共找到 217 条与 电工用钢 相关的标准,共 15 页
Magnetic materials; part 8: specifications for individual materials; section 6: soft magnetic metallic materials; amendment 1
Specifies general requirements, magnetic properties, geometric characteristics and tolerances, technological characteristics and inspection procedures.
Magnetic materials; part 8: specifications for individual materials; section 8: specification for thin magnetic steel strip for use at medium frequencies
Prezentul standard se refer? la inelele Basehig de gresie ceramic? antiacid? folosite ?n instala?iile chimice pentru m?rirea supiafe?elor de ieac?ie.
Antiacid ceramic sandstone. Raschig rings
Defines the grades of steel sheet and strip with specified mechanical properties and magnetic permeability. Gives the technological, mechanical and magnetic properties, the dimensional tolerances as well as the conditions of acceptance. Applies to materi
Magnetic materials; part 8: specifications for individual materials; section five: specification for steel sheet and strip with specified mechanical properties and magnetic permeability
Nickel iron soft magnetic alloy sheets and strips
Defines the test methods used for the determination of the following geometric characteristics of magnetic steel sheets an strip: flatness, residual curvature, edge camber, deviation from shearing line due to internal stresses and burr height of cut edge
Magnetic materials. Part 9 : Methods of determination of the geometrical characteristics of magnetic steel sheet and strip
Non-oriented magnetic steel sheet and strip
Grain-oriented magnetic steel sheet and strip
Magnetic materials. Part 8 : Specifications for individual materials. Section One - Standard specifications for magnetically hard materials
Magnetic materials. Part 8 : Specifications for individual materials. Section Six - Soft magnetic metallic materials
Magnetic materials. Part 8 : Specifications for individual materials. Section four - Specification for cold-rolled non-oriented magnetic steel
The standard is applicable to siliconiron electrical sheet steel with and without isolation of a silicon content w (Si) 4 % and of an aluminium content w (Al) = 0,17 w (Si) + 0,28 %. The content of all other alloy content may not be greater than 0,4 %.; This standard defines the determination of the density whichis necessary for the determination of the other values of the material, especially the magnetic values. The density is determined by the measurement of the mass, the lenght, the lenght of the resistance distance and the elctrical resistance.
Testing of steel; determination of the density of iron/silicon alloy magnetic sheet
Magnetic materials. Part 8 : Specifications for individual materials. Section Three - Specification for cold-rolled magnetic non-alloyed steel strip delivered in the semi-processed state
Magnetic materials. Part 8 : Specifications for individual materials. Section Two - Specification for cold-rolled magnetic alloyed steel strip delivered in the semi-processed state
Technical conditions for acceptance of hot-rolled silicon steel sheets for electrical purposes
Soft magnetic materials for continuous current relays; technical condition of delivery Matériaux magnétiques doux pour relais à courant continu; condition techniques de livraison
Soft Magnetic Materials for Direct Current Relays; Technical Conditions of Delivery
Test Method for Alternating-Current Magnetic Performance of Laminated Core Specimens Using the Dieterly Bridge Method
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号