K36 低压配电用器具 标准查询与下载

SANS 1934:2004 带电作业．接地或接地和短路用便携式设备．按照国际要求进行的国家标准修订

Specifies the national limitations on, and additions to, the international standard SANS 61230 for portable earthing equipment for busbars and overhead lines. Applies to equipment for temporary earthing of electrically isolated transmission and distribut

Live working - Portable equipment for earthing or earthing and short-circuiting - National modifications to international requirements

UL 514A-2004 金属出线盒

The following items are subject to comments: 1. Revisions to the Proposed Tenth Edition based on comments received during the ANSI Canvass. 2. Clarification of the term "air-circulating oven." 3. Revisions to the Alternative Corrosion Protection Systems Test, Annex B. 4. Editorial Revisions.

Metallic outlet boxes

JIS C 8328:2003 家用低压配电盘

この規格は，交流50Hz又は60Hzの単相2線式100V若しくは単相3線式100/200 Vの電路において，主に住宅などの引込口装置として使用すろ住宅用分電盤(以下,住宅盤という。)で，定格電流が150A以下のものについて規定する。

Low voltage panelboards for household use

UL 891 BULLETINS-2003 面板无接线的配电盘

Comment responses and substantive change for the proposed Eleventh Edition of the Standard for Switchboards, UL 891. This is a proposed tri-national harmonized standard.

Dead-Front Switchboards

JB/T 10316-2002 低压成套开关设备和控制设备用母线架

本标准规定了低压成套开关设备的控制设备用母线架产品的技术要求、试验方法、检验规则和标志、包装、运输与贮存条件。 　　本标准适用于低压成套开关设备和控制设备及其他电气设备中安装固定母线用的母线架产品。

Busbars racks for low-vlotage switchgear and controlgear assemblies

JB/T 5877-2002 低压固定封闭式成套开关设备

本标准规定了低压固定封闭式成套开关设备的技术要求、试验方法、检验规则、标志、使用说明书、包装、运输、贮存等。 本标准适用于交流50Hz或60Hz额定工作电压至660V作为电能分配及电动机控制、户内正常使用、具有封闭式结构并带有固定式部件（含插入式和抽出式断路器部件）的设备。

Low-voltage fixed connection enclosed assemblies

JB/T 10328-2002 低压固定面板式成套开关设备

本标准规定了低压固定成套开关设备的技术要求、试验方法、检验规则、标志、使用说明书、包装和贮存、运输等要求。 　　本标准适用于户内正常使用条件下的、额定工作电压为交流不超过660V，频率50Hz或60Hz作为电能分配及电动机控制的带有前护板的开启式成套开关设备，包括经过型式试验的设备(TTA)和经过部分型式试验的设备(PTTA)。 　　本标准不适用于设备中所选用的单独器件和自成一体的部件，诸如电动机走动器、电子设备等。以上设备应符合它们各自的有关标准。

Low-voltage dead-front assemblies

JB/T 10327-2002 耐火母线干线系统.(耐火母线槽)

本标准适用于额定工作电压交流到1000V(1140V)、频率50Hz或60Hz、额定电流到5000A的母线槽。各类母线槽产品的特殊要求应在相应的产品标准中分别加以补充规定。 　　本标准规定了耐火母线干线系统(耐火母线槽)的定义、型号、分类、技术要求、试验方法、检验规则及标志、包装、运输等。

Fire resistant busbar trunking systems (Fire resistant busways)

JB/T 10361-2002 低压成套开关设备和控制设备安全设计导则

本标准适用于GB 7251的各类低压成套开关设备的控制设备。 　　本标准产品的范围、使用条件和设备分类分别为GB 7251.1～3-1997、GB 7251.4～5-1998中1.1、6.1和第3章的规定。 　　本标准在GB 7251.1～3-1997、GB 7251.4～5-1998中6.2特殊使用条件下工作时，应增加相应的附加要求　。 　　本标准是各类成套设备安全设计的基础。其规定在有关各类产品标准中要进一步具体化。成套设备的设计应符合本标准的有关规定，以保证使用操作中的人身和设备安全。

Safety general guide for designing of low-voltage switchgear and controlgear assemblies

NRS 032-2001 230 V单相交流电用户引入连接用杆上型用户配电箱

Covers the requirements for outdoor pole-mounted service distribution boxes (SDBs) for the supply, through overhead cable, of single-phase electricity to domestic customers. The SDBs are intended for use in the range of climatic conditions prevailing thr

Service distribution boxes - Pole-mounted types - For overhead single-phase a.c. service connections at 230 V

UL 1703-2002 平板光电器件组件和配电盘

The following items are subject to comment: 1.) Correction of test references in Table 18.1. 2.) Addition in paragraph 40.1.1 of equation for limit voltage (VL).

UL Standard for Safety Flat-Plate Photovoltaic Modules and Panels Third Edition: Reprinted with revisions through and including April 8, 2008

UL 886 BULLETINS-2002 危险保密场所的出线箱及附件

Covers electrical fittings and boxes for use in hazardous locations, Class I, Division 1, Groups A, B, C, and D; and Class II, Division 1, Groups E, F, and G, in accordance with ANSI/NFPA 70-1984, National Electrical Code. The requirements cover capped elbows, boxes, conduit fittings for draining or venting, conduit fittings for sealing, conduit unions, cord connectors, flexible-connection fittings, mineral insulated cable fittings, and fixture fittings of the adjustable, flexible, and rigid types.

Outlet Boxes and Fittings for Use in Hazardous

DIN 15565-6:2000 电影和电视制作室用配电设备.第6部分:电视转播车用配电箱

This document applies for the distribution ?for television OB-cars which is part of the electric power-distribution equipment according to DIN 15565-1.

Electric power-distribution equipment for production workstations for film and television - Part 6: Distribution ?V for television OB-car

DIN 15565-1:2000 电影和电视制作室用配电设备.第1部分:配电箱、电缆和连接器

This document applies for electric power-distribution systems for ligting and transmission equipment for film, television and sound-production workstations.#,,#

Electric power-distribution equipment for production workstations for film and television - Part 1: Cases, cables and connectors

DIN 15565-3:2000 电影和电视制作室用配电装置.第3部分:中间配电箱TK和开关盒SV

This document applies for intermediate distribution boxes TK and switching boxes SV which are part of the electric power-distribution equipment according to DIN 15565-1.

Electric power-distribution equipment for production workstations for film and television - Part 3: Intermediate distribution box TK and switching box SV

DIN 15565-4:2000 电影和电视制作室用配电装置.第4部分:主配电HV

This document applies for the main distribution HV which is part of the electric power-distribution equipment according to DIN 15565-1.

Electric power-distribution equipment for production workstations for film and television - Part 4: Main distribution HV

DIN 15565-5:2000 电影和电视制作室用配电装置.第5部分:终端配电箱EV和照明配电箱LSV

This document applies for the final distribution box EV and the light distribution boxes LSV which are part of the electric power-distribution equipment according to DIN 15565-1.

Electric power-distribution equipment for production workstations for film and television - Part 5: Final distribution box EV and light distribution boxes LSV

DIN 15565-2:2000 电影和电视制作室用配电装置.第2部分:电流瓦时计ZK

Electric power-distribution equipment for production workstations for film and television - Part 2: Current watthour meter ZK

UL 1-2000 柔性金属导管

Flexible metal conduit

UL 891-1998 不露带电部分的配电盘

Dead-front switchboards