共找到 177 条与 其他电真空器件 相关的标准,共 12 页
本规范规定了非蒸散型室温高牢固度吸气热子元件(以下简称热子元件)的要求、质量保证规定和交货准备等。 本规范适用于特种电真空器件,一般电真空器件可参照使用。
Specification for high security ohmic heation carrier gettering element
本规范规定了阴极射线管的要求、质量保证规定、交货准备等。 本规范适用于阴极射线管。
General specification for cathode ray tubes
Detail specification for photomultiplier tube of type GDB-593
This standard is about Liquid crystal and solid-state display devices - Part 1: Generic specification; Amendment 1
Liquid crystal and solid-state display devices - Part 1: Generic specification; Amendment 1
本标准规定了真空开关管的产品系列型谱。 本标准适用于使用额定频率为50 Hz的接触器、负荷开关、断路器等类型真空开关所用的真空开关管。
The series for vacuum interrupter
本标准规定了真空开关管型号命名方法。 本标准适用于断路器、负荷开关、接触器等使用的真空开关管的型号命名。
Designation method for typesof vacuum interrupter
本规范规定了盖革-弥勒(G-M)计数管的质量评定程序,给出了电性能和核辐射探测性能、环境和寿命等要求及测试方法。 本规范适用于G-M计数管的质量评定,其他类型计数管可参照执行。
General specification for counter tubes
本标准规定了真空开关管用陶瓷管壳的要求、试验方法、检验规则、标志、包装、运輸和贮存等。 本标准适用于交流高低压开关设备用真空开关管用陶瓷管壳。
The ceramic housing used in vacuum interrupter
Blank detailed specifications for counter tubes
1XZ20/30W micro channel plate inverted image intensifier specification
Surge arresters - Part 4: Metal-oxide surge arresters without gaps for a.c. systems; Amendment 2
The requirements in this standard cover indoor and outdoor ballasts, including starting circuits for the operation of high-intensity-discharge lamps, and associated equipment, in accordance with the National Electrical Code, from an alternating-current power supply with nominal ratings of 600 V rms or less. High-intensity-discharge lamps include mercury, metal halide, high-pressure sodium, and similar types. For convenience, although technically not HID lamps, low-pressure sodium lamps are included with the group. The requirements for ballasts consisting of resistance only are excluded from this standard.
High-Intensity-Discharge Lamp Ballasts
本规范规定了军用充气整流管的通用要求、质量保证规定、交货准备等。 本规范适用于在军事装备中作高压整流用的整流管。
General specification for gas-filled rectifier tubes
Liquid crystal and solid-state display devices - Part 3-1 : liquid crystal display (LCD) cells - Blank detail specification.
This part of IEC 60099 provides recommendations for the selection and application of surge arresters to be used in three-phase systems with nominal voltages above 1 kV. It applies to non-linear resistor type gapped surge arresters as defined in IEC 60099-1 and to gapless metal-oxide surge arresters as defined in IEC 60099-4.
Surge arresters - Part 5: Selection and application recommendations
Detail specification for transmit/receive limiter tubes of type RX-280、RX-281 series
This standard is Surge arresters - Part 5: Selection and application recommendations; Amendment 1.
Surge arresters - Part 5: Selection and application recommendations; Amendment 1
This is Amendment 1 to IEC 60099-1-1991 (Surge arresters - Part 1:Non-linear resistor type gapped arresters for a.c. systems)
Surge arresters - Part 1: Non-linear resistor type gapped arresters for a.c. systems; Amendment 1
Liquid crystal and solid-state display devices. Part 4 : liquid crystal display modules and cells. Essential ratings and characteristics.
To be read in conjunction with BS EN 61747-1:2000, BS EN 61747-2:1999
Liquid crystal and solid-state display devices - Passive matrix monochrome LCD modules - Blank detail specification
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号