G54 颜料 标准查询与下载

HG/T 2883-1997 大红粉

Pigment Scarlet

ASTM D6131-97 二氧化钛颜料相对着色度评价的标准试验方法

1.1 This test method is intended to be used to determine the tint undertone (blue or yellow) of titanium dioxide pigments. This relates to the effective particle size of the pigment. It is based upon tinting with a black iron oxide, but other blacks may be used if found suitable. 1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Evaluating the Relative Tint Undertone of Titanium Dioxide Pigments

ASTM D6131-97(2004) 二氧化钛颜料相对着色度评价的标准试验方法

This test method allows the user to make a quick determination of the blueness or yellowness of the tint undertone of titanium dioxide pigments, versus a reference pigment agreed upon by the parties to the test. This is an important measure of tone, since it gives both a measure of effective particle size, and quick approximation of the blue/yellow undertone that can be expected when a coating containing the titanium dioxide is tinted. Such matters as the vehicle for preparing the dispersions, and the black for tinting have been suggested. However, changes in the components may be made by agreement between the buyer and the seller. The results obtained with a mechanical muller do not necessarily correlate directly with a practice where different dispersion conditions exist. However, dispersion with a mechanical muller is a quick and inexpensive way of evaluating the undertone of a titanium dioxide pigment.1.1 This test method is intended to be used to determine the tint undertone (blue or yellow) of titanium dioxide pigments. This relates to the effective particle size of the pigment. It is based upon tinting with a black iron oxide, but other blacks may be used if found suitable.1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Evaluating the Relative Tint Undertone of Titanium Dioxide Pigments

DIN ISO 3711:1996 铬酸铅颜料和铬-钼酸铅颜料.规范和试验方法

The document specifies the requirements and the corresponding methods of test for the following pigments identified by Colour Index numbers: orange 21, yellow 34 and red 104. These pigments are suitable for general use.#,,#

Lead chromate pigments and lead chromate-molybdate pigments - Specifications and methods of test (ISO 3711:1990)

JIS K 5110:1996 铬黄(颜料)

Chrome yellow (pigment)

JIS K 5113:1996 普鲁士蓝(颜料)

Iron blue (pigment)

JIS K 5114:1996 铬酸锌(颜料)

Zinc chromate (pigment)

ARMY MIL-Z-291 G NOTICE 1-1996 工业氧化锌

This commercial item description covers brown kraft paper used for general wrapping applications.

ZINC OXIDE, TECHNICAL

HG/T 2749-1996 酸性艳橙GR（酸性橙Ⅱ）

本标准规定了酸性艳橙GR的要求、采样、试验方法、检验规则以及标志、包装、运输和贮存。 本标准适用于由对氨基苯磺酸重氮化合物与2-萘碱性介质中偶合而得的酸性艳橙GR。

Acid Brilliant Orange GR (Acid Orange Ⅱ)

QB/T 1967.5-1996 黑色类陶瓷颜料化学分析方法

本标准规定了黑色陶瓷颜料中二氧化硅、氧化钙、氧化镁、二氧化锡、氧化铅、三氧化二铝、氧化锌、氧化锰、三氧化二铁、二氧化钛、氧化钴、三氧化二铬、氧化硼、氧化钾、氧化钠(Si02,CaO,MgO,SnO2,PbO,Al2O3,ZnO,MnO,Fe2O2,Ti03,CoO,Cr2O3,B202,K2O,Na2O)及灼烧失量分析方法。 本标准适用于以铁、钻、铬、锰(Fe,Co,Cr,Mn)为着色剂的黑色类陶瓷颜料的化学成分分析。

Chemical analysis method of black ceramic pigment

ANSI/ASTM B29:1996 铅锭规范

This specification covers refined lead in pig, block, or hog form. The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only. This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Specification for Pig Lead

BS EN ISO 787-18:1995 颜料和填充剂的一般试验方法.筛渣的测定.机械冲洗步骤

1 This part of ISO 787 specifies a general method for de-termining the residue on a sieve from a sample of pigment or extender dispersed in water, using a mechanical flushing procedure. This method can also be applied to the examination of other powders or granules which are insoluble in water. It is neither applicable to hydrophobic nor pelletized pigments and extenders. 2 ISO 787/7 specifies a general method of test for de-termining the residue on a sieve from a sample of pigment or extender dispersed in water, using a manual procedure. 3 For most pigments and extenders, these two test methods will give different results, and it is therefore essential to state clearly in a specification which method is to be used, and in the test report, which method has been used. NOTE ?When either of these general methods is applicable to a given pigment or extender, only a cross-reference to it should be inducted in the International Standard relating to that pigment or extender, with a note of any detailed modification which may be needed in view of the special properties of the material under consideration. Only when neither of these general methods is applicable to a particular material a special method for determination of residue on sieve should be specified.

General methods of test for pigments and extenders. Determination of residue on sieve. Mechanical flushing procedure

BS EN ISO 2495:2001 铁蓝色颜料规范

This International Standard specifies the requirements and the corresponding methods of test for iron blue pigments.

Specification for iron blue pigments

BS EN ISO 787-19:1995 颜料和填充剂的一般试验方法.水溶性硝酸盐的测定(水杨酸法)

Spectrophotometric method for determining soluble nitrates in pigments using salicylic acid.

General methods of test for pigments and extenders - Determination of water-soluble nitrates (Salicylic acid method)

BS 283:1995 铁蓝色颜料规范

Applicable to sulphur content of between 0.0003% (m/m) and 0.010% (m/m) depending upon the niobium, silicon, tantalum and titanium content.

Specification for iron blue pigments

NF T31-222*NF EN ISO 787-5:1995 颜料和填料的一般试验方法.第5部分:吸油值的测定

General methods of test for pigments and extenders. Part 5 : determination of oil absorption value.

NF T31-240:1995 颜料通用试验方法.第19部分:水溶性硝酸盐含量测定(水杨酸法)

General methods of test for pigments. Part 19 : determination of water-soluble nitrates (salicylic acid method).

NF T31-227*NF EN ISO 787-16:1995 颜料和填料的一般试验方法.第16部分:相对着色力(或当量着色值)和有色颜料还原色的测定.目测比较法

General methods of test for pigments and extenders. Part 16 : determination of relative tinting strength (or equivalent colouring value) and colour on reduction of coloured pigments. Visual comparison method.

NF T31-229:1995 颜料和填充剂通用试验方法.第15部分:同类着色颜料耐光性比较

General methods of test for pigments and extenders. Part 15 : comparison of resistance to light of coloured pigments of similar types.

QB/T 1967.2-1995 黄色类陶瓷颜料化学分析方法

本标准规定了黄色类陶瓷釉上颜料中硼、硅、铅、铝、锌、锡、锑、钙、镁、铬、镉、钾、钠等元素的化学分析方法。 本标准适用于黄色类陶瓷颜料的化学成分分析。

Chemical analysis method of yellow ceramic pigment