomer—Determination of halogen—Oxygen bomb combustion-ion chromatography

ICS
83.060
CCS
G40
发布
2017-11-01
实施
2018-05-01 00:00:00.0

Rubber—Determination of ash—Part 2: Thermogravimetric analysis

ICS
83.060
CCS
G40
发布
2017-11-01
实施
2018-05-01 00:00:00.0

Thermoplastic elastomer—Determination of phthalates—Gas chromatography-mass spectrometry

ICS
83.060
CCS
G40
发布
2017-11-01
实施
2018-05-01 00:00:00.0

Rubber,unvulcanized—Determinations using a shearing-disc viscometer—Part 4: Determination of the Mooney stress-relaxation rate

ICS
83.060
CCS
G40
发布
2017-07-12
实施
2018-02-01 00:00:00.0

Rubber—Dissolution by acid digestion

ICS
83.060
CCS
G40
发布
2017-07-12
实施
2018-02-01 00:00:00.0

本标准规定了四种对表面平整的硫化橡胶或热塑性橡胶硬度的测定方法(标准硬度方法)和四种对弯曲表面试样表观硬度的测定方法(表观硬度方法)。硬度值以橡胶国际硬度(IRHD)表示。这些测定方法所适用的硬度范围从10 IRHD到100 IRHD。 这些方法的主要区别在于球形压头直径和作用力大小,应根据特定的用途选择合适的方法。每种方法的适用范围如图1所示。 本标准没有规定使用便携式硬度计测定硬度的方法,该方法在ISO 7619-2中描述。 本标准规定了下列四种测定标准硬度的方法: 方法N(常规试验):适用于橡胶硬度在35 IRHD~85 IRHD范围内,也可用于硬度在30 IRHD~95 IRHD范围内的橡胶。 方法H(高硬度试验):适用于橡胶硬度在85 IRHD~100 IRHD范围内。 方法L(低硬度试验):适用于橡胶硬度在10 IRHD~35 IRHD范围内。 方法M(微型试验):本质上是按比例缩小的方法N(常规试验),可用于薄、小试样。适用于橡胶硬度在35 IRHD~85 IRHD范围内,也可用于硬度在30 IRHD~95 IRHD范围内的橡胶。 本标准同时给出用于测定弯曲表面表观硬度的CN、CH、CL和CM四种方法。这些方法用于被测橡胶表面弯曲的情况,是对方法N、H、L和M的修改,在这种情况下主要存在两种可能性: a) 试样和制品足够大,使硬度计能够安放在上面;或者 b) 试样和制品足够小,使试样和硬度计能安放在普通支座上。或者能将试样安放在硬度计的试样台上。 对于非标准不平整试样也可使用方法N、H、L和M测量其表观硬度。 上述方法不能保证适用于所有形状和尺寸的试样,但包括了像“O”型圈这样一些最普通的类型。 本标准没有规定胶辊表观硬度的测定方法,相关测试方法见ISO 7267(所有部分)。

Rubber, vulcanized or thermoplastic—Determination of hardness (hardness between 10 IRHD and 100 IRHD)

ICS
83.060
CCS
G40
发布
2017-07-12
实施
2017-11-01 00:00:00.0

Rubber indentification—Infrared spectrometric method

ICS
83.060
CCS
G40
发布
2017-07-12
实施
2018-02-01 00:00:00.0

Determination of isobutylene-isoprene rubber or polyisobutylene content in rubber

ICS
83.060
CCS
G40
发布
2017-07-12
实施
2018-02-01 00:00:00.0

本标准规定了一般用途硅橡胶混炼胶的分类与命名、要求、检验规则以及标志、包装、运输、贮存。 本标准适用于生产按键、密封件、工业杂件等一般用途用的硅橡胶混炼胶。

Silicone rubber compound.General purpose

ICS
83.060
CCS
G40
发布
2016-12-30
实施
2017-07-01



Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号