H63 稀有高熔点金属及其合金 标准查询与下载
共找到 464 条与 稀有高熔点金属及其合金 相关的标准，共 31 页
本标准规定了铼酸铵的要求、试验方法、检验规则和标志、包装、运输、贮存、质量证明书和合同(或订货单)内容。本标准适用于矿产或废催化剂等湿法冶金所制得的铼酸铵。
Ammonium perrhenate
- ICS
- 77.150.99
- CCS
- H63
- 发布
- 2018-04-30
- 实施
- 2018-09-01
Chromium Molybdenum Alloy (CrMo) target material
- ICS
- 77.150.99
- CCS
- H63
- 发布
- 2018-04-30
- 实施
- 2018-09-01
Zirconium-copper-nickel-aluminum-silver-yttrium amorphous alloy ingot
- ICS
- 77.150.99
- CCS
- H63
- 发布
- 2018-04-30
- 实施
- 2018-09-01
Molybdenum titanium alloy (MoTi) target material
- ICS
- 77.150.99
- CCS
- H63
- 发布
- 2018-04-30
- 实施
- 2018-09-01
Zirconium-copper-nickel-aluminum-silver-yttrium amorphous alloy rod
- ICS
- 77.150.99
- CCS
- H63
- 发布
- 2018-04-30
- 实施
- 2018-09-01
1.1 This specification covers hot- and cold-rolled zirconium and zirconium alloy sheet, strip, and plate. 1.2 One unalloyed and three alloys for use in nuclear applications are described. 1.3 The products covered in this specification include the following forms and sizes: 1.3.1 Sheet, 24 in. [600 mm] or more in width; under 0.187 in. [4.8 mm) in thickness, 1.3.2 Strip, less than 24 in. [600 mm] in width; under 0.187 in. [4.8 mm] in thickness, and 1.3.3 Plate, over 10 in. [250 mm] in width; 0.187 in. [4.8 mm] and over in thickness. Note 1: Material over 0.187 in. [4.8 mm] in thickness and less than 10 in. [250 mm] wide is covered as bar in Specification B351/B351M. 1.4 Unless a single unit is used, for example corrosion mass gain in mg/dm2, the values stated in either inch-pound or SI units are to be regarded separately as standard. The values stated in each system are not exact equivalents; therefore each system must be used independently of the other. SI values cannot be mixed with inch-pound values. 1.5 The following precautionary caveat pertains only to the test method portions of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Specification for Zirconium and Zirconium Alloy Sheet, Strip, and Plate for Nuclear Application
- ICS
- 77.150.99
- CCS
- H63
- 发布
- 2017
- 实施
Molybdenum and molybdenum alloy boats
- ICS
- 77.150.99
- CCS
- H63
- 发布
- 2016-07-11
- 实施
- 2017-01-01
